A TV channel has a bandwidth of 6 MHz. If we send a digital signal using onechannel, what is the max data rates in the following scenarios:Mbps1) if we use five harmonics and two levels per sample? Answer:Mbps2) if if we use five harmonics and 8 levels per sample? Answer:NBlank # 1Blank # 2

Answer: Given Bandwidth(B) =6MHz

A TV channel has a bandwidth of 6 MHz. If we send a digital signal using one channel, what is the max data rates in the following scenarios: 1) if we use five harmonics and two levels per sample? Answer: _____ Mbps Mbps 2) if if we use five harmonics and 8 levels per sample? Answer: Blank # 1 A Blank # 2 신

A TV channel has a bandwidth of 6 MHz. If we send a digital signal using one channel, what is the max data rates in the following scenarios: 1) if we use five harmonics and two levels per sample? Answer: _____ Mbps Mbps 2) if if we use five harmonics and 8 levels per sample? Answer: Blank # 1 A Blank # 2 신

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Example: A telephone line has a bandwidth of 3000. The signal-to-noise ratio is usually 3162. For this channel the capacity is calculated as
Consider a channel with a 1 MHz capacity and an SNR of 63.a. What is the upper limit to the data rate that the channel can carry?b. The result of part (a) is the upper limit. However, as a practical matter, bettererror performance will be achieved at a lower data rate. Assume we choose a datarate of 2/3 as the maximum theoretical limit. How many signal levels are neededto achieve this data rate?
A digitized voice channel is made by digitizing a 4-kHz bandwidthanalog voice signal. We need to sample the signal at twice the highestfrequency. We assume that each sample requires 16 bits. What is therequired bit rate?
For data is transmitted over twisted-pair cable, you have these characteristics: A signal's power on the channel is 60 dB, signal attenuation is 2 dB per 100 meters, and average noise power on the cable is 0.15 dB per meter. Answer the following questions: What's the S/N ratio at the end of a 60-meter channel? What's the S/N ratio at the end of a 1.5-kilometer channel? What's the maximum channel length if the receiving device requires at least 25 dB of S/N ratio for reliable operation?
Suppose analog signal has the bandwidth of 15 kHz (uniform). Find the minimum first null bandwidth (square wave pulses) at which it would be possible to transmit a PCM signal while maintaining average SNR of at least 58 dB. Assume Vpeak = 5V.
3. Draw the QAM analog signal that transmits the following bit stream: 0 10 1001 0 10 0 1 1 0 1 11 1 0 1 0 Assuming that the current analog signal is represented as y = sin t. You need to draw one complete cycle for each modulation change. You can assume that the number of amplitude level is 2 and the number of phase level is 4. You may use the mapping table we used in our lecture to represent data bits.
Consider a channel with bandwidth B = 2Mhz and a signal to noise ratio of 40dB (expressed in log scale, remember the conversion!). What is the maximum data rate achievable? Explicitly mention the theorem and the calculation that lead to the solution.
231. A digitized voice channel is made by digitizing a 4-kHz bandwidth analog voice signal. We need to sample the signal at twice the highest frequency (two samples per hertz). We assume that each sample requires 8 bits. What is the required bit rate? a. 64 kbps b. 32 kbps c. 128 kbps d. 16 kbps
Q3// A given FM transmitter is modulated with sinusoidal input (in volt), m(t)= 25 cos800 t, and the modulation index is (5). The un-modulated carrier power is (150Watt) across 2002 resistive load. Determine: 1. The modulation constant, K₁. 2. The approximate bandwidth of FM signal. 3. The peak amplitude of the first order lower sideband. 4. The ratio of the average power in the sum of the second and fourth sidebands to power in all the remaining sidebands excluding carrier
A regular telephone line normally has bandwidth of 4000 Hz. The signal-to-noise ratio is usually 3162 (35 dB). What is the theoretical highest bit rate (capacity) of this regular telephone line? 4000 Kbps 3162 bps 46.5 Kbps None of the other choices listed is correct
A corporation has a medium with a 7 MHz bandwidth (lowpass). The corporation needs to create 9 separate independent channels each capable of sending at least 12 Mbps. The company has decided to use QAM technology. What is the minimum number of bits per baud for each channel? What is the number of points in the constellation diagram for each channel? Let d = 0
This is my solution, Please check the solution and let me know If my solution is correct:Please adjust your decisiona nd provide corrected version if it is needed. a) The transmission time of a frame can be calculated as follows: Propagation delay (Tp) = distance/speed = 5km / 200000 km/s = 0.0025ms Transmission time (Tt) = frame size/bandwidth = 10000 * 8bits / (1Mbps * 10 ^ 6) = 0.008sec = 8ms Total time for transmission = 2 * Tp + Tt(since the frame has to travel from A to D and then D to A) = 2 * 0.0025ms + 8ms = 0.005ms + 8ms = 8.005ms The transmission time of the frame from A to D is 8.005 ms. b) The efficiency of the CSMA/CD protocol is given by the formula: Tt is the transmission time of a frame C is the number of collisions, Tp is the propagation time of a signal from one end of the segment to the other. Efficiency = Tt / (C * 2 * Tp + Tt + Tp) Assuming that there are no other stations transmitting or attempting to transmit on the segment, the transmission from…