A manufacturer of aluminium cans measured the level of impurities in 24 cans. The amounts of impurities, in percent, were as follows. 7.1 2.6 8.3 4.6 9.3 5.1 8.3 1.7 6.0 9.2 7.3 6.8 4.4 8.7 7.9 8.0 6.2 8.3 4.8 8.6 9.1 6.5 5.7 9.4 Send data to Excel Part: 0 / 2 Part 1 of 2 Construct a boxplot for the given sample. 2 w. 10 4 5 # 6 X 7 00 8 101 9 10

For each of the following, indicate the scale of measurement that best describes the infor mation.a. In 2008, Dell Corporation had approximately 78,000 employees.b. USA Today reports that the previous day’s highest temperature in the United States was 105 degrees in Death Valley, California. Source: USA Today, June 19, 2009, p. 12A.c. An individual respondent answers “yes” when asked if TV contributes to violence in the United States.d. In a comparison test of family sedans, a magazine rates the Toyota Camry higher than the VW Passat.

Find the test statistic for a proportion "p" given the following information. Malloree ordered 15 pair of shoes online during the stay-at-home order, and 2 pairs arrived with mismatched sizes. Looking on line, she found that the retailer claimed that this happened 4% of the time with online orders. Enter your answer rounded to the thousandths place.

A particular dam contains approximately 1,200,000,000,000 cubic feet of water. For a week-long spike flood, water was released at a rate of 25,700 cubic feet per second. a. How much water was released during the flood? b. What percentage of the dam was released during the flood? a. The amount of water released during the week-long flood was (Simplify your answer.) GOOD b.% of the dam was released during the flood. (Type an integer or decimal rounded to the nearest hundredth as needed.)

Name the scale of measurement for each of the above variables

Find the measures of dispersion and interpret the results

Statistics Question

6. Setup: JP was curious about the sodium content of organic cornflakes. To investigate this, twenty 300-gram boxes of organic cornflakes were obtained and the sodium content was measured. The data (in milligrams) are as follows: 131.1, 130.7, 130.9, 129.5, 129.6, 128.8, 130.7, 128.3, 128.2, 129.7, 130.1, 129.3, 128.7, 129.0, 129.4, 130.4, 129.5, 130.1, 129.8, 130.0 Task: Perform a hypothesis test using R to determine if you can support a claim that the mean sodium content of this brand of cornflakes differs from 130 milligrams? Use a = 0.08 to make your decision. R Output: Upon running your analysis in R, you obtain the following results: One Sample t-test data: corn = 0.1121 t = -1.6659, df = alternative hypothesis: true mean is not equal to 130 19, р-value 92 percent confidence interval: 129.3458 130.0342 sample estimates: mean of x 129.69 Questions: (a) State the hypotheses used in performing this test. (b) Using the output above, state the decision (Reject or Not Reject Ho) of the…

A good shipment of product has 3% defective and a bad shipment has 6% of defective.If 50 samples are inspected and the maximum accepted number of defective is 3 units. Determine the producer’s risk. A. 0.065 B. 0.987 C. 0.935 D. 0.353 Thanks

A manufacturer of aluminium cans measured the level of impurities in  24  cans. The amounts of impurities, in percent, were as follows. 1.5 2.0 2.7 1.3 2.9 6.2 3.1 4.8 3.5 3.7 2.9 3.9 4.1 2.2 4.2 1.9 1.1 4.4 4.9 1.8 5.2 5.8 3.3 2.9       Construct a boxplot for the given sample.