A single phase half-wave AC voltage controller provides output RMS voltage of 50V when the triggering angle (a) is 90°. For the same a, what is the output RMS voltage if the AC voltage controller changed to full-wave type.

A single phase half-wave AC voltage controller provides output RMS voltage of 50V when the triggering angle (a) is 90°. For the same a, what is the output RMS voltage if the AC voltage controller changed to full-wave type.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What is the rms voltage output value of the ac component in a half-wave rectifier when the peak…

A: Peak voltage of half wave rectifier

Q: What is the working principle of a half wave controlled three phase rectifier

A: Rectifier:- An electronic device called a rectifier uses one or more P-N junction diodes to change…

Q: Example 35: A full wave rectifier used 220V, with firing angle 10" ,total resistance load S KO,…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Suppose an analog meter is used to test a diode. What should the meter read for both connections of…

A: Analog meter generally used to check the condition of the diode, Such analog meter actually measures…

Q: The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 0.2…

A: Given displayed waveform, The time/cm switch is set to 0.2 ms/cm (X- axis) The volt/cm switch is…

Q: A center tapped full-wave rectifier circuit has the following specifications: ac supply line is 120…

A: primary supply voltage is 120 V. Nothing is mentioned about the primary side voltage of the…

Q: If a half-wave rectifier is used with 220-V rms ac (house mains in PH), the average dc output…

A: The solution is given below

Q: Compute the dc load current of a SCR half-wave control circuit if the firing angle is 36 degree.…

A: In this question we will find average load current of half wave controlled rectifier...

Q: Comparing the performance with controlled rectifier circuit which one of the following statement is…

A: DC to DC converters are known as choppers.

Q: In the full-wave rectifier circuit of figure 12, the transformer has a turns ratio of 1:2. The…

Q: If the frequency of AC signal generator is 60Hz, what is the frequency of full-wave rectifier…

A: Given: The frequency of the AC input signal is f=60 Hz

Q: Q2 A full-wave controlled supplying 3k load that operate at 9 V. The input rms voltage is 110 V and…

A: For full-wave controlled rectifier Vdc=Vmπ(1+cosα) Vrms=Vm 12-α2π+sin2α4π

Q: A single phase half wave uncontrolled rectifier with R load is supplied by an AC source of 230…

A: Last option is correct. The explanation is provided below.

Q: 3. What is the disadvantage of ripple voltage (Peak-Peak) in DC Supply on the electronic instruments…

A: Ripple voltage is an unwanted SC components in a electronic equipments workin on DC supply. This…

Q: What is the rms voltage output value of the ac component in a half-wave rectifier when the peak…

A: Peak voltage of the wave, Vp= 1200Volts

Q: single phase half wave uncontrolled rectifier with R load is supplied by an AC sourd rerage output…

Q: A half-wave rectifier with a reservoir capacitor is connected to an AC mains supply (220Vrms, 50Hz)…

A: given

Q: 38. The single-phase ac center-tap full-wave rectifier input voltage is 230 V (rms). Determine the…

Q: QI: For a single-phase full bridge-controlled rectifier. The input supply voltage 220 V. 50 Hz, the…

Q: 2 a) Name of the Circuit? (Assume Silicon Diodes) 4:1 D b) Find the peak input voltage to the 120 V…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: one of the following is point is not of a LED characteristic ? O Low operational voltage O Fast…

A: In this question we will write about LEDs and clamper circuit....

Q: A half-wave rectifier circuit has the following specifications: ac supply line is 120 volts, load…

A: A Half-bridge rectifier is an AC to DC converter. single-phase HWR converts AC voltage into…

Q: A certain unfiltered center-tapped full wave rectifier is powered by a 120 Vrms ac power system and…

A: The solution is given below

Q: Draw a reference three phase input signal, the output voltage and current waveform of a three phase…

A: Three Phase Six pulse converter: Assume that load has high inductanceSo, io is constant.Average…

Q: What is the peak output voltage of a three phase three pulse rectifier operating on a line to line…

Q: If 50 Hz input ac signal is applied at the input of a half wave rectifier, then what will be the…

A: Given, 50 Hz input ac signal is applied at the input of a half wave rectifier. Waveform of Half wave…

Q: Question- Find the voltage ripple factor if An SCR rectifier circuit is designed such that the…

A: Given- An SCR rectifier circuit- Average output voltage V=77.64 V, RMS value of output voltage…

Q: Suppose a square wave signal has a 86 percent duty cycle and an on-state voltage of 24 volts DC.…

A: We need to find out average value for given waveform .

Q: Q1: The chopper circuit shown in Figure (1-a), delivered by 12 volts, the produced average load…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question.

Q: determine :- Ex₂ : (How) A Single-phase Full wave Ac Voltage & Remove Watermark No below, has a…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: The average dc voltage of a half wave rectifier circuit is _______ of the value of the peak input…

A: Rectifier converts the input AC signal to DC signal.

Q: In the adjacent figure, what is the continuous load voltage? What is the magnitude of the continuous…

Q: What happens to the diodes if one of them is short in the bridge rectifier?

A: Consider the bridge rectifier as,Here, during the positive half cycle, the current flows as,Here,…

Q: A single phase half wave uncontrolled rectifier with R load is supplied by an AC source of 230…

A: We need to calculate average output voltage , we know formula for average output voltage for half…

Q: Figure 3 illustrates a thyristor phase control circuit and associated waveforms. Describe the…

A: Thyristor:- It is a four-layer power electronics device. A gate, a cathode, and an anode are the…

Question

A single phase half-wave AC voltage controller provides output RMS voltage of
50V when the triggering angle (a) is 90°. For the same a, what is the output RMS
voltage if the AC voltage controller changed to full-wave type.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

i need the answer quickly
What is the peak output voltage of a three phase three pulse rectifier operating on a line to line voltage ‘X’ V? (Here X= 28)
What is the angle at which the thyristor operates as a diode in a unified half-wave three-phase controller?
The output rms ripple voltage of a fullwave rectifier circuit if the input voltage maximum is 81 V?
A three-phase half wave control rectifier is operated from 3-phase source 230 V, 50 HZ (supply) with load resistance R = 10 22. An average output voltage of 50% of the maximum possible output voltage is required. Determine a) firing angle, b) average and rms value of load current, and c) the efficiency.
The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 0.5 ms/cm, and the 'volts/cm' switch is set to 0.2 V/cm. Determine the (i) amplitude of waveform Q, (ii) peak to peak value of waveform P, (iii) frequency of waveform P and (iv) phase angle difference between P and Q in Degrees. Upload your Answers steps in the "Final Answer Submission" Link provided in the Moodle. (i) Amplitude of waveform Q = (ii) Peak to peak value of waveform P = (iii) Frequency of waveform P =
Comparing the performance with controlled rectifier circuit which one of the following statement is correct for DC -DC chopper ? a. Switching frequency is not responsible for output ripples b. small filters are required c. Regenerative braking process is very slow d. Efficiency is poor in chopper circuit
Q4 / three phase half wave controlled rectifier is used to feed a resistor load of ( 10 ohm) the source is (208 volt) star connected: calculate: 1- The average value of the voltage and current on the terminal load if angle (45). 2- The average of the voltage on the terminal load if angle (80). 3- The angle required to get 7 amp. 4- Draw the circuit.
What is the action of a capacitor in a Power Supply Circuit?* a. To de-couple DC component of the rectified AC input b. To increase the DC component of the output wave. c. To remove DC component of the AC wave. d. None of the above.
Please, in 10 minutes. Will be very THANKFUL. A single-phase half-wave thyristor control is desired to be designed in such a way that a rectifier can provide an average load current of “1.6” Ampere to an ohmic load. “240”Volts, an output voltage of “83”Volts is formed for 50Hz mains supply voltage. According to these given values: a-) Draw a single line diagram of the circuit to be designed? b-) Calculate the trigger angle α? c-) calculate the rms voltage on the load? d-) Calculate the rms current on the load? e-) Calculate the output dc power?
Please answer this,I want a detailed explanation. An a.c. supply drives a half-controlled thyristor bridge with a resistive load. Sketch the circuit diagram, and the voltage and current waveforms.
What is the maximum operating period for AC voltage regulators?