A long pipe carries hot water and loses heat by convection to the surrounding air at Too=16 °C and h=20 W/(m2°C). The pipe has a thermal conductivity of k=1.7 W/(m°C), inner radius of r1=0.2 m and outer radius of r2=0.22 m. Assume that the inner surface temperature of pipe is T1=53°C. If there is no heat generation in the pipe material, calculate the outer surface temperature of the pipe T(r2), in °C, by considering steady one-dimensional heat transfer and constant thermal conductivity. Ch, T∞ I2 T1

A long pipe carries hot water and loses heat by convection to the surrounding air at Too=16 °C and h=20 W/(m2°C). The pipe has a thermal conductivity of k=1.7 W/(m°C), inner radius of r1=0.2 m and outer radius of r2=0.22 m. Assume that the inner surface temperature of pipe is T1=53°C. If there is no heat generation in the pipe material, calculate the outer surface temperature of the pipe T(r2), in °C, by considering steady one-dimensional heat transfer and constant thermal conductivity. Ch, T∞ I2 T1

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

(English Unit) A 100-pound meat is moved to the cold storage room. During preparation for storage, the meat may warm up to 45°F. That means the meat must be cooled to 32°F before it will begin to freeze. The average latent heat of fusion amounts to about 90 Btu/lb for meat. After freezing, the meat is subcooled to the quick-freeze temperature of 14 oF. The meat has a specific heat below and above freezing point of 0.7 and 0.4 Btu/ lb-oR, respectively. Find the total heat removed from cooling BTU.
PLEASE Explain it correctly 6-7 sentences ANSWER IT IN 1hr.
12 According to 1st law of thermodynamics Select one: O heat and work are convertible mass and energy are equal None mass and light are convertible O mass and energy are convertible
(d) The rate of heat generated, Btu/min
Which one of the following processes of heat transfer requires the presence of a fluid? a. conduction b. radiationc. convectiond. none of the above choices are valid
* What is the specific heat of metal if its mass is 27 g and it requires 420 J of heat energy to increase its ?temperature from 25°C to 50°C 0.19 cal/g.KO 62.2 J/kg. °C O 41.90 J/kg. KO 25.4 kg. °C O None of them. O
Tell
AB POWER ENGINEERING Introduction about the cooling system of internal combustion engines use in agriculture, and how cooling system works
A metal spoon and a wooden spoon are left overnight in a room. Why do we feel colder when we touch the metal spoon than when we touch the wooden one? a. Since metals usually have a lower heat capacity than non-metals, the metal spoon loose more heat to the room and consequently has a lower temperature b. Metals release heat faster than non-metals because of their higher thermal conductivity c. This is merely psychological since we are conditioned to think of metals as “cold” d. Metals absorb heat faster than non-metals because of their higher thermal conductivity
I need the answer as soon as possible
The given diagram shows three processes, i.e., isochoric, isobaric and isothermal. The correct sequence of the processes, in the same order is given by Select one: O a. bad O b. dba O c.dab O d. abd
Which of the following will have a higher rate of heat transfer. With conduction heat transfer. A. pulverized shale stone B. the stone and the pulverized shale will have the same heat transfer as they have the same conductivity constant. C. a solid block of shale stone D. the pulverized shale will have a higher heat transfer as it has a higher duction coefficient