Answered: A vertical circular gate is submerged…

A vertical circular gate is submerged in a liquid so that its top edge is flushed with the liquid surface. Find the ratio of the total force acting on the lower half to that acting on the upper half.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 1. The deformation of the fluid will continue as long as the is applied. 2. li

A: The deformation of the fluid will continue as long as - is applied?

Q: A smooth sphere of 2 kN weight and 2 cm radius is resting against the walls as shown in figure.…

A: Given Data,For a smooth sphere,Weight, w= 2kNTo find the reactions at the supporting points

Q: 300kn 15° W 50°

Q: Calculate the reactions at A and D

A: Given:

Q: solve for the internal forces at midspan

A: To find internal forces at mid span of beam

Q: 2) Determine the reaction forces at both walls, if temperature is raised from 30°C to 90°C. The…

Q: II. From the figure shown the coefficient of friction are as follows: 0.23 at the floor, 0.28 at the…

Q: An open circular cylinder of 20 cm diameter and 120 cm long contains watr up to a height of 80 cm.…

Q: 85. A shaft turns at 200 rpm under a torque of 1800 Nm. The power transmitted is

Q: The pressure head is in the capillary fringe zone, in the root zone, and in the saturated zone. O a.…

A: Answer Capillary fringe zoneThe capillary fringe zone is known as the subsurface layer by which the…

Q: 6 m 5 m Water 2 m 2 m DI

Q: The assembly of pipes consists of galvanized steel pipe AB and BC connected together at B using a…

A: Given data: Length of pipe (AB)1=1m Inner Diameter=17 mm Outer diameter=20 mm Length of pipe(BC)…

Q: When a fluid flows through a pipe, the fluid layer at the pipe wall has zero velocity. The maximum…

A: Velocity has parabolic distribution in pipe flowing with fluid. Velocity distribution show how…

Q: Find the support reaction at roller support A

Q: A hoop is shrunk on to a tube exerts a contact pressure of 3000 psi on the tube.an internal pressure…

A: Solution;

Q: A close-coiled helical spring, with the coil diameter as 100 mm and wire diameter as 12 mm consist…

A: Given data, D = 100 mm d = 12 mm P = 400 N

Q: 18 Because of long-term loading from the 900-N tension in the power line, the uniform utility pole…

Q: The beam is loaded as shown. which of the following nearly gives the reaction at the roller support…

A: Draw the FBD of the beam. Then using equations of equilibrium the value of unknown reactions can be…

Q: 2000 N/m 1000 N 70ON/m A 1.2m 0.6 .9m 1.8 m

Q: 6- The rectangular gat has dimensions 6 m by 2 m. Neglect the weight of the gate. Determine (a) The…

Q: The thin steel cylinder just fits over the inner aluminum cylinder as shown in Fig. 4-7. Find the…

A: Given: Rise in temperatureT=33° C Est=200 GPaEal=72 GPaαst=17.3×10-6/°Cαal=22.5×10-6/°C

Q: Use the pressure-prism concep

A: The expression for pressure P at the centroid depth P=γwater×Zcentroid Substitute the value in above…

Q: A hollow steel tube (1) with an outside diameter of D1 and a wall thickness of t1 is connected to a…

A: E1 = 210 GPaE2 = E3 = 55 GPa Determinea. The movement of joint B with respect to support A. b. The…

Q: 2) Determine the reaction forces at both walls, if temperature is raised from 30°C to 90°C. The…

Q: 1. From the given figure shown, the cylinders have equal diameters. a. give the reaction at A b.…

Q: Draw the FBD. Then, determine the reactions at A and B. 650 N 500 N 30° 300 N 1500 N · m 60° B -5 m-…

Q: The truss shown in the figure is supported on a roller at B and a hinge at A. Solve for the reaction…

Q: The 40 ft. long steel rails on the train track are placed such that there is a small gap, 8, between…

A: Axial tension force is the force acting on rails in its axial direction. It's a pulling force that…

Q: A solid shaft of diameter 'd' and length 'I' is subjected to torque 'T'. Another shaft B of some…

A: Given data, Ta = T Da= d Length of A and B = L G of A and B = G Db = 2d

Q: Particle A lies on the x-y plane and is acted on by the three forces shown. Find the resultant of…

A: To find resultant force

Q: Situation A (1 - 4) A cylindrical pressure vessel is constructed from a long, narrow steel plate by…

Q: A cylindrical drum of lengthl and radius r can rotate inside a fixed concentric cylindrical casing,…

A: Given:- Length of cylindrical drum = l radius = r dynamic viscosity = μ angular velocity = ω

Q: IN- m/m ||||||||| * A shaft of length L = 3 m is subjected to uniformly varying torque of 10 N -…

A: Given information, L = 3 m Uniformly varying torque = 10 N-m/m

Q: A and B are sections of a horizontal pipe. If the valve at C is left open and assume the flow in the…

A: Explanation : The sections both lies on the same horizontal pipe, since there is no difference in…

Question

A vertical circular gate is submerged in a liquid so that its top edge is flushed with the liquid surface. Find the ratio of the total force acting on the lower half to that acting on the upper half.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q34 If the surface tension of water is 0.06N/m, then the capillary rise in a tube of a diameter 1mm is:(0 = 0º)
1) The buoyant force acting on the plate is equal to a the mass of the plate times distance of the plate from the free surface b the weight of the plate c the weight of the liquid displaced by the plate 2) The hydrostatic force acting on a circular surface always passes through the center of the circle. True or False 3) Which of the following situation is UNSTABLE? a,b,c?
Find the support reaction at roller support A
Problem 6 Two cables of the same gauge are attached to a transmission tower at B. Because the tower is slender, the horizontal component of the resultant of the forces exerted by the cables at B is to be zero. Knowing that the mass per unit length of the cables is 0.4 kg/m, determine (a) the required sag h, (b) the maximum tension in each cable. -90 m- A h B 60 m → 3 m Figure Problem 6 с
If dc = 4.5, determine (a) The reaction at A, (b) The reaction at E. |-8 ft→-8 ft→|-8 ft→|-8 6 ft dc 300 lb 200 lb 300 lb
A cylindrical tank with its axis horizontal has a length of 6 m and the ends of the tank are vertical planes, as shown in Figure Q2 (a). The vertical pipe of 0.2 m in diameter is connected to the top of the tank. The tank and the pipe are filled with ethyl alcohol to a level of 1.5 m above the top of the tank. The diameter of the tank isa (a) 2.0 m Open surface 1.5 m 0.2 m OF Bottom surface of the 2.XX т cylindrical tank FR 6 m Figure Q2 (a)
D 4 5 P B 3 2a ka a → A In the plane truss system, the loading status of which is evident in the figure, the 36 - support reactions and all rod forces will be found. A is the fixed joint and B is the sliding joint. Single upload P = 35 kN, dimensions a = 1 m and bar numbers are given. Based on this, which of the following is true ? 2)
answer quickly
The two-steel shaft shown in figure have the same diameter and weight 100 lb each. Neglect the friction at all contact surfaces and find the reaction of the wall at A on the lower shaft