A telephone communication system normally has a bandwidth of 3000 Hz allocated for data transmission. The signal-to-noise is typically 3002. What is the highest theoretical bit rate or channel capacity of the system

Q: Explain the QPSK modulation challenges and problems.

A: QPSK stands for quadrature phase shift keying. It is a modulation technique that transmits two bits…

Q: Briefly, write the advantages and disadvantages of Delta Modulation ? .Note( Don't copy and paste…

A: Given, Question related to Delta modulation. Please find the below attachment for the clear…

Q: a) What are the disadvantages of a TRF receiver? Explain how a superheterodyne receiver overcomes…

A: (a) TRF receiver: A tuned radio frequency (TRF) receiver where tuning i.e, selectivity is obtained…

Q: 1. Draw the spectrum of AM-DSB-SC? 2. What is the minimum B. Wrequired to modulate the voice signal…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 10. For a single-conversion SSB transmitter, an audio frequency is ranging from 0 to 4 kHz, and HF…

A:

Q: Explain the relationship between the minimum bandwidth required for a BPSK system and the bit rate.

A: A message signal is transferred from the sender to the receiver end. The signal is transmitted…

Q: A digital data will be transmitted over an analog transmission medium that has a maximum bandwidth…

A: Channel Bandwidth, B=1.4 MHz, SNR=26.2 dB we have to find out a) the maximum data speed of the…

Q: Using Verilog continuous assignment statements or VHDL signal assignment statements, write a…

A:

Q: Identify and plot the power spectral density separately corresponding to the identified line codes…

A: According to the question,

Q: How should a designer construct the receiver in order to minimse the overall noise temperature?

A: Receiver noise temperature- It is a composition of all noises which enters in receiver via antenna.…

Q: Answer the following: (a)  What is the maximum data rate for a 64-level system with an analog…

A: a) Given bandwidth (BW)=400 MHz   Level (L)=64 Maximum bit rate= 2×BW×log (L) Now, putting the value…

Q: Describe how FM signals are different from AM signals?

A: In this question we discuss about how FM signals are different from AM signals?

Q: The binary sequence 11100101 is applied to Sunde's BFSK modulator. The bit duration is 1 με. The…

A: For a BFSK signal

Q: What information can be obtained by result and analysis of  "Enhance AM radio signal broadcasting"

A: AM broadcasting is radio broadcasting using amplitude modulation (AM) transmission . It was the…

Q: receiver has a sensitivity of 0.3 μV, and the same receiver can handle a signal level of 75 mV…

A:

Q: Advantages of LQG on noisy environment ?

A: LQG (linear–quadratic–Gaussian) It is perhaps the most key ideal control issues. It concerns direct…

Q: the total sampling time

A:

Q: Explain information regarding Discrete Signal

A: A discrete sign or discrete-time signal is a period series comprising of a grouping of amounts.…

Q: 1. What are baseband signals, and why can't we transmit BB signal directly (name 4 disadvantages).…

A: Baseband is a signal at a very narrow frequency range on which data or information is superimposed…

Q: Determine the following if the mark frequency of 50 kHz, a space frequency of 54 kHz, and an input…

A: For the given FSK system we need to find, the peak frequency deviation, minimum bandwidth baud for…

Q: c) The superheterodyne receiver (SuperHet) is an architecture that enables the same receiver to…

A: BLOCK DIAGRAM OF SINGLE STAGE       SUPERHETERODYNE RECEIVER

Q: Design the Frequency Division Multiplexer (FDM) for three voice signals where the bandwidth (BW) of…

A: Multiplexing is the process of sharing a single communication channel or medium for transmission of…

Q: draw the spectrum ideal Sampling and Natured Sampling??

A: According to the given question, it is required to draw the spectrum of both the ideal and natured…

Q: Noise generated by an amplifier of radio is an example for?

A: Noise generated by an amplifier of radio is a type of random signal because it has uncertainty…

Q: 1- Explain the principle of direct method generation of FM signal.

A: The explanation is as follows.

Q: List the reasons why the modulation is desired in a wireless communication system considering the…

A: Modulation is a technique that is used in carrier wave to transmit some information at low…

Q: Calculate the frequency of the TDM pulses for a 4 - channel TDM transmitter  if the maximum…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again. The…

Q: c) The superheterodyne receiver (SuperHet) is an architecture that enables the same receiver to…

A: Introduction - Superheterodyne receiver - A superheterodyne receiver, also known as a superhet, is a…

Q: Calculate the channel capacity in bits per second for a 20 MHz channel with a signal-to-noise ratio…

A:

Q: Write short notes on EEG signal classification in terms of frequency.

A: Electroencephalogram(EEG):                  The electroencephalogram (EEG) is a scalp recording of…

Q: For a 16-QAM modulator with input bit rate fb = 10 Mbps and carrier frequency fc = 60 MHz, calculate…

A:

Q: a) An amplitude modulated (AM) signal is made up of a carrier (with constant frequency) in which its…

A:

Q: The number of bits per sample in a PCM system has SNqR=45 dB is

A: SNqR can be given as      SNqR =(6n+1.8)db

Q: We need to send data 15bits at a time at a bit rate of 9Mbps. The carrier frequency is…

A:

Q: Direct method for generation of FM signal does not give high stability to FM signal frequency O a.…

A: solve prob.

Q: Calculate channel capacity, in bits per second, of a 10-MHz channel with an S/N ratio of 50 dB

A: Here, the given is, B=10 MHzB=10×106 HzSN=50 dB

Q: Assume that a voice channel occupies a bandwidth of 4 kHz. We need to combine three voice channels…

A: Given data: A voice channel occupies a bandwidth of 4 kHz. Let the voice channel has spectrum as…

Q: Determine the frequency of the modulating signal which is producing an FM signal having a bandwidth…

A: The solution is given below

Q: Problem 1: Question: The following figure shows multimedia quality performance measured by Peak…

A: The following figure shows multimedia quality performance measured by peak signal to noise ratio…

Q: eight-level encoding scheme is used in a 30-kHz-bandwidth system, what is the channel capacity in…

A:

Q: The Nyquist rate for sampling an analog electrocardiogram (ECG) signal with 80 Hz highest frequency…

A: Given data, Maximum frequency of the analog signal,  fm=80 Hz Nyquist sampling frequency, fs=150 Hz…

Q: 2. What is the minimum band width required to modulate the voice signal by using FM ?

A: Frequency modulation-Frequency modulation means varying the frequency of carrier wave with principal…

Q: Problem 4: a. For a Communications system with capacity of 400 kbps and SNR = 35dB and a lower…

A:

Q: PCM system is used to transmit base4 signal of 512 level, the input signal works in the range…

A: Given that  number of level (m)=512range of input signal =30MHz-70MHzsample frequency (f)=50MHz…

Q: Consider a telephone line initially noiseless channel having bandwidth and signal level determined…

A: Data rate is the rate that governs the speed of data transmission. It basically depends on three…

Q: Which of the following audio types has the highest bit resolution and sampling rate? A.FM boardcast…

A: In this question,  We need to choose the correct option Which of the following audio types has the…

Q: Determine the saving, in signal power, in the case of 50% modulated AM signal, if the carrier is…

A: The solution can be achieved as follows.

Q: Discuss the effect of decreasing the amplitude of the carrier on the modulated output.

A: