A pure sinusoidal current is being rectified. For the given maximum value of half wave rectified current is 50 A, then the rms value of full wave rectification will be 50 (a) A (b) 100 A - TC (c) 100 A (d) 70.7 A
Q: Plot the waveforms of current ly as funcuons of tine. Sz At=1 sec 8A S t=l see ww www www 0.8~ オーo…
A:
Q: Fig 5.1 shows the circuit of a comparator used to produce square-wave from sine wave: +15 V Vout +…
A: Given circuit is comparator It produces +Vsat at output if V+ > V- And - Vsat at output if V+…
Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…
A: A limiter circuit should be designed that limits a 20 V rms sinusoidal voltage to a maximum positive…
Q: 1. A sinusoidal waveform is displayed on an oscilloscope and has a peak-to-peak amplitude of 15 V.…
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: 4. Explain the three-level PWM by drawing waveforms.
A: Pulse width modulation(PWM): PWM is a powerful technique for controlling Analog circuits with a…
Q: 1) Suppose you have a sinusoidal input signal and wish at the output the signal should be same (in…
A:
Q: You read the following waveform on an oscilloscope with the scale settings of 20m s/div and 1 V/div.…
A:
Q: Time taken for an alternating quantity to complete one cycle of the waveform is called time period.…
A: We need to tell whether the given statement is true or false.
Q: The waveform displayed on an oscilloscope is as shown in Figure . Determine: (1) amplitude of…
A:
Q: Design a 15v full wave power supply that will deliver a 1.5A of DC current to a load of 1kohms
A: In this solution we discusses about Design of a 15v full wave power supply that will deliver a 1.5A…
Q: voltage of 10V RMS 520Hz is applied across
A:
Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…
A: A limiter circuit should be designed that limits a 20 V rms sinusoidal voltage to a maximum positive…
Q: v/2 . -V/2- Figure 1 (b) A sawtooth waveform given in Figure 1 has a period of T and a peak-to-peak…
A:
Q: The sinusoidal current waveform having the R.M.S value of 15 A, then the maximum value is
A: For sinusoidal wave form , Maximum value = RMS value ×2
Q: The waveform displayed on an oscilloscope is as shown in Figure . Determine: (i) amplitude of…
A:
Q: Suppose you are asked to generate the waveforms as shown in figure 1, continuous over time, using…
A:
Q: You read the following waveform on an oscilloscope with the scale settings of 20 m s/div and 1…
A: in the oscilloscope, x-axis represents the time period and the vertical signal consist of the…
Q: Express the following in its simplist form: sin(2πft)+sin(2πft-π). Hint: Thinkabout what each…
A: We need to solve given trigonometric function .
Q: A voltage wave having an equation e = 220 sin(314t+45°) + 100 sin(942t - 45°) is impressed across a…
A: Given parameters: Voltage wave expression- e =220sin314t + 45° + 100sin942t - 45° Resistance, R = 10…
Q: a) Draw a sinusoidal waveform on a graph paper, assuming that Vx (effective value) and fx (kHz) are…
A:
Q: 1. For the sinusoidal waveform below: What is the peak value? What is the instantaneous value at 15…
A: From the given waveform, the value of the peak voltage is, Vp=10 V
Q: A square waveform with following specifications. Peak to Peak current 10A Time for ten cycles 0.04s…
A: The square waveform of the current has the following specification: IPeak-Peak=10 ANumber of…
Q: For the given waveform, current the voltage by an angle, þ. A9 cot
A: For the given waveform we need to find a current is lagging or leading the Voltage.
Q: The peak to peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 9 cm ane the…
A: Peak value= no. Of divisions×Volt/div. Given no. Of divisions= 9 cm. And volt/div =45V/div
Q: If V=2V, input voltage Vi is a sine wave with 5V peak and R=1kohm. Plot the output waveform.…
A:
Q: An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is…
A: (a) Write the given values. Vrms=22.2 VL=0.29 mHf=1 kHz
Q: 7. A double beam oscilloscope displays 2 sine wave forms A and B. The time/cm switch is on 100 us/cm…
A: In this question, Find the frequency f= 1/T Peak voltage and rms voltage? Phase difference?
Q: For a sinusoidal input of 20 V peak to the given circuit, what is the peak value of the output…
A: The peak value of the wave is the highest value the wave reaches above a reference value. The…
Q: Question No.85 What will be the transient time (in seconds) of a series RC circuit, when the…
A: Given, A series RC circuit with, Resistance, R=8 kΩ Capacitance, C=8 mF
Q: 1 (ms) 3 5 7 9 11 13 15 17 What is the frequency of the waveform in Figure and Determine the duty…
A: Those function which repeat itself after a fixed interval of time is called periodic function. A…
Q: 2. For the given circuit, sketch the waveforms for W, X and Y. D EN CIk A Y Cik
A: Considering the positive edge trigger flip flop. Characteristic table of D-FF: It can be concluded…
Q: The total RMS current in the series circuit of Te
A:
Q: Wave Energy is non-conventional source of energy Select one: True False
A: In this question, we will find that wave energy is conventional or non conventional source of…
Q: A full wave rectified sinusoidal voltage is clipped at 1/√2 of its maximum value. What are the…
A: The solution is given below
Q: A series circuit consisting of 17ohm resistance and 20mH inductane is connected across a 220V(RMS)…
A: The solution is given below
Q: Q2: (a) Determine the frequency of the waveform of following figure. 10 V t msec 50 (b) Find T-…
A: In this question , we will find frequency of given periodic wave form...
Q: For a full-wave rectified signal the dc voltage of 0.636Vm. The rms value of the ac component of the…
A:
Q: The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 0.5…
A:
Q: For the given waveform, the current the voltage by an angle ot (rad) T/2
A:
Q: Please sketch waveform for part b
A: The output of the Op-amp circuit is Voutt=5-8sinωt V.
Q: A series circuit like the circuit in (Figure 1) consists of a 1.40 mH inductor, a 115 N resistor,…
A: The values series circuit components are,L=1.40mHR=115ΩC=95nFvRMS=55V
Q: 6. What is the period of the signal ): 47 COS r(t) = sin -t a) 91 sec (b) 13 sec (e) 7 sec (d)…
A: Brief description : Wo : Fundamental angular frequency in rad/sec T : Fundamental time period in…
Q: For the given waveform, the voltage T the current by an angle ot (rad)
A: If two alternating quantities such as a voltage, V, and a current, I have the same frequency ƒ in…
Q: 9) The time A is called the time. 9) CK 10) The time B is called the time. 10) 11) For the JK FF…
A:
Q: 8.What is the effect of increasing the value of the capacitance In single phase half wave with RL
A: Single-Phase half wave Rectifier- Single-phase half-wave rectifier consists of one thyristor and…
Q: A periodic waveform continually repeat itself after particular interval of time. Select one: O True…
A: In this question, a statement is given..We have to find it that is true or false..
Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…
A: Given data The RMS voltage 20 V The maximum positive amplitude is 10 V maximum negative amplitude -5…
Q: A voltage of 6 cos(100at) V is fed as y-input to a CRO. The waveform seen on the screen of the CRO…
A: Given input voltage is - vt=6cos100πtV Given CRO reading is -
Q: The number of passive elements in the second order transient circuits is O 1 O 4 O 3 02
A: About 2 nd order transient circuits.
Step by step
Solved in 2 steps
- A pure sinusoidal current is being rectified. For the given maximum value of half wave rectified current is 50 A, then the rms value of full wave rectification will be 50 (a) A (b) 100 - A TC (c) 100 A (d)70.7 AThe peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 6 cm and the 'volts/cm' switch is on 33 V/cm. The peak to peak voltage is given by O 396.00 V O 5.50 V O 139.99 V O 99.00 V5. Figure Q5 shows a parallel dipper circuit. Sketch the output waveform t, for one complete cycle. R Vi 10 V Si Si vo -10 V 7.3 V 5.3 V Figure Q5
- A square waveform with following specifications. Peak to Peak current 10A Time for ten cycles 0.04s i. Sketch the waveform. i. Determine the Form factor and peak factor for the above sketched waveformThe peak to peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 9 cm and the 'volts/cm' switch is on 25 V/cm. The peak voltage is given by O 2.78 V O 159.07 V O 112.50 V O 225.00 VFor the following parts, identify the name of each circuit, plot the output waveform, and find the DC output average voltage. Part (a) V 1 cycle V₁ = V sin cor Part (b) PE Part (c) Vm Vi ele eeeeeeeeeeeeee D D₂ D₁ D₂ R Va + D₂ D₁
- In sinusoidal voltage waveform the positive peak to negative peak value isQ16/ choose the correct answer For the CRO display of a pulse waveform, the time/cm is on 30 ms/cm and the volt/cm switch is on 9 V/cm. The width of one complete cycle is 5.6cm and the height of the pulse is 1cm. Determine the RMS value of the pulse waveform. A- 6.36 B- 4.50 C- 3.80 D- 0.30Problem 5 Determine the period in ms, frequency in Hz, amplitude in volts, and phase in degrees (vs base cosine signal) of the harmonic voltage signal shown in the figure. Keep 3 significant digits. voltage, V 10 5 -5 -10 36 12 time, ms 24 Question 11 What is the period, T, in ms of the waveform above?
- The rms value of the resultant current in a wire carries a dc current of 10 A and a sinusoidal alternating current of peak of value 20 A is-The given waveform is O a. Unsymmetrical waveform only O b. Unsymmetrical and alternating waveform O c. Symmetrical waveform only O d. Alternating waveform onlyIn the non-sinusoidal wave circuits the peak value of infinite harmonic number is * .peak value of fundamental wave non-of-them O I I V A