A venturi meter with a 12 cm throat is installed in a 18 cm pipe which is inclined upward at an angle of 30° to the horizontal. If the distance between pressure tape along with the pipe is 2 meters, the differential pressure is 90 kPa. What is the discharge of water in m3/s? Assume coefficient is 0.98

Q: a pipe system is as shown er a total head of 100 ft at 40°F. Atmospheric press PSH is 9 ft, will…

A: data  we have  discharge =  495gpm total head = 100 ft  tempertaure = 40°F  Atmospheric pressure…

Q: A reservoir like the one shown has SAE10 oil at 20 C and is connected to a capillary tube for…

A: Neglect major and minor losses

Q: - 1000 kg/m) flows from a large Q6: Water (p tank through a large pipe that splits into two imaller…

A:

Q: A 2-inch copper pipe connection was made from the basement to the second floor in the building. The…

A:

Q: n orifice of 10 cm diameter is fitted in a 25 cm diameter pipe that carries oil of specific gravity…

A:

Q: Find the loss of head whena pipe of diameter 200nm is suddenly enlarged to a diameter of 400mm. The…

A: Continuity equation is based on the conservation of mass. If a pipe having area at one section is…

Q: Two piezometers (manometers) are placed 1.5m apart in a horizontal plastic pipe as shown in figure.…

A:

Q: (1) 3 m (2) B 20 mm bore diameter 60 mm bore diameter

A: Calculated volume flow rate.

Q: Water flows into a house by means of a pipe with an inner diameter of 2,4cm, absolute pressure is…

A:

Q: A 30 cm x 15 cm venturimeter is inserted in a vertical pipe carrying water, flowing in the upward…

A: As per given question A 30 cm x 15 cm venturimeter is inserted in a vertical pipe carrying water,…

Q: Q-3, B.: A Pitot static probe is mounted in a 25 em inner diameter pipe at a location where the…

A: Step 1: To calculate the volume flow rate through the pipe using the Pitot static probe…

Q: A 30 cm x 15 cm venturimeter is inserted in a vertical pipe carrying water, flowing in the upward…

A: Venturimeter is a device based upon Bernoulli's equation, and is used to measure the rate of flow…

Q: 5. The large tank shown in the figure is filled with water to a height of ho. Water exits the 5-cm-…

A: Step 1: Step 2: Step 3: Step 4:

Q: Consider using a venturi tube to messure the flow rate of water (280c^0) through a pipe   5 cm in…

A: Given: Flow through pipe is measured by venturi meter. Diameter of pipe, d1 = 5cm diameter at…

Q: Water flows from a large close tank, through pipe length 15m, diameter (30mm) and exits with…

A:

Q: An orifice meter with a 5 cm diameter is used to measure the flow rate of liquid. Under a head of 4…

A:

Q: A 30 cm x 15 cm venturimeter is inserted in a vertical pipe carrying water, flowing in the upward…

A: Few points regarding venturimeter. A venturimeter is a device which is used for the measurement of…

Q: each pipe may be taken 0.03. 100 mm diameter, 200 m length Atmosphere B 100 mm diameter, 100m length…

A: Calculated discharge in each pipe.

Q: B4. An orifice meter with orifice area 848 mm2 is inserted in a pipe of area 1696 mm2 .The pressure…

A: Given fluid in pipe is oil with specific gravity of 0.75 and not water .Hence there is correction in…

Q: A 3.81-cm diameter venturi meter is installed in a pipe with an internal diameter of 10.23 cm. A 127…

A:

Q: An oil of specific gravity 0.77, is flowing through a venturimeter having inlet diameter 20 cm and…

A: Given Data: The specific gravity of oil, 0.77 Inlet diameter, d1=20 cm Throat diameter, d2=10 cm

Q: A turbine extracts 3 MW from a water flow with a rate of 23 m/s. The head loss across the turbine…

A: Find the pressure difference between 1 and 2. And elevation (h).

Q: Water flows through a venturi as shown in the figure at a flow rate of Q= 12 L/s. The inlet and…

A: Given: The flow rate is 12 L/s. The height of water column are: L1=74.6 cmL3=50 cm

Q: Water is flowing through a pipe of 100 mm diameter under a pressure of 19.62 N/cm2 (gage) and with…

A: Given: d= 100 mmp=19.62 N/cm2v=3 m/sz=8 m

Q: A 3.81-cm diameter venturi meter is installed in a pipe with an internal diameter of 10.23 cm. A 127…

A:

Q: An orificemeter with ortfice diameter 12 cm is inserted in a pipe of 20 cm diameter. The pressure…

A: Given Data, d0=12 cm=0.12 m (orifice)d1=20 cm=0.2 m (pipe)p1-p0=9.81 N/cm2Cd=0.6

Q: A 300 mm x 150 mm venturimeter is inserted in a vertical pipe carrying water flowing in upward…

A:

Q: The calculation of power from moving fluid has the following parameters: Volume flow rate = 10 +/-…

A:

Q: The inlet and throat diameters of a horizontal venturimeter are 30 cm and 15 cm respectively. The…

A:

Q: The total head of fan is 200m and has a static pressure of 201mm of water gage. What is the velocity…

A:

Q: essure the flow ra

A: given:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.