A reinforced concrete beam of rectangular cross-section, provided reinforcement for moment only is subjected to an ultimate shear force V of 400 kN. The beam size, b = 250 mm, d = 475 mm and material strength fek = 30 N/mm², and fyk = 500 N/mm². Is the beam adequate for shear? 3.5 Design the shear reinforcement for a beam with b = 300 mm, d = 550 mm, V = 150 kN, fek = 25 N/mm², and f = 500 N/mm². A T-beam and slab system of a structure are made of beams spaced at 3.0 m with a clear span of 7.2 m between brickwalls of 250 mm thick. For the T beam he = 100 mm, bw = 300 mm, d = 600 mm. If fek = 35 N/mm² and fyk = 500 N/mm2, design the shear reinforcement. Assume 4H25 tension reinforcements are provided with variable load = 5 kN/m². 3.6

A reinforced concrete beam of rectangular cross-section, provided reinforcement for moment only is subjected to an ultimate shear force V of 400 kN. The beam size, b = 250 mm, d = 475 mm and material strength fek = 30 N/mm², and fyk = 500 N/mm². Is the beam adequate for shear? 3.5 Design the shear reinforcement for a beam with b = 300 mm, d = 550 mm, V = 150 kN, fek = 25 N/mm², and f = 500 N/mm². A T-beam and slab system of a structure are made of beams spaced at 3.0 m with a clear span of 7.2 m between brickwalls of 250 mm thick. For the T beam he = 100 mm, bw = 300 mm, d = 600 mm. If fek = 35 N/mm² and fyk = 500 N/mm2, design the shear reinforcement. Assume 4H25 tension reinforcements are provided with variable load = 5 kN/m². 3.6

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q.20 The main reinforcement in RC slab consists of 10 mm diameter bars at 100 mm c/c spacing. When 10 mm bars are replaced by 12 mm diameter bars then spacing would be
Refer to the diagram of precast concrete building below and answer the following questions. What type of precast concrete element directly supports this building's floors? Precast walls Precast "T" beams Precast "L" girders Precast Columns
Q) Differentiate b/w the following: A ) UBC & IBC. Subject: Reinforced concrete design ii
5. What is the minimum steel ratio for slabs when compressive strength of concrete is less than 420 MPa?
The main reinforcement of a RC slab consists of 10 mm bars at 10 cm spacing. If it is desired to replace 10 mm bars by 12 mm bars, then the spacing of 12mm bars should be
What is heavyweight concrete? How heavyweight concrete is different from lightweight concrete?
The main reinforcement in RC slab consists of 10 mm diameter bars at 100 mm c/c spacing. When 10 mm bars are replaced by 12 mm diameter bars then spacing would be
3 نقاط The minimum reinforcement using mild steel in slab should not be less than .., if fy=420 MPa ...... 2.0% 1.8% 0.15% 0.18%
Please solve the following
SCC and Plain Concrete What is the purpose of the J ring test