A transmission line has aluminum conductors of a radius of 1.0 inches. If the aluminum conductors are replaced by steel conductors of an effective radius of 2.0 inches, the line: O A. None of the choices are correct O B. There is not enough information available to make any determination O C. Inductance would increase O D. Inductance would decrease but capacitance would increase O E. Inductance would increase

A transmission line has aluminum conductors of a radius of 1.0 inches. If the aluminum conductors are replaced by steel conductors of an effective radius of 2.0 inches, the line: O A. None of the choices are correct O B. There is not enough information available to make any determination O C. Inductance would increase O D. Inductance would decrease but capacitance would increase O E. Inductance would increase

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter25: Surge, Spike, And Lightning Protection

Section: Chapter Questions

Problem 10RQ: In reference to the load, how are capacitors connected to help prevent voltage spikes and surges?...

See similar textbooks

Similar questions

In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
A. For the following figure, the diameter of each conductor is 2.5 cm. Find the inductance and capacitance per km per phase. 40 cm 40 cm 40 cm a a' b b' 10 m 10 m Phase A Phase B Phase C
Emf and inductance. Pls answer all questions, thank you very much.
Noise due to inductive coupling can be reduced by twisting the wires carrying a signal. True False
9. If the GMR of the Conductor increases, the Inductance decreases. Select one: True False
The capacitance between the two conductor is 255 Farad per meter, then the Capacitance between line to ground in farad per meter is Numerical formula
In the Anderson Bridge for the measurement of inductance, drive the equations of balance for the unknown impedance L1 and R2.
In the figure, a traveling voltage wave of 500 kV proceeds towards point A. Calculate the voltages and currents in the branches after the first reflection and transmission at point A.
2, In a circuit, the capacitance of a capacitor is 3.2 microfarads and the rms voltage of the generator is 50 volts. Frequency (a) 100 Hz and (b) what is the rms current in the circuit when it is 1000 Hz?
Question 1.) Fill in the blanks with proper wording a.) For a purely resistive circuit, the voltage and current phasors are b.) For a purely inductive circuit, the voltage and current phasors are c.) For a purely capacitive circuit, the voltage and current phasors are
The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 42 feet. The per kilo feet inductive reactance will be: O A. 0.1537 B. 0.8117 O C. 0.1475 O D. 0.1148 O E. None of choices are correct
Prove that, neutral capacitance is twice of line to line capacitance.