A uniform quantizer, with average quantization power of 67.5 mW, is used in a PCM system. 1) What is the step-size of this quantizer? 2) If the peak value of the quantizer is 12 volts, what is the number of bits of this quantizer? 3) If the quantizer is mid-tread; ● Find the level values of the quantizer. Draw the stair-case characteristics of the quantizer.

A uniform quantizer, with average quantization power of 67.5 mW, is used in a PCM system. 1) What is the step-size of this quantizer? 2) If the peak value of the quantizer is 12 volts, what is the number of bits of this quantizer? 3) If the quantizer is mid-tread; ● Find the level values of the quantizer. Draw the stair-case characteristics of the quantizer.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Signal and system plz explain every step that how do this
Basic signal system question do it fast
Design an encoding matrix with diodes and resistors to display a decimal number to on the seven-segment display. You have 10 switches (WO-W9) with one terminal connected to Vec. For decimal number 0, switch 0 (S0) is closed, for decimal number 1, switch 1 (S1) is closed etc. (Switches are on the vertical axis, S0 on top and the outputs are taken on the horizontal axis (Y0-Y6), with “a" on the left and "g" on the right. Note that (Y0-Y6) outputs are used as inputs to seven-segment display. Since these outputs cannot drive the seven segment display LEDS you may need additional bipolar transistors and resistors. The supply voltage is 5V and each LED needs a current of 20mA. Note that this is a design problem and the design is not unique. Do your best! f a a e
4. An RC filter stage (R = 33 0, C = 120 HF) is used to filter a signal of 24 V dc with 2 V rms operating from a full wave rectifier. Calculate the percentage ripple at the output of the RC Section for a 100-mA load. Also calculate the ripple of the filtered signal applied to the RC stage. *****END*****
3) What are advantages and disadvantages for center tap and bridge? 4) What is difference between half wave and full wave circuits? 5) What is ripple factor? 6) What is happen when increase or decrease capacitor value?
Write an 8051 ASM program to load the timer 1 in order to generate 2000 Hz square wave as given in Figure. The square wave should be generated on pin 2 of port 3. Assume the crystal frequency is 16 MHz. ON 4* Delay Delay
In a rectifier circuit , DC output voltage and RMS output voltage is 0.3 V & 0.6 V respectively. The form factor of this circuit is ___________________.
What is a JFET? Explain its construction and describe the biasing methods available for biasing a JFET? Please don't write on paper
Offset voltage compensating network is connected in between pin number .......... &.. of LM741 op-amp .... O 1 and 4 O 1 and 5 O 2 and 3 O 4 and 7
4. The following Data input and data select waveforms are applied to a Multiplexer. Determine the output waveform. Do D Dy So
A level measurement system consists of three linear elements with sensitivities of 0.050 & 21.5 and 0.99 Find the system error for a true value input of 5.0 meters. This question from Measurements instrumentation course.
ASAP How reverse bias operates in: a. Depletion region B. Majority carrier C. Minority carrier