Answered: A pump discharges 60 tons of water per…

A pump discharges 60 tons of water per hour to a height of 8 m, overall efficiency of the pumping system being 69%. Calculate the output and input power.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.7MCQ: Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a)...

See similar textbooks

Related questions

Q: 1. An AC generator has a kw rating of 160 at a power factor of 0.86, Find the KVA rating of the…

A: 1. Given data, AC generator has P=160 kW cosϕ=0.86

Q: Determine the minimum number of 240Ah batteries which can supply the POWER REQUIREMENT of the motor.

Q: A power transmission line conducts current from a 6000V generator to three loads A,B,C, the loads…

Q: A 2,500kVA, three-phase, 60Hz, 6.6kV wye-connected alternator has a field resistance of 0.45 ohm and…

Q: 6. A string of four suspension insulators is connected across a 285 kV line. The self-capacitance of…

A: The correct solution can be achieved as follows.

Q: Build acreuil to perform + 2 dt

Q: A hydro-electric station has an average available head of 100 meters and reservoir capacity of 50…

A: Given: The values are shown as: Head,h =100 m,Capacity, Q= 50×106 cubic meter,Hydraulic…

Q: Which of the following statement is wrong for the outdoor substations? O For voltages below 33 KV O…

A: The voltage ratings of outdoor substations usually lies between 55KV to 765KV .

Q: Each phase of a star-connected load shown in Figure 1 consists of a resistance of 50 Ω in parallel…

A: In the figure, Resistance is connected in series with inductance(not parallel as mentioned in…

Q: a) Find the ICA load current b) Give the voltage Vab c) Calculate the total complex power on…

A: a) Find the ICA load current b) Give the voltage Vab c) Calculate the total complex power on voltage…

Q: A mini-hydroelectric power plant is under a head of 275 feet. The turbine efficiency is 0.85 and the…

A: The power system consists of power generation, transmission, and distribution. The transmission…

Q: The Power Input to a 400volt, 50HZ, 3Phase motor is measured by two wattmeter's which indicate 300KW…

A: If W1 and W2 are the readings of two wattmeter's in two wattmeter's than total power is W1…

Q: If the net flywheel hp of a tractor engine is 250, what is the estimated PTO hp? O 225 O 278

A: Power-take-off It is a device that transfer mechanical power to another piece of equipment

Q: The Power Input to a 400volt, 50Hz, 3Phase motor is measured by two wattmeter’s which indicate 300KW…

A: Let W1 and W2 are the readings of two wattmeter's in two wattmeters than total power is given by W1…

Q: A three-phase induction motor runs delivering 9 kilowatts to its load at efficiency of 88 %. If the…

A: This is a simple question based on general logical reasoning and electrical machines. In this we…

Q: A wind turbine is rated at 300 kW. Estimate annual energy production using the generator size…

A: Given: P=300 kW=300×103 J/sTime, t=1 yeart=365×24×3600 sect=31536000 s

Q: b) Draw and explain a grid network from generation to street mains, using a 11kV ring.

A: Electrical power can be generated at different voltages and transmitted to consumers in various…

Q: 6. A string of four suspension insulators is connected across a 285 kV line. The self-capacitance of…

A: The solution can be achieved as follows.

Q: Choose the correct answer: Transmission lines cause losses of electrical energy. Select one: O True…

A: According to the question we have to discuss about the loss of transmission line.

Q: A load of 10 MW operating at a power factor of 0.5 lagging is connected to a 400 V, 60 Hz source.…

Q: A power station has two 50MW units each running for 8500 hours in a year and one 30 MW unit running…

Q: Choose the correct answer: Transmission lines transmit power at the level of generation voltage.…

A: For same power transfer, High voltage transmission has less transmission losses than low voltage…

Q: A string of four suspension insulators is connected across a 285 kV line. Th nit is equal to 5 times…

A: In this question, 4 disc insulator given..We have to find out voltage across each disc and string…

Q: A single-phase energy meter is being operated on a 230 Volt, 50 Hz supply with a load of 20 Amp, 0.9…

Q: line currents (IR, Ty and 1B). (c) Determine the total real supply power (W) for Q1(b) based on the…

Q: Complete the wiring below, such that the given 3 - wire proximity sensor is capable of controlling…

A: Given: Consider the following figure: To find: Complete the wiring below, such that the given 3 -…

Q: The Power Input to a 440volt, 50HZ, 3Phase motor is measured by two wattmeter's which indicate 300KW…

A: Given data: P1=300 kWP2=10 kW

Q: 63 G5 K

A: Definition: Short circuit MVA is equal to its MVA rating divided by its own per unit impedance or…

Q: Individual loads on separate feeders of a large power system are often unbalanced. The loads of…

A: Given Data: Connection = Y Heart draw the current Phase 1 = IR = 150 A Phase 2 = IY = 100 A Phase 3…

Q: A construction crane is required to lift a load of 5000 kg from ground to a height of 60m in 30s.…

A: Given data -Weight of the load is,Lw=5000kgHeight from the ground is,h=60mThe diameter of the drum…

Q: A 400V, 3-phase Induction motor has input power of 16 KW and operates at power factor of 0.87…

A: Given: A 400V, 3-phase Induction motor has input power of 16 KW and operates at power factor of 0.87…

Q: Calculate the overall efficiency of the steam thermal power plant, If boiler efficiency is 85%,…

A: The overall efficiency of a steam power plant equal to the product of boiler efficiency, turbine…

Q: Problem 5.8: A water-pumping system in a ship is designed to pump 250 m³/h fresh water against 70 m…

Q: 4. An alternating voltage single-phase power supply generates a sinuse a) Calculate the Vpeak. b)…

Q: 2. For the manometer setup shown, determine the difference in pressure between A and B. 40,s=0.85…

Q: A 440 V, 3 phase A.C. Motor has a power input 13.5 kW, 0.6 lagging and with efficiency of 80 percent…

A: Power input to 3 phase motor =(root 3)×Line voltage ×Line current ×power factor. Given, power input…

Q: If a summing point is placed after a take off point, they will be represented ______ a. separate…

A: If a summing point is placed after a take off point, they will be represented ______ Options are:…

Q: 4. Pedro walks at the speed of 40 meters/min from the school to home, by taking the longer route of…

A: Given Speed: 40meters/min Longer route is: 100 meters to north and then 100 meters to east. Mother…

Q: If (i) Fault current = 1000 Amp (ii) CT Ratio = 80:1 (iii) Relay setting = 150% Then PSM (plug…

A: Given, Fault current, If=1000 A CT ratio = 80 : 1 Relay setting = 150 % = 1.50

Q: For reasons associated with economy, transmission of electric power is done by 3- phase system.…

A: Transmission of Electric power is done by 3 phase system

Q: 82. An autotransformer, designed for 4,000- to 2,300-volt operation, supplies a load of 32 kw at a…

A: In this question, Find the transferred power and conductive power? If autotransformer have…

Q: What is the reserve capacity, if the maximum demand of generation of power is 50 MW, the load factor…

A: Given, Maximum demand MD=50 MW. Load factor LF=60%=0.6. Plant capacity factor PCF=50%=0.5.

Q: Calculate the total cost of operating the followings for 30 days based on the rate of 10¢/Kwh. 3 2HP…

A: cost of the energy is given by the following relation = number of units energy consumed * price per…

Q: 1-Three identical capacitors are connected in delta with 400 V. If the line current is 12 : If the θ…

A: Given, A 3-ph delta connected capacitive load has, Line to line voltage (VL) = 400 volts Line…

Q: Homework: Determine whether the systems below a nonlinear. y(t) = x(log(t)).

Q: 2c What capacity would result if the pump rpm is increased to produce a pumping head of 120 ft,…

A: It is given that: N1=100 rpmQ1=500 gpmH1=90 ftη=0.60H2=120ft

Q: Remaining Time: 28 minutes, 24 seconds. A Questiqa Completion Status: 10 L> A Moving to another…

Q: The input power to a 3-phase a.c. motor is measured as 5 kW. If the voltage and current to the motor…

Q: Kuroto Hydro Electric Plant generates power for 4,850 watts with a flow rate of 712 ltrs/sec with…

Q: 3. A single phase 11kV line w inductive reactance of the Calculate the efficiency and

A: In this question , we will find efficiency and voltage regulation of given 1 phase overhead line..

Question

100%

A pump discharges 60 tons of water per hour to a height of 8 m, overall efficiency of the
pumping system being 69%. Calculate the output and input power.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How hydropower water turbine is essential in dry season
5. A welder machine operates automatically as follows : 30A current in 10 seconds, 20A in 10 sec., 10A in 10 sec. And finally 30A for 20 sec. To complete one cycle. What the equivalent rms value over one cycle?
1. Check any DC power sources in most large body aircraft. Choose all the correct answers. 2. These power sources supply 28V in most large body aircraft. Choose all the correct answers.
A 255 V, DC lathe machine, (not a 2 pole machine) has armature resistance and series resistance are 0.150 and 1702 respectively. The motor has 25mWb flux per pole. The ratio of pole to parallel paths is unity. The product of this ratio and number of turns in armature section is 1000. When it runs light, it has a speed of 1200 rpm. If it runs at maximum load, it takes a current of 70A. (1) Which machine is this one, shunt or series ? Is machine lap wound or wave wound? (3) Calculate the no load back EMF. (4) Calculate the no load armature current. (5) Calculate the no load shunt current. (6) Calculate the current drawn by the machine. Calculate the variable losses on load. (8) Calculate the armature power when it runs light. (9) Calculate the stray losses when it runs light. (10) Calculate the full load armature current. (11) (12) (13) Calculate the full load back EMF. Calculate the Variable losses on maximum possible load. Calculate the armature power on maximum load. (14) Calculate…
Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a) Exciting current (ii) Ic (b) Magnetizing Current (iii) Ie (c) core loss current
A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current of the Thyristor (5 µA) and frequency (50 Hz). Find the rate of voltage changing with time and snubber circuit power losses?
Explain the prime mover in diesel plant and it's energy conversion
c) A linear sensor-transmitter is used in the flow control loop. The current transmitter output is at 8 mA when the flowrate in the pipeline is 5 m³/hr. Calculate the gain of the sensor- transmitter if the lowest value of the calibrated flow sensor is 0 m³/hr. Determine the range of the calibrated flow sensor.
Cylindrical metallic parabolic trough solar thermal collectors. 1. Does not rotate. 2. It rotates around one axis only. 3. It rotates around two axes only. 4. They can produce a temperature of20-100 °C. 5. They can produce a temperature of200-400 °C. 6. They can produce a temperature of2000-4000 °C. O 1 + 4 only. O 2 + 5 only. 2 + 6 only O 3 + 5 only.
In DC machines, used to collect and supply current to the external load circuit.
A compound generator has a no load voltage of 136 V and a full load voltage of 145 V. Calculate the percent voltage regulation to one decimal point. No Units!
What is geothermal energy? b. How does a geothermal power plant differ from other power plants? c. Can a geothermal operation cause volcanic eruption?