A student performed an experiment on the determination of dissolved oxygen in a water sample using the Winkler Titration Method. What is the amount of (A) dissolved oxygen and (B) oxygen in the water sample? Use the data and results recorded by the student in the table below. (A) What is the amount of dissolved oxygen in the water sample? * a) 4.0864 mg/L b)0.4085 mg/L c)2.6198 mg/L d)0.2620 mg/L (B) What is the amount of oxygen in the water sample? * a)4.0864 mg b)0.4085 mg c)2.6198 mg d)0.2620 mg

A student performed an experiment on the determination of dissolved oxygen in a water sample using the Winkler Titration Method. What is the amount of (A) dissolved oxygen and (B) oxygen in the water sample? Use the data and results recorded by the student in the table below. (A) What is the amount of dissolved oxygen in the water sample? * a) 4.0864 mg/L b)0.4085 mg/L c)2.6198 mg/L d)0.2620 mg/L (B) What is the amount of oxygen in the water sample? * a)4.0864 mg b)0.4085 mg c)2.6198 mg d)0.2620 mg

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.23QAP

See similar textbooks

Similar questions

Both AgCl and Agl dissolve in NH3.. (a) What mass of AgI dissolves in 1.0 L of 1.0 M NH3?. (b) VNhat mass of AgCl dissolves in 1.0 L of 1.0 M NH3?
Sample containing arsenic weighing 0.800 are titrated with a standard iodine soluton. what should be the normality of the iodine in order that each ml of titrant represents 1/2% As2O3 in the sample (Answer: 0.0809 N show full solution please)
2.23 gr sample taken from a bleaching powder is dissolved and completed to 250 ml. Taken from here 25One ml of sample is titrated with 33.02 ml of 0.1158 N Na2S2O3 solution after the necessary procedures. Bleachingactive chlorine in powder (OClCalculate the amount and percentage. (OCl: 51.5 g / mol)
o/index.html?deploymentld%=55750828934189288909969212&eiSBN=9781305657571&snapshotld%32199898&id%3... ☆ IDTAP Q Search this cou Use the References to access important values if needed for this question. The concentration of H3ASO3 in a solution is determined by titration with a 0.1945 M Ce+ solution. The balanced net ionic equation for the reaction is: 2Ce*(aq) + H3ASO3(aq) + 5H2O(1) 2Ce*(aq) + H3ASO4(aq) + 2H3O*(aq) (a) If 19.83 mL of the 0.1945 M Ce** solution are needed to react completely with 30.00 mL of the H3ASO3 solution, what is the concentration of the H3ASO3 solution? M (b) Which of the two solutions was in the buret during the titration? (c) Suppose at the end of the titration, the solution containing the Ce³* ion is transferred to a volumetric flask and diluted to 300. mL. What is the concentration of Ce3+In the diluted solution? Submit Answer 5 question attempts remaining
UEid- base tit ration the Consentrat ion of ammonia Solution excess HCL was titrated ith o.07om Na, cO3 Solutian. The volume of Na, Coz Solution reguired was 15.50 ml using the following eguations: 2HCLem> + Na, COgcaps CO2 Cays + HzO1) t NaCL Calculate the concentration (molarity and ppm) of ammonia in the Original Solution.(MM of NHzis 17.031.9/4) 10.0 was by of o.10OMI HCE to Then
A 10.00 mL sample containing 8.00 g/L of a mixture of KCI and NaCl was titrated with 0.10 M standard solution of AgNO3; where 5.6 mL was needed to reach the end-point. Calculate the mass of sample (in grams). 1. O0.0033 2. O0.0800 3. O0.0083 4. O0.0337
0.0585 g Na2C2O4 10 mL to adjust KMnO4 solution prepared in 0.1 M'pure water, 2 M H2SO4 added, heating process and 8.4 mL titrant as a result of titration it's spin out. Calculate the actual concentration of potassium permanganate accordingly
Fertilizer sample 1.150 g containing SO4 -2 ion is dissolved in 500ml dist. Water. 100ml of the solution was precipitated with BaCl2 solution as BaSO4 weighing 0.436 g. % mass of SO42- = ?
0.900 g KIO3 was dissolved to give a 50.00 mL Iodate solution. 35.00 mL aliquot reactedwith the iodide to form triiodide. The liberated triiodide was titrated and consumed 8.65 mL of theS2O32- solution to reach endpoint. Calculate the concentration in molarity of the Na2S2O3solution.
Determinati an 25 ml by dissolving 110n (111) per 1 This (as ml 750ml experiment Solution The to of was The a and process Q on added The portion layer taken 1 volumetric diluted Litre Colution Two These of in diluted ml soo 1% ETA of Question A. reaction an Solution 0₁ 446 9 of A. R. hydrated sulphate, (NH4) Fe (504) ₂ · 12H₂0 2 of distilled then of wertel) 0,0446 g/L of lion Absorbance was 250 ml in to ·layers frask was Is 2. 3. Was Chlore form and were 5 ml, 10 ml, 15 ml por tions 4. Iron • iron (111) four oxine it mixture the done. (111) seperatory conducted Volume SMT as 10 ml 15 ml 20 ml Plo + absorbance formed readings a (A.R) Jayer measured the por tions Solution was Water diluted out 20 ml were then Each of these mark against funnel as was after with for 8- ity droxy quinolate. follows. to iron (111) solution was prepared of then Calibration was ) 10 obtain collected. ammonium F. W-481,979 then these Absorbance 0,076 0,169 9185 0₁234. Shook. the shaking added portions…
Exp. 4 Volhard method In an experiment of determination of KBr (g%) by volhard method In a flask; 15ml KBr was taken 25 ml 0.05M AgNO3 1 ml nitric acid 1 ml ferric alum indicator Then titration with 0.05M KSCN was done The end point was =15 ml Calculate the mass of KBr in g%
A 0.5131-g sample that contains KBr (MM: 119.0023) is dissolved in 50 mL of distilled water. Titrating with 0.04614 M AgNO3 requires 25.13 mL to reach the Mohr end point. A blank titration requires 0.65 mL to reach the same end point. Report the %w/w KBr in the sample.