A refrigeration system with a capacity of 10 tons of refrigeration operates at 210 kPa in the evaporator, while in the condenser it is 850 kPa. If the R-134a refrigerant is in a saturated state, calculate the theoretical power required to operate the compressor. Compressor power = .... kW

Q: Air is to be compressed from 3 bar and 303K to pressure of 15 bar in a multistage compression…

A: a multipart question about a simply supported beam subjected to a thermal load and an axial point…

Q: Refrigerant 134-a enters the condenser of a residential heat pump at 800 kPa 35 C at a rate of 0.018…

A:

Q: Solve question. Use countercurrent heat exchanger process. Also find the log mean temperature…

A: Step 1: Given t1​=125oCt2​=90oCT1​=50oCT2​=75oCm˙w​=4.81kg/sco​=1.9kJ/kg.Kcw​=4.184kJ/kg.K Step 2:…

Q: In order to increase the velocity of steam used as a fluid for a power plant, it was concluded that…

A: Nozzle is a device which is used to increase the velocity of fluid. Given data: Mass flow rate of…

Q: A transmission case measures W = 0.30 m on a side and receives a power input of P; = 150 hp from the…

A:

Q: the rate of 65 kg/min through a double pipe counter flow heat exchanger. Water is eated from 50 C…

A:

Q: A reciprocating compressor draws in 500 gal per minute of air whose density is 0.079 Ibm/cu ft and…

A:

Q: A piston-cylinder device initially contain 0.4 m3 of 1.8-kg saturated liquid water and steam mixture…

A:

Q: A refrigerator operates on a reversed Carnot cycle whose coefficient of performance is 5.0. The…

A:

Q: Q1) Air is used at a rate of 0.2 m³/min from a receiver at 50°C and 700 kPa gage. If the atmospheric…

A: Given, Volumetric flow rate, V2=0.2 m3/min=0.00333 m3/sec Final temperature, T2=50°C=323 K Final…

Q: Kerosene is pumped into a tank at rate between 0 and 1000 Litres per minute. The inlet temperature…

A: Given that- Kerosene is pumped into tank at rate between 0 to 1000 L. Hence, inlet flow rate= Fi…

Q: Q2/ A vapor-compression refrigeration system. The refrigerant is R134a for operating conditions,…

A:

Q: Find the specific work done in a Rankine cycle if the steam supplied at 650 kPa and 0.9 dry and the…

A: The given parameters are:Pressure at which steam is supplied (P1) = 650 kPaDryness fraction (x) =…

Q: 45 kg/h liquid propylene will be cooled from 300 K to 288 K by chilled water through a shell and…

A: Heat capacity of liquid propylene at 294 K is 2.6 kJ/kg-KCp-pl = 2.6 kJ/kg-KFlow rate of liquid…

Q: In the gas turbine cycle whose installation scheme is given in the figure below, 80% Isentropically…

A: Outlet temperature; Pressure ratio =5 T2T1=P2P1γ1-γ⇒T2290=50.41-0.4⇒T2=459.3 K (outlet tempreature…

Q: Consider a steam power cycle operating according to the simple ideal Rankine cycle. The steam enters…

A: Hello. Since your question has multiple parts, we will solve the first question  for you. If you…

Q: A converging-diverging nozzle is used to accelerate water at the state of superheated steam. The…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: At steady state, a power cycle develops a net power output of 20kW while receiving energy by heat…

A:

Q: Q2/ Steam at 320 °C and 80 bar enter Nozzle with velocity 70 m/s and leaving by temperature is 100…

A:

Q: Consider the transmission case of Problem 1.23, but now allow for radiation exchange with the…

A: Given Data:Pi=150 hPTsur = 30oCThe emissivity () is 0.80.W= 30 mThe efficiency ()is 0.93.

Q: It is proposed to design and develop a Rankine cycle Steam Power Plant in which steam at 80 bar and…

A: Note: Since we are entitled to answer only 3 sub-parts, we’ll answer the first 3 subparts. Please…

Q: A co-current (same direction) heat exchanger has one line with 5 kg/s of n-butane at 120oC and 5 bar…

A:

Q: Steam at 320 °C and 80 bar enter Nozzle with velocity 70 m/s and leaving by temperature is 100 °C,…

A:

Q: (For numbers 4 to 10) A double-pipe heat exchanger (counterflow operation) having an area of 100 m²…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Q3. A Carnot system operates between temperatures 500 "F and 100 °F. Its efficiency may be increased…

A:

Q: Air enters an insulated compressor at ambient conditions, 100 kPa, 20C at the rate of 0.2 kg/s and…

A: Given: P1 = 100kPa T1 = 273+20 = 293K m = 0.2kg/sec T2 = 500K n= 70% Cpo= 1.004kJ/kg.K

Q: The reservoir problem containing 45 kg of liquid with an initial temperature of 45 ° C has one inlet…

A:

Q: What is the power output -2

A:

Q: )Problem #3 A prototype pump is designed to so that the attached dimensionless performance curves…

A:

Q: Using the first law of thermodynamics, analyze the cycle below in the thermodynamic equipment to…

A:

Q: A Compressor compresses the air at 112 kPa and 300 K to 415 kPa and its inner diameter is 0.021 m.…

A:

Q: As can be seen in the figure, the air conditioner working in a stable state keeps the indoor…

A:

Q: A compressor receives air at 101.3 kPa at a steady rate of 0.5 kg/s and delivers at 700 kPa. At the…

A: Given mass flow rate of air into compressor, v= 0.5 kg/s inlet velocity of air V1=6 m/s exit…

Q: A heat pump with a COP = 3 delivers heat to a building that has a UA = 15,000 Btu/hr-ºF. The heat…

A: COP of a heat pump is defined as the relationship with the power  that is drawn out of the pump with…

Q: The temperatures of the 12 °C water at inlet 13 °C 15 °C 30 °C The temperatures of the 20 °C water…

A: