A voltage of v(t) = 4.5 cos (14 t- 31°) V is applied across a capacitor C= 2.1 mF as shown. What is the magnitude of the current phasor throughthe capacitor?i(t)Cv(t)Please enter your answer in Amps (A), to 3 significant figures below.

In the given, Voltage across the capacitor given, find the magnitude of the phasor current flow in…

Answered: A voltage of v(t) = 4.5 cos (14 t- 31°)…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1RQ: An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in...

See similar textbooks

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
List the five capacitor replacement rules.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A 250-V circuit, consisting of a resistor, an inductor and a capacitor in series, resonates at 50 Hz. Thecurrent is then 1A and the p.d. across the capacitor is 500 V. Calculate (i) the resistance (ii) theinductance and (iii) the capacitance Answer:
The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M resistor, a 9.00-V emf, and a switch. What are the following exactly 9.00 s after the switch is closed? (a) the charge on the capacitor 13.7204 UC (b) the current in the resistor 0.0110522 x Your response is off by a multiple of ten. HA (c) the rate at which the capacitor is storing energy μW (d) the rate at which the battery is delivering energy μW
A capacitor that is connected parallel to the inductor is added to the circuit image below to correct the power factor to unity. What would be the capacitive reactance of the capacitor assuming the resistance is irrelevant.
A capacitor that is connected parallel to the inductor is added to the circuit image below to correct the power factor to unity. What would be the rating of the capacitor (answer should be in VARs) Thank you !!
A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.
Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 11.80 Volts and is running at a frequency of f = 147000 Hz. The resistor has a resistance of R = 3910 Ω, the capacitor has a capacitance of C = 4.01e-10 Farads, and the inductor has an inductance of L = 5.97e-03 Henries.Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit ?Ztot = Determine the numerical value of Ztot = ΩDetermine the numerical value of ?Ztot = degreesDetermine the current through the circuit: I(PEAK) = Amps I(RMS) = Amps Determine the voltage across the inductor: VL(PEAK) = Volts VL(RMS) = Volts Determine the voltage across the capacitor: VC(PEAK) = Volts VC(RMS) = Volts If a second circuit were connected in parallel with the resistor, this circuit would be considered as: a high-pass filtera flux capacitor a radio tunera phase…
You are an electrician working in an industrial plant. You discover the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-V AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 μF and a voltage rating of 240 V AC. The only 10-μF capacitor in the storeroom is marked with a voltage rating 350 VDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

A voltage of v(t) = 4.5 cos (14 t- 31°) V is applied across a capacitor C= 2.1 mF as shown. What is the magnitude of the current phasor through the capacitor? i(t) C v(t) Please enter your answer in Amps (A), to 3 significant figures below.