A three phase star-connected load drawing power at a voltage of 0.9 pu and 0.8 power factor lagging. The three phase base power and base current are 100 MVA and 437.38 A respectively. The line-to-line load voltage in kV is

A three phase star-connected load drawing power at a voltage of 0.9 pu and 0.8 power factor lagging. The three phase base power and base current are 100 MVA and 437.38 A respectively. The line-to-line load voltage in kV is

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: と。 O/ A balance 2-phose Y-Comecled \aad has z to 4-usa on Find phose Curents and live cnnnts.

A: Given data, Phase impedance is given, Zph=10∠-450 VCA is the voltage between line C and A therefore…

Q: Three point charges as Determine the electric force on the -0.60 µC charge due to the other two…

A: The charge q1 will be acted by attractive force by other two charges in positive x and positive y…

Q: What would be the same results of this quesiton if the circuit was single phase 1000v?

A: If True power is single phase i.e.,P1ϕ=10kWV1ϕ=1000VI1ϕ=12.33 A

Q: 1= 20/70° A E = 80/40⁰ V

A: W need to find out reactance for given current and voltage

Q: Three one-phase (270 / 178V) transformers are connected in star-delta to the three-phase system.…

Q: Pu pole Dc shunt genesator ouitn a shunt field resistamce of 100 aomature oesistance of 1.2n has 264…

A: Given,P=4Rsh=100ΩRa=1.2ΩZ=364ϕ=0.02RL=10ΩN=1000 aGenerated emf,…

Q: The maximum size overcurrent device for primary only protection of a three-phase, 37.50 kVA,…

Q: A split-wye capacitor bank is made up of two 4500-kVAR, 13.8-kV sections, for a total installed…

A: This problem is based on the concept of a balanced 3-phase system and power calculations in AC…

Q: (a) Give THREE (3) advantages of a three-phase system compared to a single-phase system.

Q: ば 52+GS+13

A: In the question Find the Inverse laplace transform of the given function. We know cos(at)…

Q: Problem 1 – The 4.16kV distribution station capacitor bank below consists of 3 ungrounded double-wye…

A: a) 110% of rated rms voltage b) 120% of rated peak voltage. a) Kilo over - 135% b) RMS voltage -…

Q: are used across an inductive and capacitive loads so as to supply part of the reactive VARS required…

Q: What is the phase displacement between any three currents of LLL fault of a three phase system.

A: LLL fault is called as the triple line fault.

Q: ) Choose how to measure the R phase voltage in three phase star connected system? a. Between…

A: Phase voltage is measured between one phase and neutral

Q: Which is easier to smooth the wave a three-phase unifying circuit or a single-phase circuit using a…

A: Three phase unifying circuit: A three-phase unifying circuit, also known as a three-phase bridge…

Q: Problem 3 Circuit Element 3 C =20 [µF] rad w =2000 + What is the magnitude of the impedance of this…

A: Here, we have given a circuit, where we can see that the circuit consists of a capacitor only. So,…

Q: Scott connection of transformer is used to convert supply. O Three phase supply to Single phase O…

A: Given To determine purpose of Scott connection of transformer.

Q: What is a three phase balanced star connected load? Its phase power measurement and total supply…

Q: Calculate I linea and I G Zcarga = 8.66 + 5.00 j

Q: When a delta-connected source is connected to a delta-connected load,

Q: please include the request below with the phasor diagram C ii) Construct the new phasor for E’…

Q: reactance diagram

A: Transformer- A device that transfers the electrical energy between two electrical circuits which are…

Q: Can you explain regarding shunt reactor and shunt capacitor?

A: Shunt Inductive reactor Inductive reactor absorbs lagging VAR and supplies leading VAR. The…

Q: 1. Find the minimum output expression for circuit of figure below and draw logic circuit. A

A: In this question we need to minimize the output expression and logic gate.

Q: A3-phase three stepped core transformer having a leakage impedance of 0.15 p.u. The positive…

A: A 3 phase three stepped core transformer having a leakage impedance of 0.15 pu. The positive…

Q: 72. In 132 kV system, the phase to ground ca- pacitance is 0.01 µF and inductance is 6H. The voltage…

Q: APPLICATION OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT

A: we need to answer what are the APPLICATION OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT .

Q: Which of the following is the severest and has the lowest percentage of occurrence? DLG L-L 3-Phase…

Q: Voltage of a particular bus can be controlled by controlling the: A active power of the bus B…

A: Electrical bus An electrical bus bar is a conductor or group of conductors that collects and…

Q: A three phase power system has a fault level of 500 MVA and Sg = 100 MVA at a 132 kV busbar. What is…

A: Given, A three phase power system has SB=100 MVAVB=132 kV Fault level is 500 MVA.

Q: The maximum size overcurrent device for primary only protection of a three-phase 75 kVA transformer…

Q: In a three phase -four wire star connected system, the three outer wires are called as lines and the…

A: Fig: Three phase four wire system In the above shown system the common wire (N) in the…

Q: 2-What is the relationship between phase and line quantities in balanced star and delta connections…

A: Let us consider a balance 3 phase system in which a balance 3 phase load connected in star and delta…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Three phase star connection,

A three phase
star-connected load is drawing power at a voltage of 0.9 pu and 0.8
power factor lagging. The three phase base power and base current are 100 MVA
and 437.38 A respectively. The line-to-line load voltage in kV is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given-

VIEW

Step 2: Calculation

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

True or False The zero sequence components consist of 3 equal sized phasors. The phase difference between the phases is 120.
Draw the different combination of 3 phase connection
What size primary conductor can be used for a three-phase, 480V transformer, where the primary overcurrent protection is sized at 175A? a. 1/0 AWG b.2/0 AWG OC. 3/0 AWG d.4/0 AWG
For a star connected three phase AC circuit is associated with
The maximum size overcurrent device for primary only protection of a three-phase 45 kVA transformer with a 480V primary and a 120/208V secondary is Oa.50A Ob.60A Oc. 70A Od.90A
Determine the primary line current of the following three phase circuit using a 5:1 step-down wye-t0-delta wired transformer. 5:1 480V Lino In 4160V ess Va 30 Vuna 277V Vuno Primary Secondary O 7.4 A O 2.7A O 1.07A O 5.1A 2401V
What would be the total single phase 120kVA capacity that could be used with the transformers size of 1.5 kVA?
Differentiate series connection from a parallel connection based on the electrical characteristic
Branch - circuit conductors must have an ampacity not less than? Served. A maximum load b minimum load c average load d average 3 phase load
In a three phase - four wire star connected system, the three outer wires are called as