A typical flash for a point-and-shoot camera uses a capacitor of about 200 µF. 9. If the potential difference between the capacitor plates is 100 V-that is, 100 Vis placed "across the capacitor," how much energy is stored in the capacitor? c. 3 J d. 4 J a. 1 J b. 2 J

A typical flash for a point-and-shoot camera uses a capacitor of about 200 µF. 9. If the potential difference between the capacitor plates is 100 V-that is, 100 Vis placed "across the capacitor," how much energy is stored in the capacitor? c. 3 J d. 4 J a. 1 J b. 2 J

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: A parallel plate capacitor with plate separation of 4.0 cm has a plate area of 0.08 m2. What is the…

Q: A parallel plate capacitor is connected to a battery. The space between the plates is then filled…

A: When capacitor remains connected to the battery, then energy stored in capacitor is given by: U =…

Q: a. What is the equivalent capacitance between a and b? b. What are the potential difference on each…

Q: A capacitor consists of two 6.0-cm-diameter circular plates separated by 1.0 mm. The plates are…

Q: 22. u and mE A parallel-plate air capacitor is made up of two flat plates of area mm² 4 held mm 1.5…

Q: 2. A In the given network, each capacitor has C = 4.00 µF and Vab = +28.0 V. Calculate the: a. Total…

A: a)capacitance C1 and C2 are in series,C'=C1C2C1+C2=2μFC' is connected to parallel with…

Q: 2. Two capacitors, Ci=10mF and C2=50mF, are connected togetherin parallel. The potential difference…

Q: 1. A parallel-plate capacitor has square plates that have a length equal to 1.2 cm separated by 1.2…

A: Square plate length = 1.2 cm = 0.012 mPotential difference (V) = 10 VRequired:The energy stored in…

Q: A 20μμF capacitor charged to 2.0 kV and a 40μμF capacitor charged to 3.0 kV are connected to each…

A: C1 = 20 μF C2 = 40 μF V1 = 2 kV V2 = 3 kV To find = final charge on C2

Q: Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply,…

Q: 7. Pulling the plates of an isolated charged capacitors apart: a. increases the capacitance b.…

Q: In the figure a potential difference V = 95.0 V is applied across a capacitor arrangement with…

Q: A cylindrical capacitor with inner radius a, outer radius b, and length L. Calculate a. Capacitor…

Q: The plates of a parallel plate capacitor have an area of 0.4 m^2 and are 3 mm apart in air. If…

A: Given value--- Area = 0.4 m2. separation = 3 mm. Voltage = 200 V. We have to find--- potential…

Q: A cell has a 7.0-nm-thick membrane with a total membrane area of 6.0 x 10-9 m2.a. We can model the…

A: (a) Charge on the capacitor

Q: A. What is the potential difference across the 6.00 µF capacitor? B. What is the charge stored in…

Q: A parallel plate capacitor with plate separation of 4.0 cm has a plate area of 0.08 m2. What is the…

Q: 10 cm, 9. A parallel plate capacitor has semi-circular plates with radius r = a plate separation of…

A: Solution Given dataRadius r=10cm=0.10mPlate separation d=3.00mm=3×10−3mDielectric constant…

Q: Dielectrics. A parallel-plate capacitor with a dielectric with dielectric constant & between the…

A: Capacitance of a parallel plate capacitor is given by, C=kAd If the distance between the plate is…

Q: a a a 3. A parallel plate capacitor has a plate seperation 3a and plate area A. Two slabs of…

Q: What is the charge on each capacitor Q1, Q2, Q3 in μC b. What is the potential difference across…

Q: Kappa-City. A 25 V potential is supplied across termi- nals a and b to fully charge the capacitor…

A: Let C1 = 7.5 nF C2 = 18 nF C3 = 30 nF C4 = 10 nF C5 = 6.5 nF The potential difference across a and b…

Q: Two flat plates with an area of 4 mm? and is held 1.5 mm apart makes a parallel-plate air capacitor.…

A: The energy density (energy per unit volume ) u= Uvolume consider a parllel plate capacitor U=…

Q: A simple capacitor consists of two rectangular plates, each with an area of 5.3 cm2, and are…

A: The arae of each plate is, A=5.3 cm2=5.3×10-4 m2. The separated distance is, d=3 mm=0.003 m. The…

Q: A capacitor of capacitance C=41 µF capacitor is used in conjunction with a motor. How much energy…

A: Capacitance (C)= 41 micro farad Applied voltage (V) = 111 volts

Q: An electronic flash unit for a camera contains a capacitor with a capacitance of 820 μF . When the…

A: Given data :- Capacitance of capacitor C = 820 μF Potential difference between the capacitor…

Q: A parallel plate capacitor is connected to a battery. The space between the plates is then filled…

A: We have to use some basic formula of capacitor.

Q: A parallel plate capacitor is connected to a battery. The space between the plates is then filled…

Q: A parallel-plate capacitor is made of two circular plates, each with a diameter of 2.50x10^-3 m. The…

A: Given that, The diameter of the circular plates, D = 2.50 x 10-3 m The separation between the…

Q: 2. A capacitor consists of two 6.5- cm-diameter circular plates separated by 1.0 mm. The plates are…

Q: the given network is connected to Vab = 30V with the dialectric of each capacitor as air, calculate…

Q: In the figure below(Figure 1), each capacitor has C=3.80 μF and Vab=24.0V. (a) Calculate the charge…

Q: A parallel-plate capacitor carries an electric charge of ± 7.5 pC on its conducting plates. The…

A: Charge on the parallel plate, Q=±7.5 pC Area of the plates, A=5 cm2 Distance of separation between…

Q: A parallel plate capacitor with plate separation of 4.0 cm has a plate area of 0.08 m2. What is the…

A: Given: Distance between plates d=4.0cm=4×10-2 m Plate area A=0.08 m2 Standard data used:…

Q: 3. A 290 µF capacitor is charged by a 15 V battery. While remaining on the battery, a layer of…

A: Given that-Original Capacitance- Coriginal= 290μFBattery voltage, Vbattery=15 VoltsWe know…

Q: Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply,…

Q: An electronic flash unit for a camera contains a capacitor with a capacitance of 780 μF. When the…

A: Given data: Capacitance (C) = 780 μF Potential difference (V) = 310 V Required: Charge (Q) and…

Q: C C + K Two identical capacitors are connected as seen in the figure. The potential across each…

A: Given Potential Across each capacitor=V0 Q=CV0

Q: 4. An 8400 pF air-gap capacitor is charged by a power supply set to 9.1 V. It is removed from the…

Concept explainers

Dielectric Constant Of Water

Water constitutes about 70% of earth. Some important distinguishing properties of water are high molar concentration, small dissociation constant and high dielectric constant.

Electrostatic Potential and Capacitance

An electrostatic force is a force caused by stationary electric charges /fields. The electrostatic force is caused by the transfer of electrons in conducting materials. Coulomb’s law determines the amount of force between two stationary, charged particles. The electric force is the force which acts between two stationary charges. It is also called Coulomb force.

Question

A typical flash for a point-and-shoot camera uses a capacitor of
about 200 µF.
9. If the potential difference between the capacitor plates is 100 V-that is, 100 Vis
placed "across the capacitor," how much energy is stored in the capacitor?
c. 3 J
d. 4 J
a. 1 J
b. 2 J

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A parallel-plate capacitor stores charge Q. The capacitor is then disconnected from its voltage source, and the space between the plates is filled with a dielectric of constant κ = 2. What is the relationship between the stored energies of the capacitor, where PEi is the initial stored energy, and PEf is the stored energy after the dielectric is inserted? a. PEf = 0.25PEi b. PEf = 0.5PEi c. PEf = PEid. PEf = 2PEi
A parallel plate capacitor with plate separation of 4.0 cm has a plate area of 0.01 m2. What is the capacitance of this capacitor with air between these plates? Select one:a. 2.2x10 -14b. 2.2x10 -10c. 2.2x10 -13d. 2.2x10 -12e. 2.2x10 -15
In (Figure 1), let C1 = 3.10 μF, C2 = 4.50 μF, and Vab = +63.0 V. Part A: Calculate the charge on capacitor C1. Q1=__ Part B: Calculate the charge on capacitor C2. Q2=__ Part C: Calculate the potential difference across capacitor C1. V1=__ Part D: Calculate the potential difference across capacitor C2. V2=__
A parallel-plate capacitor has square plates of side length s and distance d between them. It stores energy U when it is connected across a fixed potential difference V. In order to decrease by a factor of 4 the amount of energy stored in this capacity will still connected to the potential difference V, the lengths that should be changed to...? A. 4s B. S/2 C. 8s D. 2s E. S/4
B8
A vacuum spherical capacitor has inner and outer radius of 7 cm and 9 cm, respectively. What is the capacitance? a. 3 50 pF b. 14.6 pF c. 22.3 nF d. 17.2 pF
The electric potential increases from 100 V to 800 V from the bottom plate to the top plate of a parallel-plate capacitor. a. What is the magnitude of the change in potential energy of a −3 × 10^−4 C charge that is moved from the bottom plate to the top plate? b. Does the potential energy increase or decrease in this process?
Pls, i need help with these!!
In the figure, a proton is fired with a speed of 200,000 m/s from the midpoint of the capacitor toward the positive plate. a. Show that this is insufficient speed to reach the positive plate. b. What is the proton’s speed as it collides with the negative plate?
5. A capacitor is charged by a battery. It may or may not have been removed from this battery. A dielectric is then either inserted or removed from between the plates. The capacitance increased by a factor of 5 and the charge across the plates increased by a factor of 5. a. Was the capacitor on or off the battery? Explain. b. Was the dielectric inserted or removed from between the plates? Explain.
q1
A parallel plate capacitor is made of two metal plates, each with an area of 0.2 m?. The capacitance is 4.8 x 10-9 Farad. How far are the two plates separated from each other in millimeters? O a. 0.34 mm O b. 0.37 mm O c. 3.36 mm O d. 3.69 mm