A sand bottom in seawater is characterized by p₂ = 1700 kg/m³ and C₂ = 1600 m/s. (a) What is the critical angle of incidence corresponding to total reflection? (b) For what angle of incidence is the power reflection coefficient equal to 0.25? (c) What is the power reflection coefficient for normal incidence?

A sand bottom in seawater is characterized by p₂ = 1700 kg/m³ and C₂ = 1600 m/s. (a) What is the critical angle of incidence corresponding to total reflection? (b) For what angle of incidence is the power reflection coefficient equal to 0.25? (c) What is the power reflection coefficient for normal incidence?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

6. Does the volume of the cavity exceed 50% of the total volume of the block?
Earth absorbs solar energy and radiates infrared energy. The intensity of the solar radiation incident on earth is J = 1350 Wm-2, also known as the solar constant. Assume earth’s surface (ground) temperature to be uniform at Ts, and that the ground and atmosphere are black (emissivity = 1) for infrared radiation. The radius of the earth is 6.378 x 106 m. The diagram shows the ground at the surface temperature Ts and the atmosphere, represented as a thin black layer, at temperature Ta . Suppose the atmosphere absorbs 100% of the infrared radiation emitted by the ground. Assume that the ground absorbs 47.5% of the incident solar energy, and that the atmosphere absorbs 17.5% of the incident solar energy (for a total of 65% absorbed by the planet). Calculate the "steady state” numerical values of the earth’s ground temperature Ts and the atmospheric temperature Ta taking into account the “greenhouse effect” of atmospheric infrared absorption and emission described above.
A solar car has a roof dimensions of 116cm x 102cm for solar cells . Calculate the electrical power available, assuming total energy loss of 79% and a constant light intensity of 972 W/ m?. Answer:
Assume a layer of fluid 2 separates fluid 1 from fluid 3. (a) Compare the pressure reflection coefficient for a plane wave traveling in fluid 1 that reflects normally from the layer with that for a plane wave traveling in fluid 3 that reflects normally from the layer. (b) Are the pressure reflection coefficients the same for the two cases? (c) Repeat (a) and (b) for the power reflection and transmission coefficients. (d) What do these results suggest in terms of energy transmission?
1. A glass window allows 95% of radiant energy between 0.32 < 1 < 2.6 microns to pass. Any wavelength outside of this range will not pass through the glass. Compute the energy rate passed through the glass window if the incident energy rate on the glass is 1200 W/m^2. 0.9 0.4 E0-a ot 0.4 0.2 0.1 15,000 AT(Micron-Rankine) S000 10,000 20.000 25,000 30,000 33,000 00 1.0 2.0 3.0 4.0 5.0 6.0 7.0 Amax Ans. 1026 W/m^2
A small 100 cd spring is located in the center of a spherical mirror with a diameter of 10 cm and a focal length of 50 cm. Assuming that the total reflectance is about 80%, obtain the average brightness of the parallel beam reflected from the mirror.
Please don't provide handwritten solution
You have stated that the convective area is πr^2. Please explain this. πr^2 is the area for a circle, not a sphere. It should be 4πr^2 as this is equal to the surface area of the sphere as you have done correctly in the radiative area. A conv= 4πr^2*3*293-292 = 0.377 A rad = 4πr^2*0.2*5.67x10^-8*(292^4-291^4) = 0.144 I have tried to multiply the convective area by 4πr^2 instead of πr^2 but it is giving me an incorrect total heat transfer rate of 0.377+0.144 = 0.521 the correct answer is supposed to be 0.236
29. Gamma radiation is bombarding an iron plate as shown in the figure. A con- vection boundary condition of T;= 150 C and h = 200 W/m-K removes heat from the plate. Find the maximum temperature and its location in the plate. Also find temperature at 1 cm from the side facing irradiation and the rate of heat removal from the side not being irradiated. k= 48.5 kW/m K, µ= 24.6 m'. Questions and Problems 507 40 = 19,600 kW/m³ 15 cm T, = 150 C h= 200 W/m K T = 150 C h= 200 W/m K