A synchronous generator connected directly to an infinite bus is generating at its maximum real power. Assume that the generator field current is adjusted to supply line-line voltage of 420 V under rated conditions. At rated conditions, the internal phase excitation (Field)voltage Ea= 421426 V, Find Xs on ohms if irs maximum nower is 676 kW

A synchronous generator connected directly to an infinite bus is generating at its maximum real power. Assume that the generator field current is adjusted to supply line-line voltage of 420 V under rated conditions. At rated conditions, the internal phase excitation (Field)voltage Ea= 421426 V, Find Xs on ohms if irs maximum nower is 676 kW

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

When this generator is connected to a 13.8 kV distribution feeder of negligible impedanceand operates at an output power of 8.75 MW at 0.9 power factor lagging, work out the field current, the reactive-power output, and the load angle for this operating condition.
A synchronous generator supplies rated power at 0.8 pf lagging.ra = 0.015p. u., andxl 1p.u. . Find out the possible terminal voltage. In case of the practical operation, which terminal voltage is more feasible? =
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 25.4 MVA, 60 Hz, 0.77 PF lagging, 4-poles, Y-connected, with synchronous reactance of 2 Q and an armature resistance of 0.05 Q. Each of generators G1 , and G2 has a characteristic power-frequency slope of 5.8 MW/Hz, and no-load frequency of 62.5 Hz. Generator G3 has a characteristic power-frequency slope of 6.0 MW/Hz. Find the no-load frequency of generator G3 for which all generators supply a load of 42.6 MW, at fsys = 60 Hz. Select one: O a. fevs = 62.95 Hz O b. fsys = 62.26 Hz O c. None O d. fsys = 62.5 Hz
a. 4 KA O b. None of these O c. 6.25 kA O d. 2.309 KA A 100-MVA, 60-kV, three-phase synchronous generator has a synchronous reactance of 16 Ohms/phase and negligible armature resistance. The generator is operating with an excitation per phase E= 47.116 KV, and is delivering maximum power before losing synchronism (stability limit). Thus, the maximum generated power is Pmax = and the armature current is la = 306 MW None of these 102 MW 530 MW A 90-MVA 69.3-kV, three-phase synchronous generator has a synchronous reactance of 10 Ohms/phase and negligible armature resistance. The generator is delivering power to the bus bar at the rated voltage with its field current adjusted for a generated emf (excitation voltage) of 50 kV per phase and a power angle & = 7.1 degree. Thus, the delivered power is the generator armature current is and the power factor is The thre tings of the below.electr nower system is given below:
(a) Illustrate the process of power generation from a typical thermal power plant. Describe the overall power generation process of a typical thermal power plant based on your illustration in 5(a). Distinguish between geothermal power plant and thermal power plant.
may be more than one answer
A 10 KVA, 400 V, 3 phase, star cónnected synchronous generator has an armature resistance of 0.80 per phase and synchronous reactance of 1.5 Q per phase. The voltage regulation at a power factor 0.6 lagging is
A generator is connected through a transformer to a synchronous motor as shown in the following figure. (All values in this problem are per unit.) Before the fault V,=0.9,1=1 with power factor 0.8 lagging. jX, P + jX ds jX" dm + E. E The reactances are Xd=0.15 , X,=0.1 , X âm=0.35. A symmetric fault occurs at P. Find the per-unit current magnitudes in the fault, the generator and the motor (a) using subtransient voltages. (b) using a Thevenin equivalent.
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 24 MVA, 50 Hz, 0.85 PF lagging, 4-poles, Y-connected, with synchronous reactance of 2 Q and an armature resistance of 0.05 Q. Each of generators G1 , G2 , and G3 has a characteristic power-frequency slope of 4.2 MW/Hz , 4.5 MW/Hz, and 5.0 MW/Hz, respectively The no-load frequency of each generator is set to 52.4 Hz. The load increases with no changes in the settings of the no-load frequencies, until a generator reaches its maximum rated power first. At what system frequency does this limit occur? Select one: O a. fsys = 49.2 Hz O b. None O c. fsys = 48.9 Hz O d. fsys = 48.32 Hz Clear my choice
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 25.4 MVA, 60 Hz, 0.77 PF lagging, 4-poles, Y-connected, with synchronous reactance of 2 Q and an armature resistance of 0.05 Q. Each of generators G¡ , and G2 has a characteristic power-frequency slope of 5.8 MW/Hz, and no-load frequency of 62.5 Hz. Generator G3 has a characteristic power-frequency slope of 6.0 MW/Hz. Find the no-load frequency of generator G3 for which all generators supply a load of 38.5 MW, at fsys = 60 Hz. Select one: O a. fsys = 62.5 Hz O b. fsys = 61.85 Hz O c. None O d. fsys = 61.58 Hz Clear my choice