A wall partition 5.8m long and 3.4m high specify the use of 2”x3” studs space at 60cm on both ways. Find the total board ft required ?

Q: Design staircase of 3.4m length, 1.83m height, 0.225m risers and 14 steps. Include reinforcement of…

A:

Q: What is the required stud spacing for a wall with 9' -0" 2x4 SPF stud grade studs Assume wind load…

A: The required stud spacing can be estimated using 2006 North Carolina Residential Code Table…

Q: By means of neat diagram indicate three methods of providing a lintel over an opening in a block…

A: A lintel refers to the beam that is placed along the openings like windows, doors, etc. in the…

Q: 2. A steel framing plan is shown below with the following parameters: S = 2m, L = 7m. A B 3S -SE.…

A: As per our policies, the first 4 questions will be solved within the time limit. Please post the…

Q: w H1 0.5 L 0.5L Figure 3 Activ. 6.2 Span "L" in metre Height (H1) in metre Live Load on the slab…

A: Strain energy hypothesis proposes that disappointment will happen when the strain energy per unit…

Q: Can you please do the calculations for the partition loads as well. Thanks

A: where,  A=40 ft  B=19 ft  C=9ftThe given building is a school located in Los Angeles, CATo…

Q: What is a suspended ceiling?

A: A suspended ceiling is a secondary type of ceiling in which it hung from the main ceilings. It is…

Q: You personally designed the formwork for a 14’‐0” tall concrete wall as specified below:   3/4”…

A: Let's go through each variation and determine whether the formwork design is adequate or not: 1.…

Q: Compute the minimum net area of the section shown below 2½ in 5 in 2½ in 2 in 3 in 3 in C10 × 30…

A:

Q: EA Calculate number of Rolls of Asphalt Felt to cover the Roof Slope Area. (1 roll of Felt will…

A: Given Data, Length=32' Width=44' Area of the roof- Area of Roof=44×32×12217212Area of…

Q: Describe the Plumb bob technique in setting out and its uses? please describe in details.

A: A plumbob is used to check whether the objects are vertically placed or not. It consists of a weight…

Q: Explain the minimum no of bars to be provided in circular column ?

A: The minimum number of bars in column is 6 for the circular column.

Q: a. What is the minimum edge distance required? b. What is the gage distance? c. Is this gage large…

A:

Q: What span information are available for glued-laminated wood decking?

A:

Q: Draw with scale 1:10 a section in roof slab showing all layers used in roofing if you k

A: Solution- For the roof slab section - Scale = 1: 10 Slab thickness = 15cm Parapet height = 70cm

Q: A teaching building has two floors in total, each floor is 3.3m high, and the height difference…

A: To determine the dimensions of the stair and each part of the stairwell, we will need to consider a…

Q: Q2/A: Draw with suitable scale the details of "T' junction clay brick bearing walls 240 mm and 360…

A: Solution:- The  suitable scale the details of 'T' junction clay brick bearing walls 240 mm and 360…

Q: Howcan I  design  a shear wall ,Could you give steps ?

A: Oi

Q: 1/ For the plan and section of the wall shown below. Calculate quantities for each of the following…

A:

Q: Are the compressions found on the same location in the slinky before and after hitting the wall?

A: No, compression doesn't found in the same location in the slinky before and after hitting the wall,…

Q: Q5/ In the plan below there is a conventional L shape stair, the distance between slabs is 2.9m find…

A: Solution: Given: Provide L shape stairs: Slab span = 2.9 m Installation area = 2m x 3 m Stairs width…

Q: 05/ In the plan below there is a conventional L shape stair, the distance between slabs is 2.9m.…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: 2 Required drawings: Roof framing plan-scale 1:100 mts.

A: Hi! Thank you for the question.  As per the honor code, we’ll answer the first question since the…

Q: The architects decides to put a shear wall in the middle of the building as shown. Given the…

A:

Q: RAFTE AND

A: GIVEN- ROOF SLOPE- 712 Common rafter 16" run of common

Q: MAKE THE ROOF FRAMING PLAN WITH ITS DETAIL RAFTERS AND OR TRUESSES IF IT HAS.    THIS IS THE TOP…

A: Solution: As we are designing the flat roof, the trusses will not be there but due to the large span…

Q: What are the actual depth, average flange thickness? And web thickness of a C12 x 30?

A: Answer  We need to refer AISC steel construction Manual or AISC Shape database to get the actual…

Q: 4. SHOW THE FRAMING ON THE ROOF FOR THE HOUSE TO THE RIGHT. « PREFABRICATED TRUSSES POST AND BEAM…

A: Roof framing is considered the most complicated thing in the house because of the angles involved.…

Q: Assuming all dimensional lumber framing, list all elements that will see shrinkage in the vertical…

A: 1. Assuming all dimensional lumber framing, the following elements will see shrinkage in the…

Q: Shear wall 200 x300 x 30 cm reinforcement 5 f 16 / m vertical and 5 f 12 horizontal both sides make…

A: Given data :- Width of wall = 200cm Height of wall = 300 cm Thickness of wall = 30cm Vertical…

Q: 42. How many square feet of forms are needed to construct the columns shown in Figures 5-26 and 5-…

A: Consider the footing placement as in Figure (1).

Q: draw One-way slab- 12 mm diam. main bars spaced @        300 mm o.c. b/w with 10 mm diam. extra top…

A: Solution: Given: One-way slab: Main bars = 12 mm diameter Temperature bars = 10 mm diameter

Q: Q5/ In the plan below there is a conventional L shape stair, the distance between slabs is 2.9m find…

A: Solution: Given: Area for staircase provision: 2 m x 3 m staris width = 90 cm landing area = 90 cm x…

Q: 3. Defermine how many pieces of wood needed for window frame that requires 30 pieces having a 2 x 6…

A: Windows are fixed into the wall openings in the buildings for entry of daylight and air circulation.…

Q: Complete details at roof overhang with gutters,downspouts,etc. showing the truss connection to the…

A: A truss is a construction that comprises of individuals coordinated into associated triangles so the…

Q: do curtain walls enclose the structure and provide support?

A:

Q: Calculate the Moment of Inertia (1), the Section Modulus (S) and radius of gyration (r) and…

A: Given:width of beam(b)=1.5''depth of beam(d)=5.5''We know that,Moment of inertia of the rectangular…

Q: Building codes provide specifications that regulate each connection specified on framing plan.…

A: In the creation of facility designs, the compilation of cost estimates, and the formation of…

Q: Illustrate the roof framing layout (using wood rafters) for a 5.00m x 6.00m bungalow with gable roof…

A:

Q: 3 spot details of the ff. Connection details

A: Step: 1 Concrete Pier: - It is defined as load bearing member in building construction. Concrete…