A triangular weir has a 90° notch. What head will produce 1200 gpm? (cw = 2.5 - english) 0.31 m O 2.04 m O 0.62 m 1.02 m

Q: The head of water on a 90° triangular weir is 0.725 ft .Compute the discharge by a) Approximate…

A:

Q: 7) The floor of a weir is 20 m long with two sheet piles of 5 m at the downstream end and 4.5m at…

A: b = 20mH = 3.9mL1 = 4.5mL2 = 5m

Q: Discuss the factors that influence the kind of dam that is chosen. Each element should be discussed…

A: Factors influencing the kind of Dam that is chosen:-  These factors are discussed one by one.…

Q: Home Work Check the stability of the gravity dam section shown in Figure at the section AA' assuming…

A: We have to check the stability of the gravity dam section shown in the figure according to the given…

Q: 9. In discharge of water over narrow crested weir, discharge is directly proportional to the second…

A: formula for discharge over narrow crested weir Q=23Cd2gLH32

Q: A V-notch weir is located (or cut) at one end of a tank having a horizontal square section 1 Sm (L)…

A:

Q: A 5 KN 5 KN 5 KN 5 KN 5 KN 1m 1m 1m 1m 1m 20 kN-m DRAW V&M DIAGRAM. SOLVE FOR V-MAX NEGATIVE, V-MAX…

A: Solution:*MB = M5

Q: By placing a broad-crested weir, why we are able to measure discharge in the channel? O All the…

A: Broad Crested weird are used to get discharge in open channel and it also controls depth.

Q: A trapezoidal weir has a side slope of 1 horizontal to 4 vertical. The head over the weir is 2.5 ft…

A:

Q: B) Determine the discharge (L/s) of the weir having a head of 0.54 m. if it is a rectangular weir…

A: Given data : Length (L)=2 mCoefficient of discharge (Cd)=0.58Head (h)=0.54 m

Q: ermine the head (in meters) on a 35° V-notch weir for a discharge of 405 L/s. Use Cd = 0.948. Round…

A:

Q: The discharge over a trapezoidal weir is 1.315 m/s. The crest length is 2 m and sides are weir.…

A: Discharge, Q = 1.315 m3/s. Crest length , L = 2m. θ2= 90°-75.4°57'50''= 13.6°02'10''

Q: In a river 45ft wide, having an average depth of 3.5ft and a mean velocity of 2 fps, a contracted…

A:

Q: Compute the discharge in m3/s of a suppressed rectangular weir, C = 0.60, L = 4.88 m, H = 1.1 m %3D…

A: As per Bartleby policy we are supposed to solve only first question for multiple question…

Q: A 12 m high weir above riverbed is constructed with 1.0 m free board. The 5 km long water conveyance…

A:

Q: 7. The head of water over a rectangular weir is 26 cm. The length of the crest of the weir end…

A: To find discharge using Francis formula

Q: Determine the head (in meters) on a 25 degrees V-notch weir for a discharge of 310 L/s. use Cd =…

A:

Q: End View Water Flow H B H= head or height of water the weir P= height of weir from bottom of channel…

A:

Q: A trapezoidal weir has its non-parallel sides inclined at 4V:1H. It has a base of 4.64 m. And a head…

A:

Q: A suppressed weir 7.5m long is to discharge 10.125 m/s of water onto an open channel. The weir…

A:

Q: 4. A channel is carrying 3m/s. Assuming that an error of 1.3mm is made in measuring the head,…

A: Weir : A weir is defined as a shield that allows water to flow into an open channel. The crest is…

Q: Q: For the weir below, if you know the pressure head at point A is equal to 20 m, K=3*10-3 m/sec,…

A:

Q: : Q4 Determine the discharge over a 3.4 m wide sharp crest weir no lateral constrictions…

A:

Q: The pump-turbine system in the figure draws water from the upper reservoir in the daytime to produce…

A: Answer (21) We know that Power in Horsepower extracted by the turbine can be calculated using W˙t =…

Q: The concrete pipes culvert (n = 0.012) must carry the flow from open channel half square section 4m…

A:

Q: 1. A suppressed weir (Cw = 1.84) under a constant head of 90mm feeds a tank containing 75mm diameter…

A:

Q: A trapezoidal weir has its non-parallel sides inclined at 4V:1H. It has a base of 4.54 m. and a head…

A:

Q: A triangular weir has a 90° notch. what head will produce 1200 gpm? (Cw=2.5-english

A:

Q: 3. In discharge of water over ogee weir, discharge is directly proportional to the second power of…

A: Option b is correct.

Q: Compute the discharge in m/s on a triangular weir, C = 0.60, e = 80 deg, h= 3.3m O 7.1299 O 23.529 O…

A:

Q: Find the width (meter) of a suppressed weir using the following data: H = 25.8 cm; D = 2.485 m; Q =…

A: H=25.8cm Q=0.84m3/s

Q: Please help me with this activity. All information is in the image. According to my user, the data…

A:

Q: the crest if the sides are inclined 75'57'50" with the horizontal. The discharge over a trapezoidal…

A: Given: Q= 1.315 m3/s,  L = 2m, Inclination = 75 deg 57 min 50 sec

Q: Determine the head (in meters) on a 25 degrees V-notch weir for a discharge of 310 L/s. use Cd…

A: Given data : Coefficient of discharge Cd=0.902 The value of discharge Q=310 l/s Angle of V notch…

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.