A Synchronous Motor taking 40kW is working in parallel with a load of 80kW having a power factor of 0.75 lagging. The power factor of the combined load os 0.9 lagging. Find the power factor and the reactive KVA of the motor

Q: Find Rth for the following circuit. 4V 50 www 150 www 1002 www 80 120 www 6V

A: For calculating thevenin resistance, voltage source is short circuited and current source is open…

Q: The dynamic part of the state space representation of the following circuit with R₁ = 40 R₂ = 30 L₁…

A: The given circuit isR1=4 Ω.R2=3 Ω.L1=0.25 H.L2=0.5 H.We need to determine the state space…

Q: Q3: Consider non-minimum phase unity feedback system with the following open loop transfer function:…

A:

Q: In the figure below, suppose the switch has been closed for a time interval sufficiently long for…

A: A capacitor is an electronic component that stores electrical energy in an electric field. It…

Q: Show the value of the voltage and it's polarity between terminals A and B for each of the three…

A: Show the value of the voltage and it's polarity between terminals A and B for each of the three…

Q: The equivalent resistance in the infinite ladder network shown in figure, is Re 2R am R The value of…

A: The infinite ladder circuit is given asIn this question, we need to determine the ratio of…

Q: Current and voltages???

A: Given data:Required information:

Q: Q.2) A) For the sinusoidal signal m(t) 2 sin(2000xt+ 0.055x), shown down, is sampled, quantized and…

A: "Since you have posted multiple questions with multiple sub parts, we will provide the solution only…

Q: Exercise 4.4 ▸ A 2.4 KVA, 2400/240 V 50 Hz step down transformer has the following parameters ▸ R₁ =…

A: Given Data:A step-down transformer with,Power rating Voltage rating Load percentage Power factor To…

Q: by applying kirchhoff's voltage law to a series RLC circuit, we obtain the relationship;…

A: By applying Kirchhoff's voltage law to a series RLC circuit:

Q: The CS stage of a bias current of 0.5 mA. must provide a voltage gain of 10 with a). Compute the…

A: Diagram is given,

Q: Q1: A position vector has a length of 40 m and is at an angle of 57° above the x- axis. Find the…

A:

Q: Q3A- find the energy of the right side signal: x(t)=Ae ²¹ u(t) Q3B- fine the power of the x(t)=…

A: To determine:energy of one-sided signal x(t)=Ae−2tu(t),power of periodic signal x(t)=8cos(50t+π2).

Q: A) By using K-Map, find the equation of the following: F = (0,1,2,3,4,6,8,9,10,11,12,14) B) Extract…

A: In the given questions we need to find the Boolean function using Kmap and simplify the logic…

Q: Calculate the ripple factor in a half-wave combiner circuit and the value of the output frequency,…

A:

Q: 2.15 Calculate v and i, in the circuit of Fig. 2.79.

A: Given data:Required information:

Q: Obtain the transfer function V (s)/V, of the circuit in Fig. 14.69. 0

A: Given data:Required information:

Q: " V1 12V R1 22.2ΚΩ R2: чко: R3 3.3k $1 KeySpace- Key-Space- R4 24.7kQ R5 3.3kQ

A: Given Data:A DC resistive circuit of,To Find:i. The total resistance in the circuit.ii. The currents…

Q: Determine the voltage gain of the stage shown in VDD VinM₂ Assume λ 0. - Vout VDIMM3 HEM.

A:

Q: 2) A current of 250mA flows through a perfect inductor, when it is connected to a 5V, 1kHz supply.…

A:

Q: Electromechanical energy conversion Measured in the idle running test of a three-phase…

A: Electromechanical energy conversion Measured in the idle running test of a three-phase…

Q: 23: Consider non-minimum phase unity feedback system with the following open loop transfer function:…

A:

Q: Q5. A dc ammeter has resistance of 0.102 and current range is 0- 100 A. If the range is to be…

A: Given data:Required information:

Q: 2- Use superposition to obtain vx in the circuit of Figure below. 90 V 30 12 www 102 www Vx 60 52 6…

A: Given circuit,Asked to find the vx using the Superposition theorem.There are three active energy…

Q: Q3A- find the energy of the right side signal: x(t)=Ae-²¹ u(t) Q3B- fine the power of the x(t)=…

A: To determine:energy of one-sided signal x(t)=Ae−2tu(t),power of periodic signal x(t)=8cos(50t+π2).

Q: 11 What is V? A) 4.0V B) 1.8V C) 2.2V D) 3.3V E) none of the above. 10V 1092 2092 1092 2092 V

A: Given:A circuit, we need to find:the value of voltage v.

Q: [n] = 8[n] + sinlun]u[n] + (–0.25)-"ul-nl

A:

Q: 1. Determine the current in the circuit. V: w 20 22 20V V₂: iz 0.8 A 40 02 1V₂

A: Given:A circuit, we need to find:the value of current i.

Q: The power input to a 250 h.p., 1100V 3 phase motor running st full liad is measured by a two watt…

A: In this question, we need to determine the input power, power factor, line current and the…

Q: 7. Draw the circuit diagram of a 3-bit by 3-bit array multiplier using 1-bit full adder units and…

A:

Q: Q2: Use Nodal analysis to find Vx in the circuit shown below: www 0.81 50 0.25% ww 292 3A 5A 1002

A: Nodal analysis is a method used in electrical circuit analysis to determine the voltage at each node…

Q: 3- Plakasında 600 V, 50 Hz, 18 kW, 1450 devir/dakika yazan 3 fazlı, yıldız (Y) bağlı, 4 kutuplu…

A:

Q: 1. Using graphical method, compute the convolution integral y(t) = x(t) h(t) for the pair of signals…

A: Given:we need to compute: the convolution of of x(t) and h(t).

Q: 2. Convert the following binary numbers to the decimal. (10110011)2: (100011101)2; and (111000)2

A: given binary numbers and asked to convert them to decimals.

Q: Consider a p+/n junction made of silicon doped with NA 3x1018 cm3 and ND 2 ×10¹6 cm-³3. Taking the…

A:

Q: 3.⁠ ⁠Given a 4-bit adder, how do you use it to design a subtractor? Give your design and explain it.

A: The objective of the question is to understand how to design a subtractor using a 4-bit adder. This…

Q: Q: Choose The Correct Answer 1. What is the main advantage of using FSK over ASK for digital…

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: Q3A- find the energy of the right side signal: x(t)=Ae2¹ u(t) Q3B- fine the power of the x(t)=…

A: To determine:energy of one-sided signal x(t)=Ae−2tu(t),power of periodic signal x(t)=8cos(50t+π2).

Q: Q20) Give a plot that represents an ASK modulation of the sequence of bits (101010000111) using…

A:

Q: Q2) What is the range of output voltage in the circuit below Σ]20KΩ 600KΩ V1 = + 25mV V2 = -20 mV- –…

A: The output voltage will be minimum when variable resistance will be short-circuited:=>Now,…

Q: 14. Express the following functions in sum of minterms form: (a) F(A, B, C, D)= (1,3,5, 11, 13, 14)…

A: given a function and asked to express it in terms of minterms.

Q: 12. A 500 kVA transformer is having efficiency of 95% at full load and also at 60% of full load;…

A: Given data:Required information:

Q: Find Vx in the circuit of Fig. 2.85.

A: Given data:Required information:

Q: Q3) In free space a point charge of 100nc at origin and a volume of a uinform charge distribution…

A:

Q: A digital communication system using ASK transmits 1s and 2s by changing the amplitude of a carrier…

A:

Q: J₁ E V₂ R₁ R3 Va 86 J₁=30mA 82=10³0-1 R₁ 200 R₁=1000 E₁-45V Js=20mA 86-50

A: Where,

Q: Q13) Plot the amplitude spectrum of the sampled signal X, (f) in the previous question with sampling…

A:

Q: (b) Find the 3-phase balanced fault current at bus 2 using Thevenin's method. 10/0² لمات J0.2 10.2 م…

A:

Q: 7 Determine the Vo for the network of figure below for the Input shown. lov - lov t Vi 0 Si # 2-244…

A: Given:Two diode circuits, we need to determine the output V0 for both the circuits for the input,

Q: d. The time taken for the coil to become fully energised. e. Calculate the peak voltage at the…

A: This question is transient analysis