A synchronous motor rotating at 900 rpm, is used as the prime-mover of the generator that have   four-pair of magnets. Compute the frequency of the generator

Q: 3 v(1) (+ G(s) = 2 H oooo VL(S) = , for the network shown V(s)' 292 ww 2Ω. elle m 2 H VL(1)

A:

Q: The figure shows a 4 to 1 MUX to be used to implement the sum S of a 1-bit full adder with input…

A: Solution !!

Q: When a 4.7 uF capacitor is connected to a 1 kHz source, what is its capacitive reactance? A. 4.7…

A:

Q: Two loads are connected in parallel to a source of emf whose voltage is (110 + j63.5). if the branch…

A: In this question,  We need to determine the total current, equivalent impedance, total power and…

Q: Question 4 Evaluate the following Inverse Laplace transforms. 1 s² + 3s +2

A:

Q: How does a multi-meter measure resistance?

A: The multi-meter is a device that measures various quantities such as resistance,  voltage, current…

Q: 15. Calculate V, in the circuit of Fig. 10.74. +25 mV -20 mV 15kQ m 30 k m 600 k ww AG. 10.74 30 k w…

A:

Q: Point charges Q₁ = 5 µC and Q2 = -4 µC are placed at (3,2,1) and (-4,0,6), respectively. Determine…

A: Given data, Charges, Q1=5 μCQ2=-4 μC Distance of Q1 (3,2,1) Distance of Q2 -4,0,6

Q: In the magnetic circuit of Example 4.4, an air gap of length 0.5 mm is cut in the lower leg of the…

A: Given data are: The cross-sectional area of the core, Ac=12 cm2=12×10-4m2 Length of the core,…

Q: Q) The voltage and current of a circuit are given as V₁ + jV2 and I₁ - jI2 respectively. Determine…

A: Given- Voltage of the circuit- V=V1+jV2, Current of the circuit- I=I1-jI2, To Find- The circuit…

Q: 2. Consider the circuit below. The switch has been in position a for a long time. Then at t = 0 it…

A: The switch has been in position a for long time therefore at t=0- circuit is at steady state.

Q: A 500kVA, 3 phase transformer, 60Hz, Delta-Wye, has the voltage ratio 34/12kV. Resistance per phase…

A: Given data, Sout=500 kVA Pcore=3050 W

Q: Q- The armature resistance of a permanent magnet dc motor is 0.80. At no load, the motor draws 1.5 A…

A: Given- Armature resistance- Ra=0.8 Ω, Current- Ia=3.5 A, supply voltage V=25 V, speed=1500 RPM, To…

Q: using 792 Q4/B/ Answer Only One of the following: 1. Draw the waveform of the outputs (Q1&Q2) of D…

A: In this question we need to draw a timing diagram of the given sequential circuits

Q: le machine running at 1500 r.p.m. has an armature with 90 slots and 6 conductors per slot. le is 10…

A:

Q: A given signal f (1)

A:

Q: 2. Given points P(1.-3.5), Q(2,4,6), and R(0,3,8), find: (a) The position vectors of P and R (b) The…

A:

Q: For a semiconductor at OK, what is the probability that the allowed energy states, E< Ev, are empty?…

A: SOLUTION From probability of finding electron in energy state E is…

Q: 5. Calculate the flux per pole required on full-load for a 50 kW, 400 V, 8-pole, 600 r.p.m. d.c.…

A:

Q: A message signal m(t) is modulating a carrier cos(27301t) using DSBSC technique. If the value of the…

A: Given:  Using DSBSC Technique of Modulation  c(t) = cos2π301tm(t) = 9.7Time = 3.4 Find: Value of…

Q: 1. The figure shows a fixed conducting wire, bent to form a square frame of side b, lying in the…

A:

Q: FIND THE TOTAL POWER DEVELOPED IN THE CIRCUIT Ћ спасит Berow If V% = 5V 9A 20V + бд 64 Va - + го -…

A: In this question,  We need to determine the total power developed by the circuit.  A element is…

Q: its making current

A:

Q: In the given circuit shown, all MOSFETS are N-channel MOSFETS. MOSFET M, and M₂ are matched and…

A:

Q: 14. Calculate the output voltage, V, in the circuit of Fig. 10.73. V₁ = 0.1 V 20 ΚΩ 400 k www 20 kn…

A: Given data:  The circuit diagram is shown below,

Q: In the network in Fig. V, is known to be 8/45° V. Compute Vs. S

A:

Q: 7. Refer to the Hartley Oscillator circuit, compute for wo and gm. L1 = 10mH, L2 = 20mH, R =…

A:

Q: If V₁ = 17 V₁ V₂ = 5 V and V3 = -7 V, the voltage Vo (in volts) is + V₁ - Vo O-29 015 O-15 O-19 029…

A: Given circuit, Where the voltage are, V1=17 V,V2=5 V,V3=-7 V.

Q: Q2: A three-phase Transmission line with 1,956 cm diameter conductor, the corona takes place if the…

A: Here  mo is mistakenly printed as 11 , but it is 1. And the diameter of the conductor is 1.956Cm

Q: What are the conduction angle of the SCR if the device will trigger at 38V break - over voltage? n…

A:

Q: What is the radius in cm of 100 MCM Cable?

A: given cable problem

Q: The equiva parallel cin A 85 (a) 8 ohms (c) 12 ohm

A: Given data, Circuit diagram is given as,

Q: ate the ign of a WI having a Idi dred langanin having a resistivity of 50 x10^-8 ohm-m. If the wire…

A: Resistance opposes the flow of current. The unit of resistance is ohm. Resistance is depend on…

Q: Consider the circuit shown below. Calculate The voltage across R4 resistor. 12 V R1= 20 22 M R4= 80…

A:

Q: Problem Solving mi h. Ov ULD Let R 30 SL L = 15mH Determine C= 120 μF b) Je, IL GIC a) ZT. IT & T )…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A current of 1 A is maintained in a simple circuit with a total resistance of 2.5 00. How much heat…

A: When a current is passed through a conductor, it heats up over time, producing heat. This happens…

Q: 3) In the following circuit, find: 12 V 4 ΚΩ 6 ΚΩ 6V 6 mA a) I, using nodal analysis b) The voltage…

A: Given circuit, Marking all the nodes,

Q: For class AB amplifier the R.M.S. input voltage is IIV and the supply voltage is ±20V and the load…

A: Given that                                  Vin(rms) =11 V                                   Vcc…

Q: b) Differentiate between periodic pulse trains and non-periodic pulse trains in the context of…

A: A basic signal should first be verified by an intermittent pulse train to convert it from constant…

Q: The voltage gain (Av,dB) of an amplifier is -26 dB, what is the voltage gain (Av) in V/V? The power…

A: SOLUTION GIVEN--&gt;                   (Av)dB = -26                  (…

Q: Given the Fourier Cosine Transform F(w)= (2/Pi)a/(a^2+w^2) use integration to find the Inverse…

A: Given: F(ω)=2π×aa2+ω2 To find:  Inverse Fourier Cosine Transform, f(t)

Q: By doing the " Coloumbs Law Lab " how do you calculate the electric force on suspended balloon and…

A:

Q: Answer in 4 sentences only. 3. Why should you not hold the resistor while measuring its resistance?

A: We should not hold the resistor will measuring its resistance.

Q: In the network in Fig. Vs + I₁ V is known to be 8/45° V. Compute V S 13 ww 202 + V₁ 1₂ j2 n -j2 n…

A: This is a problem of circuit. The problem can be solved by using ohms law, KVL and KCL. The detailed…

Q: Convert the following voltage ratios to dB. (a) 3000 (b) √30

A: a) Given: The voltage ratio, Av=3000

Q: A machine coil has a resistance of 46 ohms at 25 degrees celsius. Its temperature coefficient of…

A:

Q: The content must be the connection of resistor color codes to tolerances and the relationship of the…

A: According to the question, for the given resistor color code and measurements as shown below, We…

Q: The root locus plot of a system intersecting the constant damping ratio line is shown in below…

A: Given data: The diagram is shown below,

Q: Can I please have the part a  handwritten? I can't tell which variable has the bar sign

A:

Q: A 3 Bus network is shown. Consider generators as ideal voltage sources. If rows 1, 2 and 3 of the…

A:

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.