A rigid container with volume of 200 L is divided by a partition resulting to two equal volumes A and B. Volume A has air at 2 MPa, 300°C while Volume B has air at 1 MPa, 60°C. The partition was then removed, and the air comes to a final uniform state at 110°C. Assuming that the ambient temperature is 25°C, and that specific heats are constants, determine:

A rigid container with volume of 200 L is divided by a partition resulting to two equal volumes A and B. Volume A has air at 2 MPa, 300°C while Volume B has air at 1 MPa, 60°C. The partition was then removed, and the air comes to a final uniform state at 110°C. Assuming that the ambient temperature is 25°C, and that specific heats are constants, determine:

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A-C line Liquid R-134a A rigid container containing 6.6 kg of saturated liquid R-134a at 24°C is used to fill an air-conditioning system. A valve is opened and allows liquid R-134a to escape the tank into the A-C line until only 0.49 kg of R-134a remains in the tank, at which point the valve is closed. During the process, heat transfer is allowed to occur to maintain the tank temperature at 24°C. What is the quality of the refrigerant inside the tank at the end of the process? What is the total heat transfer for this process? KJ
What is an adiabatic process? What is an adiabatic system?
For an air-water system, the dry bulb temperature is always greater than the wet bulb temperature. Is this true or false?
The average thermal conductivity of the walls (including windows) and roof of a house in the figure shown below is 4.8 10-4 kW/m · °C, and their average thickness is 20.8 cm. The house is heated with natural gas, with a heat of combustion (energy given off per cubic meter of gas burned) of 9,300 kcal/m3. How many cubic meters of gas must be burned each day to maintain an inside temperature of 25.9°C if the outside temperature is 0.0°C? Disregard surface air layers, radiation, and energy loss by heat through the ground. m3 A house has a rectangular base and a roof that peaks along a line above the center of the house and parallel to the length of the house. This roof slopes downward from the peak to each edge at an angle of 37.0° with the horizontal. The length of the front of the house is 10.0 meters. The width of the house is 8.00 meters. The height from the front of the house up to the edge of the roof is 5.00 meters.
Putting hot foods into the refrigerator without cooling them first not only wastes energy but also could spoil the foods nearby. Is it true?
a) A gas is trapped in a piston-cylinder device. The initial pressure and temperature of the gas are 500 kPa and 300 K, respectively. The system undergoes an isothermal expansion process, in which 15KJ of boundary work is done by the gas and 3KJ of paddle-wheel work is done on the gas. Determine the amount heat transfer during this process. Explain the direction of the heat transfer.
A student living in a 4m x 6m x 6m dormitory room turns on her 150 W fan before she leaves the room on a summer day, hoping that the room will be cooler when she comes back in the evening. Assuming all the doors and windows are tightly closed and disregarding any heat transfer through the walls and the windows, determine the temperature in the room when she comes back 10 h later. Take R= 0.287 kJ/kg.K, and Cy 0.718 kl/kg.K, and assume the room to be at 100 kPa and 15 C in the morning when she leaves.
Refrigerant-134a (R-134a) enters the expansion valve of a refrigeration system at 650 kPa with a quality of 20%. The pressure of R-134a at the outlet is 200 kPa. a)Determine the temperature of R-134a at the outlet in oC. Calculate the difference of internal energy between the outlet and inlet in kJ/kg
Determine the work required (in kJ/kg) for a pump that is used to increase the pressure of a liquid water stream from 100 kPa to 1500 kPa isothermally at 20 °C. The specific heat of water (C) is 0.0035 kJ/kg.K. its specific volume is 0.001031 m³/kg and its volume expansivity (B) is 250x10 K
Consider two identical rooms, one with a 2-kW electric resistance heater and the other with three couples fast dancing. In which room will the air temperature rise more quickly?
A certain quantity of air in a closed vessel with a fixed volume of 0.15 m3 exerts 1 MPa pressure at 500 K. If the vessel is cooled while the pressure is reduced to 350 kPa, determine the heat transfer during the process.
The air temperature during this process is kept constant by an electric resistance heater placed in the tank. Determine the electrical work done during this process.