A series combination of resistance of 4 , an inductance of 0.5 Henry and a variable capacitance connected across 100 V ,50 Hz supply. Calculate a) the capacitance to give resonance b) the voltage across inductance and capacitance.

A series combination of resistance of 4 , an inductance of 0.5 Henry and a variable capacitance connected across 100 V ,50 Hz supply. Calculate a) the capacitance to give resonance b) the voltage across inductance and capacitance.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Q1: A. Write down the measured capacitance on your bench C1 Figure.1 (Don't select the same values).…

A: Since you have asked multiple question and not specified which one to answer I will answer the first…

Q: What will happen to the value of the current if the capacitance will be increased or decreased?…

A: The solution is given below

Q: What is the value of capacitance if the capacitive reactance is 50 Q .Assume frequency of supply as…

A: In this question we will find capacitance..

Q: 2.A series R -L-C circuit is to be made resonance when connected to a 200 – volt 500 cycle source.…

Q: For 3-phase unsymmetrical spacing shown in figure (the diameter is I cm).: Find the capacitance per…

A: Given, For 3-phase unsymmetrical spacing shown in figure,

Q: What is the technical methot of measuring capacitance?

A: The inductor and capacitor are the energy storing elements. They keep on exchanging energies between…

Q: 5. How does a capacitor work, and what is its purpose in an AC circuit? 6. In an AC circuit, Ohun's…

A: AC circuit is nothing but a circuit using alternating current, the magnitude and the direction of an…

Q: What is the impedance of purely inductive circuit at a frequency value approaching to zero?

Q: Why the magnitude of the voltage across the capacitor is many times larger than the source voltage…

Q: What is specifice capacitance?

Q: What is the fundamental purpose of a capacitor?

A: Capacitor- It is a electrical passive two-terminal component which will save electrical energy in an…

Q: Both the number of turns and the core length of an inductive coil are double. Its . . self…

A: It is given that: The number of turns and the core length of an inductive coil are doubled.

Q: shunt

A: In this question, we have to find out which element accounts for losses due to leakage current...

Q: Prove that, neutral capacitance is twice of line to line capacitance

A: The capacitance between one of the conductors and a neutral point is known as neutral capacitance or…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: Clipper Circuits:- A clipper circuit is used to clip the input voltage at a fixed higher and lower…

Q: - (a) Considering pure inductance in an ac cireuit element, show that the alternating current lags…

A: Given Pure inductance in an accident circuit.

Q: C= luF ZUF (3 = 3uF

Q: how does the measured value of phase angle compare to the theortical value for an inductor?

A: Given To compare the phase angle of inductor between theortical and practical values.

Q: Number 13 and 14

A: (13) If the film-type capacitor has the rating as a 3-digit number, the first two digits represent…

Q: What is the total capacitance of a 0.005-uF, 10-nF, and 2000-pF capacitor in series?

A: When capacitances are in series for example , then equivalent or total capacitance is . Given that…

Q: concept of pure inductive circuit

A: Given: Pure inductive circuit

Q: A 200-0 resistor is connected in series with a 3.25-uF capacitor. The voltage across the resistor is…

A: Given data:-R=200 ohmC=3.32μFω=1902 rad/sFind Xc=?

Q: An A.C Bridge as shown in the figure is used to measure unknown inductance L1. in companion with…

A: For the given AC bridge at the balance condition, the expression is given as:

Q: what is meant by capacitor leakage, and what part of the capacitor contributes to how much leakage a…

A: Capacitance depends on Area between plates Distance between plates Types of dielectric material…

Q: Q. 14. At high frequencies, the shunt resistors used for current measurement will have a higher…

A: To measure either alternating or direct electric current, a shunt resistor is employed. By measuring…

Q: What is the equation thst represents the relationship between charge, capacitance and voltage for a…

A: Q=CV

Q: give definition and explanation about Capacitance meter

A: According to the given question, it is required to define and explain a capacitance meter. The…

Q: A capacitor (C) is connected in series with a (400) resistor across a supply of frequency (60HZ). A…

A: According to guidelines we need to solve only the first three sub-parts. According to the question…

Q: Q6. Explain why an a.c capacitor that is working in an a.c circuit will get hot, whereas a d.c…

A: AC Capacitor in an AC CircuitReactive Power: Each cycle of AC voltage causes the capacitor to absorb…

Q: 3.The capacitor having a platearea of o.1m? the istance between plate is o6Mm end the dielectrie…

A: For parallel plate capacitor capacitance=εo×εr×Ad where A is area of plates d is…

Q: 5. Explain the phase difference between pure resistor, pure inductor and pure capacitor circuit in…

Q: Explain the phase difference between pure resistor, pure inductor and pure capacitor circuit in…

A: 1. Pure Resistive circuit In an AC circuit, the ratio of voltage to current depends upon the supply…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A series combination of resistance of 4 , an inductance of 0.5
Henry and a variable capacitance connected across 100 V,50 Hz
supply. Calculate a) the capacitance to give resonance b) the voltage
across inductance and capacitance.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the importance of resistor, multimeter, and capacitor? How can we apply its importance to the future?
R 1. Measure the internal resistance of the 1mH inductor. Set up the given circuit with R = 270n and L = 1mH. Apply a sinusoidal voltage as input. Adjust V, = 4Vpp and set the frequency as 20kHz. Observe the input voltage and the V, L voltage across the inductor simultaneously using an ocilloscope and plot both signals. Find the phase difference between these signals and comment on the results.
.A series RLC circuit contains a 4-kN resistor, an inductor with an inductive reactance (X,) of 3.5 kn, and a capacitor with a capacitive reactance (Xc) of 2.4 kN. A 120-Vac, 60-Hz power source is connected to the circuit. How much voltage is dropped across the inductor?
When is the capacitive reactance (Xc) greater? a) If the capacitance is higher and the supply frequency is lower b) If the capacitance and supply frequency are lower C)If the capacitance and supply frequency are higher d) If the capacitance and supply frequency are higher
d) Determine the total inductance for the connection shown in Figure 5.1 below. vor L4 6mH mon 8mH Figure 5.1 8mH
.i. In a parallel plate capacitor, the cross sectional area of the plates are doubled and all other parameters remains the same. The ratio of Final capacitance to initial capacitance is found to be: