A small stream is of rectangular cross section. At a certain section it divides itself, encloses an island and then re-joins to form a single channel again. The properties of the two paths past the island are as follows: At a short distance downstream of the confluence the discharge is found to be 160 m3 /s and depth of flow of 4 m. Find the discharge in each channel and the depth of flow at the point of division. Neglect the energy loss at the division and at the confluenc

Q: The discharge in m^3/s for laminar flow through a pipe of diameter 0.05 m having a centre line…

A:

Q: Note:hand written solution should be avoided.

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: Water flows under a sluice gate in a horizontal rectangular channel of 2 m wide. If the depths of…

A: In this problem, we are asked to calculate the discharge of water flowing under a sluice gate in a…

Q: Example A submerged sharp crested weir 0.81 m high stands clear across a channel having vertical…

A:

Q: Two reservoirs are connected by two pipes P and Q. The pipes have the same diameter and length and…

A: Given data: Two reservoirs are connected in parallel by two pipes P and Q. Friction factor of P is 9…

Q: 8.4 The storage-elevation-discharge Elevation (m) Discharge (m³/s) Storage (10 m³) characteristic of…

A:

Q: lar channel one metr . The 300 bed slope al

A: Given data-  Discharge (Q) =  1 m³/s  Width of rectangular channel (B) = 1m  Depth of rectangular…

Q: Water Resource Engineering: Open Channel Flow For a triangular channel, the top width, T is given…

A: Given data: Calculating critical depth using the given relation: Given relation:

Q: For the two-dimensional flow system shown below (units in meters):Compute the total flow rate under…

A: From the flow net, the number of flow channels is 3 and the number drops is 10. Given, x = 4; y = 8

Q: A reservoir A contains water at an elevation of 45 m. and a 50 mm pipe line leads downhill from the…

A:

Q: luid mechanics

A: Given That,  Discharge = 25 m3/s width = 4 m Deapth = 1.2 m maninngs n = 0.012

Q: Uniform flows occur in a 10 meter wide rectangle channel. The flow in the channel is 18.4 m³/s and…

A: Minimum Specific Energy of flow is given by ; Emin Emin = 1.5  *  yc Where ; yc = (q2g)13

Q: 5.30 A line source of strength 15x m/s is situated within a uniform stream flowing at -12 m/s (i.e.…

A:

Q: servoirs A, B and C, respectively, and meet at junction D. The elevation of A is 300 m while that of…

A: Given  Discharge through pipe 2 = 560 l/s

Q: 8 m³/s discharge flows through 4 m wide rectangular channel at a velocity of 2 m/s. The hydraulic…

A:

Q: 9.4. A small farm reservoir behaves as two identical CFSTRs in series. Flow into the reservoir…

A: Given,Influent BOD, C0=50 g/m3Flow rate, Q=0.5 m3/sVolume of reserviour, V=2.16×106 m3k=0.2…

Q: Q/A small resarvoir has a spillway with the Following relationship

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: A Im wide rectangular channel carries a discharge of 2m³/s. The specific energy-depth diagram is…

A: Given- 1 m wide rectangular channel Discharge Q = 2 m3/s, Subcritical depth is twice the…

Q: A cippoletti weir having L=1.25m maintains its head at 250mm, determine the flow in cu.m per second…

A:

Q: A 1 m wide rectangular channel carries 3 a discharge of 2m/s. The specific energy-depth diagram is…

A: given -  Critical depth = 2 X supercritical depth . y = supercritical depth. Subcritical depth = 2y.…

Q: A 170-m long pipeline, composed of two pipes connected in series, discharges freely at a point 40 m…

A: The total loss in the pipeline for the given question is given by: hL=hentrance+hsudden…

Q: A rectangular channel (n=0.011) 18 m wide to carry water at a flow rate of 35 m³/s. The slipe of the…

A: Given data in question  Constant value Width Discharge  Slope To find out Critical depth Specific…

Q: A 10 m wide rectangular channel carries a discharge of 20 m³/s under critical condition. Using g=…

A:

Q: A steep wide rectangular channel takes off from a reservoir having an elevation of 101.2 m. At the…

A:

Q: A hydrogen generation facility is proposed 5km west of an existing steel mill in downtown Hamilton.…

A: Apply concept of specific energy. Specific energy before hump and after hump will be equal

Q: A submerged sharp crested weir 0.81 m high stands clear across a channel having vertical sides and…

A:

Q: A trapezoidal channel has a bottom width of 6 m and side slope of 1:1. The depth of flow is 2 m at a…

A:

Q: A trapezoidal channel has a bottom width of 6m and side slope of 1:1. The depth of flow is 2m at a…

A: Bottom width = 6 mside slope = 1:1Depth of flow = 2 mDischarge = 24 m3/secTo find :Specific energy ?

Q: A steep wide rectangular channel takes off from a reservoir having an elevation of 101.2 m. At the…

A:

Q: Water flows in a clean and straight natural channel of rectangular cross section with a bottom width…

A:

Q: 8 m³/s discharge flows through 4 m wide rectangular channel at a velocity of 2 m/s. The hydraulic…

A: Given:- Discharge, Q=8 m3/sWidth of rectangular channel, w=4 mVelocity, V=2 m/s To find:- Hydraulic…

Q: Three reservoirs A, B and C at water levels of 25 m, 12 m and 8 m are connected by a pipe network.…

A: Given: Three reservoirs Pipe diameter Pipe length Friction factor To find: Direction of flow Flow…

Q: A 170-m long pipeline, composed of two pipes connected in series, discharges freely at a point 40 m…

A:

Q: In a triangular channel, the velocity along the centre line at a depth of 0.2 m and 0.8 m is 0.7 m/s…

A: Given data: Velocity at depth of 0.2 m, V0.2 = 0.7 m/s Velocity at depth of 0.8 m, V0.8 = 0.5 m/s…

Q: The three reservoirs, A, B and C are connected by pipelines A, B and C respectively which meets at…

A:

Q: EL 83 m EL 80 m D 15 m

A:

Q: Example 12.3. A small reservoir has a spillway crest elevation 200.0 m. Above this elevation, the…

A: Elevation of spillway =200.00 m Storage: S=36000+18000y (m3) Outflow: Q=10y (m3/s) Assume the…

Q: For a 2-D flow field, the stream function y 3 is given as y = (y²-x²). 2 The magnitude of discharge…

A:

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.