A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps. What is the throughput if the system (all stations together) produces? a. 1000 frames per second? b. 500 frames per second? c. 250 frames per second?

Q: Eight sources, each with a bit rate of 1000 kbps are to be combined using synchronous TDM. Each…

A: a. The size of an output frame in bits is as follows : Size of an output frame = Number of sources +…

Q: Assume that the data is transferred using 16PAM (16-level pulse amplitude modulation). How many bits…

A: ANSWER : The number of possible pulse amplitudes in analog PAM is theoretically infinite. Digital…

Q: In a CRC voice recognition system, the generator is polynomial g = 11011 and if we want to send the…

A: The question is to write what data bit is sent using CRC.

Q: An Information system sends 365 kbps over a channel of 25 KHz bandwidth, how many signal levels…

A:

Q: A distant planet is about 9 x 1010 metres from the surface of the Earth. What is the channel…

A: Distance =9 x 1010  Band Width=64 MB Frame Size= 32 KB Velocity=3 X 108 m/sec

Q: Q3)A slotted ALOHA network transmits 800-bit frames using a shared channel with a 400-kbps…

A: In this case G=2. So, S = G*e-G S = 2*(2.71)-2 S = 0.272 = (27.2 percent) This means that the…

Q: We need to transmit 100 digitized voice channels using a pass-band channel of 20 KHz. What should be…

A:

Q: Answer the following questions with a simple "true" or "false" and a short explanation of your…

A: Introduction Selective Repeat Protocol (SRP) is a data link layer protocol that utilizes a sliding…

Q: For the following stream of digital signal which is being transmitted by bit rate 5 Kbps:…

A: a. Draw waveform for all line code is self synchronized or not.

Q: Can I have a detailed, step-by-step explanation for the following question? Thank you very much!…

A: We have 4 channels that are multiplexed using TDM. If each channel sends 100 bytes/second and we…

Q: What is the main disadvantage of using FSK over ASK for digital communication? A. FSK is more prone…

A: Frequency Shift Keying (FSK) and Amplitude Shift Keying (ASK) are both digital modulation techniques…

Q: What will the best latency be for 280 KB to be transmitted with a bandwidth of 12.5 KB per second?

A: The best combination is to have high-speed internet with low latency.

Q: what is the throughput if the system produces the 1000 frames/sec then A pure ALOHA network…

A: The Answer is in Below Steps

Q: lex cable runs at T1 data rate cable is 2/3 the speed of light in the cable is

A:

Q: SAMPLE DATA HELLO CODE

A: A)in below figure shows how to transit message  are multiplexed into frames.

Q: 6- If an Audio signal of 20KHz is sampled and encoded by 8 levels, what is the Nyquist…

A: EXPLANATION Below is the answer for the given question. Hope you understand it well. If you have any…

Q: -A synchronous TDM with four 2 Mbps data stream inputs and one data stream output. The multiplexing…

A: Here we have given the answer for the first question as per the guideline.

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A:

Q: Q4\ In IS-95 system, assuming the speed of a vehicle is 100 Kmph, carrier frequency, fc 860 MHz, the…

A: The symbol distortion will be experienced as phase distortion. The type of fading will be…

Q: Let's say you're interested in transmitting PAL video as a YUV stream. K bits are used to represent…

A: 1. Composite Video: In composite video, the YUV video signals are combined into a single composite…

Q: II. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A: Solution:-

Q: A group of some stations share a 56 kbps pure ALOHA channel. Each of these stations output a 1000…

A:

Q: Please check my answer and correct the part which is need to be foxed. And provide justification for…

A: The transmission time of a frame can be calculated in the next step. The efficiency of the CSMA/CD…

Q: A digital signal can only be sent in baseband if we have a channel. a. low-pass b. bandpass c. low…

A: GIVEN: A digital signal can only be sent in baseband if we have a channel.a. low-pass b. bandpass c.…

Q: Consider a geostationary satellite-based system. Earth stations are multiplexing digital information…

A: Given ,A geostationary satellite-based system .And a earth station is multiplexing the digital data…

Q: We have 14 sources, each creating 500 8-bit characters per second. Since only some of these sources…

A:

Q: Q4\  In IS-95 system, assuming the speed of a vehicle is 100 Kmph, carrier frequency, fe 860 MHz,…

A: the answer is as follows.

Q: Four computers are sending the digital data over a multiplexed line as shown in the Figure below.…

A: A) Multiplexing is the process of combining multiple signals into one signal, over a shared medium.…

Q: We need to send 265 kbps over a noiseless channel with a bandwidth of 20 kHz. How many signal levels…

A:

Q: ith a bit rate of 250 kbps and four with a bit rate of 500 kbps are to be combined using…

A: a) we can allocate eight 250kbps sources into 4 500 kbps sources . Therefore 8 total 500 kbps…

Q: How many bytes of data can be transferred in 10 seconds via a serial link in asynchronous mode with…

A: iNTRO How many bytes of data can be transferred in 10 seconds via a serial link in asynchronous…

Q: p. What is the output frame rate? E. What is the duration of an output frame? d. What is the output…

A: NOTE: As per Bartleby guideline, If there are multiple part then we are allowed to solve only first…

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.