A tensile test is performed on a brass specimen 10mm in diameter using a gage lenght of 50mm. When the tensile load P reachers a value of 20kN, the distance between the gage marks has increased by 0.122 mm. What is the modulus of elasticity of the brass.

A tensile test is performed on a brass specimen 10mm in diameter using a gage lenght of 50mm. When the tensile load P reachers a value of 20kN, the distance between the gage marks has increased by 0.122 mm. What is the modulus of elasticity of the brass.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

#2 will upvote to anyone who will answer
A mild steel bar of 2cm is subject to tensile test. The bar yields under a load of 80kN. It reaches a maximum load of 150kN and breaks finally at a load of 70kN. Estimate the a) Average tensile stress at yield point b) ultimate tensile stress c) average stress at the breaking point if the diameter of the fractured neck is 1cm
A steel specimen is tested in tension. The specimen is 2 in. wide by 2.3 in. thick in the test region. By monitoring the load dial of the testing machine, it was found that the specimen yielded at a load of 30 kips and fractured at 40 kips. a) Determine the tensile stress at yield and fracture; b) If the original gauge length was 4 in., estimate the gauge length when the specimen is stressed to 2 the yield stress.
A 50 mm diameter steel hanger rod carries an axial load of 271 kilonewtons. Under this load, it's average unit strain is 0.00069. determine the modulus of elasticity for the steel.
Part B,G, and H. Please provide proper units
A steel specimen having a modulus of elasticity equal to 29x103ksi has a width of 1.0in and thickness of 0.25in. During the tensile strength testing, the specimen yielded at 12.5kips and fractured at 17.5 kips. Compute the value of the tensile stresses at yield and fracture
A cylindrical specimen of some metal alloy having an elastic modulus of 101 GPa and an original cross-sectional diameter of 3.6 mm will experience only elastic deformation when a tensile load of 2430 N is applied. Calculate the maximum length of the specimen before deformation if the maximum allowable elongation is 0.41 mm. i mm
Determine the ductility of the following steel samples that undergo tensile strength test. All dimensions in millimeter.
"Engineering Stress-Strain Curve" for a low carbon steel obtained as a result of the tensile test test. In terms of plastic forming by drawing important points on it (rolling, forging, machining ... etc.) Explain its importance.
Don't use Ai to answer. Provide Handwritten work ,The answer must be accurate.
A drill rod with a diameter of 10 mm is made of high-strength steel alloy with a shear modulus of 80 GPa. The rod is to be subjected to a torque T. What is the minimum required length L of the rod so that the cross section at one end can be rotated 90° with respect to the other end without exceeding an allowable shear stress of 300 MPa?
An alloy steel specimen of 30 mm diameter with a gauge length of 200 mm is load tested. It has extension of 0.16 mm under a load of 85 kN. Load at elastic limit is 160 kN. Young's modulus of the specimen in GPa O 127 O 143 O 150 O 172