A short circuited stub is shunt connected to a transmission line as shown in the figure is, if Zo = 500 ohms, the admittance y seen at the function of the stub and the transmission line is Zo Zo 1/2 ZL= 100 ohms

Q: A given signal f (1)

A:

Q: Q6) Find the following: 2. Simplify using Boolean algebra and DeMorgan's theorem y=(ABC XABC) 3.…

A: We need to find out the simplified Boolean expression for given function by using of de Morgan…

Q: 3 only

A:

Q: Q4) Find the following: A. (1100); × (101): B. (1101); + (101); C. (10011000) acD+ (10010111)BCD

A: Note: We are authorized to answer the first three sub-parts at a time, so we are answering the first…

Q: 2. Using source transformation, find ix. +1 100V (+) 50 M 105 12A dix 852 M 452 + 1641

A:

Q: Example 1.1. A lead acid battery fitted in a truck develops 24V and has an internal resistance of…

A: Given : Generated voltage, Eg= 24V Internal Resistance, Ri =0.01Ω Power supplied 100 watt

Q: What is the period of a clock waveform that has a frequency of 15.4 kHz? A. 649 με Β. 6.49 με C.…

A: Given: A clock waveform has a frequency, f=15.4 kHz.

Q: Q5. Determine if the following circuit is in saturation. Assume VCE(sat) = 0.2 V. VBB 4 V +1₁ RB www…

A: Considering the circuit.   VCEsat=0.2 V

Q: 10. There are two alternators, 100kW, 3-phase in parallel are driven by shunt motors whose…

A:

Q: Calculate the missing values in the table. Round all values to the nearest whole number when…

A: We need to find out number of turns and voltage for given transformer . We know transformer ratio ,…

Q: A signal generator having a source resistance of 50 2 is set to generate a 1 kHz. sinewave. Open…

A: Given data, Resistance Rs=50 Ω Voltage, Vs=10 VV0=8 V Frequency ω=103  Hz

Q: FOR THE CIRMIT SHOWN, (a) WHAT VALUE OF Vg Is REQUIRED IN ORDER FOR THE INTER CONNECTION TO BE…

A:

Q: An electric motor with a maximum output of 75 hp (horse power, English: hp, horse power) on the axle…

A: Given data, Motor:-1 Power P1=45 HP Efficiency,  η1=91%=0.91 Motor:-2 Power  P2=75 HP Efficiency,…

Q: Consider the following assembly language program. MVI B,87H MOV A,B START: JMP NEXT MVI B,00H XRA B…

A: Solution is priortize in 8085

Q: Find v and i using nodal analysis. 21 V (+ Μ 4 Ω 3 Ω + | 9V 2Ω 6Ω

A:

Q: The maximum efficiency of a 100 kVA, 1100/440 V 50 Hz transformer is 96%. This occurs at 75% of full…

A: Given- Maximum efficiency, η=0.96 , Voltage = 100 kVA , Frequency, f = 50 Hz , Power factor,…

Q: A complex voltage wave is given by v = 200 sin 100лt + 80 sin 300nt + 40 sin 500nt volts. Determine…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: Given Using the Fourier inverse transform inverse g(t) = ? O a. O b. О с. O d. G (w) = 28 (w-50) + 8…

A: In this question,  We need to choose the correct options What is inverse Fourier transform of the…

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistanc to be used is…

A:

Q: 4. Determine V₁ and V₂ using nodal analysis. Show complete solution using either elimination or…

A:

Q: 3. Determine all the mesh currents using mesh analysis. Show simplified equations and complete…

A: The given circuit diagram is shown below:

Q: 5. Write an assembly language program to convert an 8-bit binary data to BCD. The binary data is…

A: Solution !!

Q: Q4) Find the following: A. (1100): x (101): B. (1101); +(101); C. (10011000) BCD + (10010111)BCD D.…

A:

Q: More Circuit Diagram Building Build the following: +5V 100 0 # Build the following 3 times, but add…

A: According to the question, we need to explain the operation of the circuit, and design new circuit…

Q: The conductors of a three-phase transmission line are arranged in the form of an equilateral…

A:

Q: Using K-Map, design a logic circuit whose output is high only when majority of inputs A, B, and C…

A: We need to design the given circuit by given condition by using of k map .

Q: If V₁ = 17 V₁ V₂ = 5 V and V3 = -7 V, the voltage Vo (in volts) is + V/₁- Vo O-29 015 O-15 O-19 029…

A:

Q: When operating at a frequency of 2 kHz, a cable has an attenuation of 0.25 Np/km and a phase shift…

A:

Q: Obtain a Fourier series for the periodic function f(x) defined as: -k, when - < x < 0 0<x<π f(x) =…

A:

Q: 1.Determine vo(t) in the circuit, assuming zero initial conditions IH 10(0) V

A: Since only question 1 has been asked, so I am answering 1st question. Given: A circuit with current…

Q: - Three phase induction motor has rating of 50 kW, 960 rpm, 400 V. 50 Hz, 6-pole. The motor…

A: The polarity of the back EMF and armature voltage is not the opposite. As a result, the armature…

Q: The content must be the connection of resistor color codes to tolerances and the relationship of the…

A: According to the question, for the given resistor color code and measurements as shown below, We…

Q: 88. An AM transmitter is rated 100 W at 100% modulation. How much power is required for the carrier?

A: Given: An AM transmitter is rated at, Total power, PT=100 W. Modulation index, μ=100%=1.

Q: A 240 V, 60 Hz parallel circuit supplies three branches. Branch 1 consists of a noninductive heating…

A: Note: We are authorized to answer upto three subparts only, kindly repost your question for other…

Q: Explain the basics of Double sideband supressed carrier signal and it's application. (Where it is…

A:

Q: Find the given signal's f(t) = 2cost power or energy

A:

Q: & M 12 tt ¾ 4 G 13

A: Given:

Q: d A given system y(t) − 2—y(t) = x(t) +3—x(t), it is (choose all the correct choise dt dt linear…

A: A system is called a linear system if it follows the law of homogeneity and the law of additivity.…

Q: Find the impedance, Z, shown in Fig.. of 60 Hz. Z 10 mH ww 1Ω 202 M 10 μF at a frequency

A: Given that: A circuit is shown below. L=10 mH, C=10 μF. f=60 Hz find the impedance Z.

Q: 2. Given points P(1.-3.5), Q(2,4,6), and R(0,3,8), find: (a) The position vectors of P and R (b) The…

A:

Q: etermine the electrical force of attraction between two balloons with separate charges of +3.5 x 10…

A: Charges can be positive and negative. In electrostatic the charges are in rest. The force between…

Q: its making current

A:

Q: R 11 Vo C+ L Vout This band-pass filter has R = 100 kOhms, C = 0.010 microF, and L = 2.2 mH. At time…

A:

Q: Write the corresponding differential equation for the given transfer function. X(s) S+2 2 F(s) s³…

A: We need to find out differential equation for given transfer function by using of inverse Laplace…

Q: Us R₁ Rin Vcc J • R2 www R3 41. Vcc 오 °」 RA Rout 41. R5 41. Vo

A:

Q: Solve the following. Show complete solution, resistor combination and circuit transformation. Box…

A: We need to find out the current and resistance for given circuit . We will do star to delta…

Q: why is 2.8 in V instead of A?

A: SI unit: a measurement unit that is a member of system used globally for scientific &amp; technical…

Q: Determine the equivalent impedance of the network shown in Fig. 8.10 if the frequency is f = 60 Hz.…

A:

Q: Calculate the equivalent impedance of a circuit in which a coil of wire having a value of 5∠53.2ºohm…

A:

Q: 1. 2 3. 20 1505 4, 8 80 50 60 10 50 но ,200. 30 60 Is SV 4. 16 -25 2 V 20 ·16 25 30 60 M7 120 100 M…

A: This is a basic problem of circuit. The above problem can be solved by using nodal analysis which is…

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.