A steam power plant is operating on the ideal Rankine cycle. The boiler is maintained at 4 MPa, and the condenser at 40 kPa. The steam quality leaving the turbine is at 90%. a.) Draw the proper T-S diagram of the cycle with proper label for the points. b.) Find the temperature of the steam entering the turbine, Qa, Qr, Wt, Wp, Wnet, efficiency, and steam rate

A steam power plant is operating on the ideal Rankine cycle. The boiler is maintained at 4 MPa, and the condenser at 40 kPa. The steam quality leaving the turbine is at 90%. a.) Draw the proper T-S diagram of the cycle with proper label for the points. b.) Find the temperature of the steam entering the turbine, Qa, Qr, Wt, Wp, Wnet, efficiency, and steam rate

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Show the COMPLETE SOLUTIONS and DIAGRAM (T-s) (Cycle) including the switching of table and interpolations/extrapolations: NO Calculator Technique and Applications. A smaller power plant produces 25 kg/s steam at 3 MPa, 600o C in the boiler. It cools the condenser with ocean water so the condenser exit is at 45o C. There is a reheat done at 500 kPa up to 400o C and then expansion in the low-pressure turbine. Find the net power output and the total heat transfer in the boiler.
Thank you
Q.8 In a regenerative steam cycle employing one open feed heater, the steam is supplied to the turbine as dry saturated at 40 bar, and exhausted to the condenser at 0.35 bar. The intermediate bleed pressure is 10 bar. Sketch the layout of the plant and show on the temp | entropy diagram the pressure under gone by the steam, neglecting the pump works, calculate: A. The mass of steam bled from the turbine per Kg of steam leaving the boiler. B. The thermal efficiency of the plant. C. The thermal efficiency of the plant without feed heating. D. The heat rate in (kJ/kW.hr) for the plant with and without feed heating.
Plz help me determine the rankine cycle Or can someone do the rankine cycle on this and how this works
An Actual Rankine cycle operates on a boiler and condenser pressure of 2MPa and 20kPa respectively. Steam leaves the boiler at 500C. Steam flows at a rate of 10kg/s in the cycle. The Turbine and Pump Efficiency are provided to be 87% and 89% respectively. a.) Determine the Heat Added to the boiler (kJ/s) b.) Determine the Work done by the pump (kJ/kg) c.) Determine the Thermal Efficiency of the Cycle (%) ROUND OFF ANSWER TO SIX SIGNIFICANT FIGURES PLS USE THE GIVEN VALUES THAT IS HIGHLIGHTED IN THE IMAGE OF THE STEAM TABLE AND SUPERHEATED TABLE PLSS USE THIS VALUES
Given in Table are the pressure and temperature of the steam as it enters the turbine as well as the pressure in the condenser. The given engine operates on a simple ideal Rankine cycle, calculate the unknowns in Table. Show solution Rankine Pressure of Temperature Pressure at the Net work Heat Thermal entering the Efficiency (n) in % the steam entering the entering the condenser system (WN) boiler (Qin) turbine (Rx) turbine (t+) in MPa Engine of the steam done by the in KJ/kg in KJ/kg (Pe) in kPa in °C A 3 350 75
In a steam power plant operating according to the simple ideal Rankine cycle, steam enters the turbine at 10 MPa pressure and 600 ° C temperature and condenses at 30 kPa pressure. The isentropic efficiency of the turbine and the pump is 90%, the steam flow circulating in the cycle is 25 kg s. a) The power generated in the cycle, b) The heat thrown into the environment in the condenser c) Calculate the thermal efficiency.
DRAW DIAGRAM In a SIMPLERankine cycle, the steam throttled condition is 8 MPa and 480°C. The steam is then reheated to 2 MPa and 460 °C. If turbine exhaust is 60 °C, determine the following:a. Heat Addedb. Turbine Workc. Heat Rejectedd. Pump Worke. Net Workf. Efficiency
Note : similar problem is already solved on bartleby.You can take help from there. Assume ideal and the inlet of pump is saturated liquid.
Thermodynamics II
Consider a vapor compression refrigeration cycle working with R134a circulating at a flowrate of 90 kg/s. Compressor inlet is saturated vapor at 140 kPa and exits at 1200 kPa and 80oC.Condenser exit is 44oC. Find:a) Draw T-s and P-h diagrams and schematic block diagram of the cycleb) Compressor work inputc) Refrigeration capacityd) Isentropic efficiency of the compressore) 2nd law efficiency of this cycle
Find the thermal efficiency of the system in percentage to 2.d.p.