A parallel resonant band-pass filter consists of a 90 resistor in series with a parallel network made up of a 60 mH coil and a 0.02 F capacitor. The output is taken across the capacitor/coil. The coil winding has a resistance of 20 . What is the center frequency of the filter? 4.59 5.59 6.89 7.59 8.59

A parallel resonant band-pass filter consists of a 90 resistor in series with a parallel network made up of a 60 mH coil and a 0.02 F capacitor. The output is taken across the capacitor/coil. The coil winding has a resistance of 20 . What is the center frequency of the filter? 4.59 5.59 6.89 7.59 8.59

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 4RQ: A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant...

See similar textbooks

Similar questions

A series resonant filter can be made into a:a. low-pass filterb. high-pass filterc. band-pass filterd. none of the above
An RC high pass filter consists of a 1000 Ohm resistor, what is the value of C so that the cut off frequency is 10 KHz Oa. None of the answers b. 0.01 nF Oc. 100 nF O d. 16 nF
The below 4 figures are the angle of the transfer function of passive filters. 90 Phase (deg) 45 -45- 00 -90 10 -45 -90 Phase (deg) 10¹ 90 45 -45 -90L 10² 90 10 10² 10 10³ Frequency (rad/sec) 10¹ 10² Frequency (rad/sec) Figure-1 shows the frequency response of Figure-2 shows the frequency response of Figure-3 shows the frequency response of Figure-4 shows the frequency response of 10 10 10 10
Determine the break frequency in KHZ of the RC low-pass circuit below. Assume that Resistor value is 3 KQ and Capacitr value is 0.02uF.
the Draw Speci Sication of Vistigal filter
What is the high pass filter cutoff frequency of the circuit R1= 54 Q, R2 = 261 Q, RF = 332 Q, RG = 8560 Q, C1 = 0.25 uF, C2 = 89 uF. Note: No need to place the unit, express your answer in Hz, two decimal places. ww m RG RF Vout ww ww RG RF R2 Vin C1 fin R1 + C2 +
The below 4 figures are the angle of the transfer function of passive filters. Phase (deg) -45- Phase (deg) (Cep) sid 45 10 10 Frequency (radisec) 10² Frequency (rad/sec) Figure-1 shows the frequency response of Figure-2 shows the frequency response of Figure-3 shows the frequency response of Figure-4 shows the frequency response of 4) ( + 4 10 10" 10
The roll-off of a lowpass Butterworth filter is 12 decibels per octave in the stopband. What is the filter order?
Determine the center frequency, maximum gain and bandwidth for the filter in figure below. C 0.01 R2 C2 180 kN R1 Vin 68 kN 0.01 µF Vout R3 2.7 kN Answer: fo = 736 Hz, Ao = 1.32, BW = 177 Hz
3. Show how a series RLC filter, its type depends on the output voltage terminal as follows: Low pass filter the output voltage across ... High pass filter the output voltage across . Band pass filter the output voltage across Band reject filter the output voltage across ...... ......... ........
What is the cut off frequency of RC low pass filter of order 1
11. In a certain low-pass filter, XC-500 and R=2.2 k. What is the output voltage (VoutVout) when the input is 10 V rms?