A petroleum cut has the following TBP Distillation data: 0 10 30 71 85 125 150 175 200 225 Volume % distillate 50 70 90 95 Temperature °C Calculate the a) Molal Average Boiling Point (MABP) b) mean average boiling points (MeABP)

Q: An evaporator is concentrating solutions coming from two different sources. The solution from the fi...

A: Given F1=59kg/min F2=80kg/min First source = 10% NaCl and 10% NaOH Second source = 8% NaCl and 12% ...

Q: For the redox reaction given below complete the following: FeCl2 + H202 + H* → FeCl3 + H2O (a) What ...

A: This is an example of redox reaction. Balancing this redox reaction.

Q: Process Flow of Sludge Treatment in any industrial plant

A: Mixed sludge is goes to dissolved air flotation tank which is received from secondary wastewater tre...

Q: n evaporator is concentrating solutions coming from two different sources. the solution from the fir...

A: Given that: Input solution (1): NaCl = 10% = 0.1 NaOH = 10%= 0.1 Water, H2O = 80 % = 0.8 Flow rate =...

Q: A sandstone core sample (Vb = 49 cm3, Vp 8.8 cm3, fluid mass = 15.2 g) contains both oil and water (...

A: Given Volume of the particle, Vp = 8.8 cm3 Mass of the sandstone, m = 15.2 g Density of oil, ρo = 0...

Q: 3. The irreversible first order liquid phase reaction A →R is to be carried out in an insulated mixe...

A:

Q: A simple Rankine cycle works betw een pressures 64 bar and 10 Kpa, the initial condition of steam be...

A:

Q: a. What are the effects of the presence for sulfur compounds in crude oil?

A: NOTE: Kindly repost other questions as a separate question. Sulfur compunds like sulfides, thiophene...

Q: Q3/ Estimate the Watson characterization factor K, molecular weight, Aniline point, carbon to hydrog...

A: Given data: Mean average boiling point = 99 0C API gravity = 52

Q: In refineries, a mixture of paraffins and cycloparaffins is reformed in a catalytic reactor to produ...

A: Given in this problem  Component flow rates, ni , of feed ,in lbmol/h. Component split fractions for...

Q: Problem No.2 A cross-flow heat exchanger consists of 40 thin-walled tubes of 1-cm diameter located i...

A: Given: Number of tubes is 40 Diameter of tubes is 0.01m Cross section area of heat exchanger is 1 m2...

Q: Particles of a sphalerite (SG=0.4) are settling under the force of gravity through a slurry consisti...

A: Given: Particles of a sphalerite (SG=0.4) 25% by volume of quartz particles (SG-2.65) and water Dens...

Q: Q2:A sandstone core sample (Vb 49 cm3, Vp 8.8 cm3, fluid mass 15.2 g) contains both oil and water (p...

A: Given, The density of oil, ρo = 0.82 g/cm3 The density of water, ρw = 1 g/cm3 Mass of the sandstone,...

Q: Deliver crude oil feed to the fractionator at a constant temperature T*, and flowrate F0, regardless...

A: Crude oil feed to the fractionator  Constant Temperature= T* Flowrate =F0 Furnace Outlet temperat...

Q: A 30 ml solution of 1 - was treated with 50 ml of 0.365 M AgNO,. Agl(s) was filtered off, and the fi...

A: Write the reaction between AgI and KSCN as follows: AgI + KSCN  → AgSCN + KI   One mole of AgI react...

Q: A liquid mixture containing 35.0 mole% acetone and 65.0 mole% water is to be partially vaporized in ...

A: Hi and thanks for the question. Since you have posted a question with multiple subparts, we will ans...

Q: A solid naphthalene sphere is placed in a flow of air at 135°C at a pressure of 1.013 × 105 Pa. The ...

A: Given NAr=DABPRTrln11-PA1P Diameter = 35 mm to 15 mm DAB=8.6x10-6 m2s PA1=9537 Pa P=1.1013x105 Pa T=...

Q: The radius of a given capillary is 0.1055 mm. A liquid whose density is 0.850 g/mL rises in this cap...

A:

Q: (d) The figure below shows the operation of a reciprocating positive displacement pump. Explain in y...

A:    

Q: You are learning Russia {passiv}

A: The given statement is to be converted into a passive form.

Q: Conditions at the top of a vacuum distillation column for the sep- aration of ethylbenzene from styr...

A: Things which are provided over here are Phase condition, temperature, pressure, flow rate, and compo...

Q: 3. The irreversible first order liquid phase reaction A »R is to be carried out in an insulated mixe...

A:

Q: 3. The irreversible first order liquid phase reaction A →R is to be carried out in an insulated mixe...

A:

Q: Data from an unseeded domestic waste-water BOD test are: 5.0 ml of waste in a 300 ml bottle, initial...

A: A) GIVEN: Initial DOi = 7.8 mg/l Final DOf afetr 5 day = 4.3 mg/l Dilution fraction = P = 5.0 ml of ...

Q: 1. Liquid water mixed with a recycle stream is fed to a heater to raise the temperature to 150°C at ...

A: Given: Process flow diagram:  

Q: ngorous the nonrigorous expressions, cite the assumptions. (a) K; = a/v (b) K; = da/&v (c) K¡ = dz (...

A: K value is known as the phase-equilibrium ratio is the ratio of mole fractionsof a species in two ph...

Q: Q2/ A Petroleum cut has the following ASTM D86 distillation data:- Volume% 30 50 10 70 90 95 distill...

A: Given data: The ASTM D86 distillation is given.

Q: a. What are the effects of the presence for sulfur compounds in crude oil? b. Explain the most accep...

A: Answer the following questions.

Q: Fluid properties acetone at 42.5 celcius

A: Acetone C3H6O is a colourless fluid. It is also called as 2propanone. Molecular weight = 58g/mol

Q: The Power (P) required to drive the pump depends upon the diameter (D), the angular velocity (@), th...

A: Given, Power is a function of diameter, angular velocity, discharge, and fluid velocity. P = fD, ω, ...

Q: 4. A dairy processing plant is interested in producing 100 kg of low fat cream (15% fat). The raw ma...

A: Answering: 4) Given: 100 kg of low fat cream is produced (15% fat) Feed contains 45% fat and fresh m...

Q: Water flows in a pipeline composed of 75 mm and 150 mm pipe. Calculate the mean velocity in the 75 m...

A:

Q: It is known that stream N contains 75% of A present in stream M. The ratio of F/P is 5:3 on a mole b...

A: The material balance of the unit is used to derive unknown compositions. The balance can be based on...

Q: is second order 1. At a certain temperature, the reaction in X with a rate constant of 51.0 M-'.min1...

A: Given: The rate constant for a second-order reaction is k = 51 M-1.min-1 The initial concentration o...

Q: 3-10 Determine the atmospheric pressure at a location where the barometric reading is 750 mmHg. Take...

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: Case Study: Two AES exchangers in series have difficulty heating a process stream from 50°C to 90°C ...

A: A adiabatic system which transfers heat from hot fluids to cold fluids is called heat exchanger. Thi...

Q: a. What are the effects of the presence for sulfur compounds in crude oil?

A:

Q: AWhy does the method of separation of variables work better for problems like the hydrogen atom when...

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: Q7. A gas expands adiabatically in a cylinder fitted with a piston. The initial pressure and tempera...

A:

Q: 3-48 Consider a double-fluid manometer attached to an air pipe shown in Fig. P3-48. If the specific ...

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: The following  potentiometric cell can be used to measure Ksp of AgI . SCE//Ag|Ag+(sat’d AgI)||Ag+(0...

A: GIVEN:  Concentration of [Ag+] =  0.10 M             -----(1)  By using the Nernst equation, we get ...

Q: Mutual solubility data for the isooctane (1) furfural (2) system at 25°C [Chem. Eng. Sci., 6, 116 (1...

A: Given: Experimental solubility data at 25 0C for the isooctane (1)-furfural (2) system.In the furfu...

Q: How the equipment works for Fixed-bed leaching

A: Leaching basically involves use of solvent to remove solute from a solid mixture. Here generally we ...

Q: A mixture containing 40 kg A and 60 kg B is contacted with are solvent in a single-stage process. Th...

A: This is problem of extraction. We are given relative abundance in raffinate and selectivity from whi...

Q: To make an 18.76% (w/w) solution, what volume (mL) of solvent would be needed for a solution that co...

A: To find Volume of solvent needed to make a solvent that is needed to make 18.76% w/w solution contai...

Q: How many grams of NaCl are present in 1263 ml of a 1.09 M solution?

A: Given, volume of solution, V=1263 mL=1.263 L Molarity of solution=1.09 M Also, molarity=moles of NaC...

Q: A screw conveyor transports seeds of 500 kg/m3 in bulk density and consumes 0.45 hp in power. If the...

A: For screw conveyors, the capacity can be estimated using the following relation, C = 4500PLρbF      ...

Q: what are real time applications and calculations used for the design of industrial system or practic...

A: A heat exchanger where the gaseous condense into liquid is called condenser. The phenomena involved ...

Q: A simple Rankine cycle works betw een pressures 46 bar and 10 Kpa, the initial condition of steam be...

A:

Q: A solution containing 10% NaCl, 3% KCl and 87 % water is fed to the process shown in the following f...

A: Apply mass balance on the system or corresponding individual unit to obtain unknowns. Apply composit...