A solid circular shaft has a uniform diameter of 0.0508 m and is 3.048 m long. At its midpoint, 65 hp is delivered to the shaft by means of a belt passing over a pulley. This power is used to drive two machines, one at the left end of the shaft consuming 25 hp and one at the right end consuming 40 hp. The shaft turns at 200 rev/min, then the maximum shear stress (in MPa, correct upto two decimal places) developed in the shaft will be [Take G = 82.74 GPa and assume elastic action]

A solid circular shaft has a uniform diameter of 0.0508 m and is 3.048 m long. At its midpoint, 65 hp is delivered to the shaft by means of a belt passing over a pulley. This power is used to drive two machines, one at the left end of the shaft consuming 25 hp and one at the right end consuming 40 hp. The shaft turns at 200 rev/min, then the maximum shear stress (in MPa, correct upto two decimal places) developed in the shaft will be [Take G = 82.74 GPa and assume elastic action]

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

What is the maximum Moment for the whole structure?
The 5 ft diameter cylinder weighs 5000 lbs. and is 5 ft long as shown.compute the horizontal reaction at A (in lb)
Problem 6 Two cables of the same gauge are attached to a transmission tower at B. Because the tower is slender, the horizontal component of the resultant of the forces exerted by the cables at B is to be zero. Knowing that the mass per unit length of the cables is 0.4 kg/m, determine (a) the required sag h, (b) the maximum tension in each cable. -90 m- A h B 60 m → 3 m Figure Problem 6 с
I need the answer as soon as possible
A hollow shaft of external and internal diameter as 100 mm and 40 mm respectively is transmitting power at 120 rpm. If the shearing stress is not to exceed 50 MPa, the power the shaft can transmit will be