A three-phase, three-wire Y-Y system a balance load. The following information are given of the system: Impedance of each line: 2002+j4092 Power delivered to the load: 12KW at 13kV (Line voltage at load side) Power factor at the load side: 0.7 (lagging) Determine: i. ii. iii. iv. V. The magnitude of the line currents. The magnitude of the line and phase voltages at generator side. The total average power delivered by the generator. Power factor from the generator side. Efficiency of the system.

A three-phase, three-wire Y-Y system a balance load. The following information are given of the system: Impedance of each line: 2002+j4092 Power delivered to the load: 12KW at 13kV (Line voltage at load side) Power factor at the load side: 0.7 (lagging) Determine: i. ii. iii. iv. V. The magnitude of the line currents. The magnitude of the line and phase voltages at generator side. The total average power delivered by the generator. Power factor from the generator side. Efficiency of the system.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Please click on pic to open it
Need 100% Perfect answer.
hi.. question as per attached
4. What is the significance of Power factor? Explain it with the help of Power Triangle. Refer ProQuest/Internet, Type and submit the answer not less than 200 words in Turnitin Assignment link in Moodle. Properly mention the ProQuest Link/reference website in the submission)
DEGREE: ELECTRICAL ENGINEERING SUBJECT/COURSE: INDUSTRIAL ELECTRONICSTOPIC: TRANSFORMERS NOTE: Please solve in this way. 1. Please have a good handwriting, some of the answers are not readable. Thank you!2. GIVEN. (Include symbols and units)3. ILLUSTRATION (Required).4. Step-by-step SOLUTION with Formulas and Symbols. No Shortcut, no skipping, and detailed as possible5. FINAL ANSWERS must be rounded up to two decimal places with corresponding unit. PROBLEM:An 80:5 current transformer is connected to a 5-amp ammeter. if the latter reads 3.65 amp, what is the line current?
Please send the Design of the tank as photo or PDF file the Design sketch of the tank is require please
Refer to the National Electrical Code® or the working drawings when necessary. Where applicable, responses should be written in complete sentences. For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft x 18 ft (~3.7 m x ~5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0. 1. The maximum distance that the luminaires can be separated and achieve uniform illuminance is ft ( m). For problems 2-5, two luminaires, 8 ft (2.5 m) and 4 ft (1.2 m) in length with dimensions as shown in Figure 15-7, are to be installed in tandem (end to end). The end of the long luminaire is to be 2 ft (600 mm) from the wall. 2. The center of the outlet box should be roughed in at ft ( m) from the wall. 3. The first support should be installed at the wall. ft ( m) from 4. The second support should be installed at from the wall. ft ( m) 5. The final support should be installed at the wall. ft…
Please solve ..
DEGREE: Electrical Engineering SUBJECT/COURSE: AC CircuitsTOPIC: Converter and Rectifier NOTE: Please solve in this way. 1. Please have a good handwriting, some of the answers are not readable. Thank you!2. GIVEN. (Include symbols and units)3. REQUIRED/FIND/MISSING (with symbol/s)4. ILLUSTRATION (Required).5. Step-by-step SOLUTION with Formulas and Symbols. No Shortcut, No skipping, and detailed as possible6. FINAL ANSWERS must be rounded up to three decimal places PROBLEM: A 1,000-kw three-phase converter delivers full load at 600volts. If the efficiency is 94percent and the power factor is 0.96, determine:(a) the direct-current output(b) the a-c slip-ring current(c) the kilovolt-ampere load delivered by each transformer.
Can you help me with these problems?
DEGREE: ELECTRICAL ENGINEERING SUBJECT/COURSE: INDUSTRIAL ELECTRONICSTOPIC: TRANSFORMERS NOTE: Please solve in this way. 1. Please have a good handwriting, some of the answers are not readable. Thank you!2. GIVEN. (Include symbols and units)3. ILLUSTRATION (Required).4. Step-by-step SOLUTION with Formulas and Symbols. No Shortcut, no skipping, and detailed as possible5. FINAL ANSWERS must be rounded up to two decimal places with corresponding unit. PROBLEM:Connect the three 1-Φ transformers in bank:Primary winding in WYE and secondary windings in DELTA.
How did you find the angles? Also my computer says the answer to (a.) is incorrect.