A mixture c0nsisting 0f is0butane, n-butane, is0pentane and n- pentane is t0 be distilled... The f0ll0wing tabulati0n gives the c0mp0siti0n 0f the streams in m0le fracti0n:     is0butane n-butane is0pentane n-pentane   Feed 0.06 0.17 0.32 0.45    Distillate 0.245 X Y 0.0242   B0tt0ms w 0.129 0.3008 z   Per 100 m0ls 0f feed, find the am0unt 0f the distillate and b0tt0ms str

Q: Benzene reacts with nitric acid to produce nitrobenzene and water. Nitrobenzene formed may undergo f...

A: Given : Benzene reacts with nitric acid to produce nitrobenzene and water The percentage conversion ...

Q: 2.10-6. Friction Losses and Pump Horsepower. Hot water in an open storage tank at linc from the stor...

A:

Q: To find out the equilibrium vapor phase molar composition and pressure, use a liquid binary solution...

A:

Q: A single CSTR with volume of 1550 ml operates with inflow/outflow volumetric flowrate of 100 ml/min....

A: Given- Volume of CSTR, V = 1550 ml volumetric flow rate, v = 100 mlmin initial concentration, CAO = ...

Q: Methane (CH, M = 16 g/mol) flows through a gas pipeline at a rate of 48 Ibm/h. If the gas is maintai...

A: Following values are given in the question Maas flow rate of methane m˙= 48 lbm /h molecular weight ...

Q: You have been given a beaker that contains a mixture of substances to separate. The mixture contain...

A: To list five separation techniques in order to separate the components of a mixture containing sand,...

Q: With the given diagram below, What is the EXACT composition of point a2?

A: Given diagram is a phase diagram of ternary system between water- acetic acid - chlororform The figu...

Q: Ethanol can be produced by the direct hydration of ethylene with H¿PO4 at 300°C and 6.8 MPa accordin...

A:

Q: 7. Find the volume of the combustion products formed by burning 1 Ib carbon to CO, with 60 percent e...

A:

Q: V1 Vapor 90 90 bpB 80 80 L2 70 70 V3 Liquid L3 60 60 50 L5 V5 L4 50 100% A 80 60 40 20 0% 0% 20 40 6...

A:

Q: A purification system with recycle is used to recover the solvent dimethyl formamide (DMF) from a ga...

A: Some assumptions are to be made initially. The fresh feed is assumed to be 100 mol/hr. As the produc...

Q: Q5: A piston-cylinder device contains 0.1 m³ of liquid water and 0.9 m³ of water vapor in equilibriu...

A:

Q: 3. Please consider a van der Waals gas for which that entered a device at 650 C and 30 bar and exite...

A:

Q: solid material containing 15.0 wtN moistues dried so that it contains 7.0 wt mied with recycled air ...

A: First let us see what are the data given: For the solid: Initial moisture content  = 15 wt% Final mo...

Q: What is the value of pgh?

A:

Q: Acetylene is hydrogenated to form ethane. How many kg/sec of hydrogen is required to produce 4 mill...

A: Given that: Required production of ethane (C2H6) = 4 million metric tons = 4×109 kg Process operatio...

Q: Predict the major product of the following reaction. NH2 1. NaNO2, HCI 2. CuCI CI NH2 NH2 CI NH2 CI ...

A: The given reaction is sandmeyer reaction in which aryl halides are formed from aryl diazonium salts ...

Q: The Antoine constants for 1-chlorobenzene are A=13.8635; B=3174.78; C=211.700. For 1-chlorobutane ar...

A: Given: The Antoine constants for 1-chlorobenzene are A=13.8635; B=3174.78; C=211.700 For 1-chlorobut...

Q: Consider the phase diagram for carbon dioxide. 73.0 In what phase is CO, at 4 atm and -10 °C? solid ...

A:

Q: Change of state of iodine Data: Average values of molar specific heat capacity at constant pressure:...

A: The total heat required will be a summation of various heat that is needed in the whole process. Ini...

Q: A series of multiple-effect evaporators is to be used for evaporating 400,000 kg water per day from ...

A: Given that Weight  of water per day from a salt solution = 400000 kg . initial cost for the first ef...

Q: 2. Methane gas is combusted with air, supplied in 25% excess. Calculate the maximum attainable tempe...

A:

Q: a) Butane (C,H10) is burned with air entering at 20°C. The air fuel ratio is 20 on a mass basis. Giv...

A: Given data: Air-fuel ratio = 20 (on mass basis) Atmospheric pressure = 100 kPa

Q: The figure below shows a simplified flowchart of sugar manufacturing.Sugarcane is fed to a mill wher...

A: Given, crystallizer produced=1000 lb/h

Q: Dry air (79 mol% N2 and 21 mol% O2) is bubbled through a vessel with liquid water to produce moist a...

A:

Q: -7. Pressure Drop of a Flowing Gas. Nitrogen gas is fiowing through a 4-in. schedule 40 commerical s...

A: Given that  T = 298 k 4 in schedule 40 commercial steel pipe flow rate, m = 7.4 x 10-2 kg/s L = 3000...

Q: Air ( Cy = 0.7186kJ/kg°K, R = 0.287KJ/kg°K ) with a pressure of105 kPa and temperature of 420°K is h...

A: Given, T1=420 K, P1=105 KPa T2=590K, P2=P KPa As the given process is a constant volume process, P1T...

Q: Raoult's Law

A: In ideal mixing solutions of low concentrations obey Raoult's law. Raoult's law  states that the vap...

Q: Unlike any other classification of materials, this type of materials is distinguished, not on its co...

A: The materials mentioned here are : Composites  The composite material also known as composition mate...

Q: 3. In a process Industry, benzene is flowing at the rate of 4 kg/s. Density of the fluid was measure...

A:

Q: O Hexagonal Close-Packed (HCP) O Body-Centered Cubic (BCC) O Primitive cubic O Face-Centered Cubic (...

A:

Q: 2.23. A stream of warm water is produced in a steady-flow mixing process by combining 1.0 kg s- of c...

A:

Q: A stream of pure A is fed into a reactor in which two reactions take place: A- B+C (1) A+C-2D (2) If...

A:

Q: Crude oil at 140°F with y=53.7 lb/ft³ and u= 8x10-5 lb-s/ft2 (about four times the viscosity of wate...

A: Given that  T = 140 F density = 53.7 lb/ ft3 Viscosity ,u = 8 x 10-5 lbs/ft2 L = 799 mile = 4.22 x 1...

Q: An integral balance is appropriate, since we are interested in accumulation after a finite time inte...

A: Given that  there is given an equation ,we have to integrate with respect to ' t ' initial value of ...

Q: The temperature dependence of the viscosity of a gas is given by the expression: AEviscosity µ = A e...

A: Given that  There is equation of viscosity which is depend on temperature  u = A exp(-ΔEviscosityRT)...

Q: Please allow the Molar Internal Energy to be a function of T and v, ū = ū(T, v). u = u(T,V), and sho...

A:

Q: Determine the change in entropy for an ideal gas that undergoes a change in conditions from a temper...

A: Given that, Initial temperature Ti = 300oC = 573 K Initial pressure Pi = 1.2 bar Final temperature T...

Q: What are 2 types of solid solutions, give the Hume Rothery rules for substitutional solid solution f...

A:

Q: mine the change in length in metre due to work by surrounding on the system of 15 kJ with

A: Work done = 15KJ = 15*10³J = 15*10³kgm²/s² Force = 300N = 300kgm/s²  

Q: Maisha flour mills obtained wheat from two farmers (50 tonnes each). Farmer A's wheat was at 13% moi...

A: Given that, The weight of wheat from farmer A mA = 50 tonnes The weight of wheat from farmer B mB = ...

Q: A cylindrical tank 24 inches in radius and 2 meters tall initially contains 100 gal of cane juice. A...

A: Given that, The radius of the cylindrical tank r = 24 in = 0.6096 m The height of the tank h = 2 m T...

Q: 2.10-2. Frictional Pressure Drop in Flow of drop in pascal for olive oil at 293 K flowing through a ...

A: T=293K L=76.2m Di= 0.0525m V= 1.22m/s frictional pressure drop=∆P=? Density of olive oil (293K)=0.91...

Q: You are tasked with designing a separator to remove HCl from a gas stream. The feed gas is comprised...

A: Given that  In feed  feed flow rate = 200 mol/hr Feed contain 15% CO2, 4% HCI, and the remainder C3H...

Q: What are the assumptions made for mass transfer in the packed column?

A: Packed column is a distillation column that has packings in some sort of arrangement or in disorder....

Q: At what temperature will a mixture of n-decane and water start to boil at 4 bar of absolute pressure...

A:

Q: 120.3710レ 49.2639 39.066 9 10.1979 45.003 g 44.366 g Molar Mass of Unknown Anhydride Weight of Hydra...

A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve first three sub-...

Q: A gaseous mixture of CH., N2, CO, and O, has the following partial pressures 140 kPa, 55 kPa, 70 kPa...

A: Given that, The Partial pressure of CH4 PCH4 = 140 kPa The partial pressure of N2 PN2 = 55 kPa The p...

Q: (a) CO;(g) + H;(g) =cO«) + H,O{) (b) SnOz(s) + 2 COg) = Sn(s) + 2 CO(g)

A:

Q: degree of freedom

A: Degree of Freedom Analysis is important as it helps in knowing unknown quantities and calculate them...