A line 100m long was paced by a surveyor for four times with the following data, 142, 145, 145.5, and 146. Then another line was paced for four times again with the following results, 893, 893.5, 891, and 895.5. Determine the length of the line.

A line 100m long was paced by a surveyor for four times with the following data, 142, 145, 145.5, and 146. Then another line was paced for four times again with the following results, 893, 893.5, 891, and 895.5. Determine the length of the line.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: In levelling across a wide river on Pampanga, a reciprocal level reading were taken between points B…

Q: Using the Google Earth Pro application, a BSGE student measured the dimensions of the main academic…

A: Surveys are the procedures used to decide the three-layered places of focuses. It incorporates…

Q: The length of a line was measured repeatedly on three different occasions and probable error of each…

Q: PROBLEM NO.04. The length of a line was measured repeatedly on three different occasions and…

A: To find weighted mean

Q: 14. Shown in the accompanying Figure C are the measured offsets from a traverse line AB to an…

Q: A surveying instructor sent all the 40 students in his class out to measure a distance between two…

A: Most probable value - MPV = x1 + x2 + x3 + .........xnn⇒MPV = 922.11 + 921.24 + 921.86 + 920.99 +…

Q: 2. An archaeologist took some measurements on the unique mountain he had found. He sets two points X…

A: Given: Distance between X and Y =928 m Angle of elevation of peak of mountain from point X=47 ° 10'…

Q: The sides of a rectangular piece of land are measured several times. Only 2 sides are measured since…

A: Given data-

Q: Determine the actual length of line OP?

Q: The distance between point A and B was measured 15 times. The mean of the 15 measurements is…

A: Given data- Sample size n = 15Mean=124.555'Standard deviation σ= 0.500'To Find-The 50% Error E

Q: An unknown line was paced by a surveyor and gathered the following data: 489, 482, 489, and 483. He…

A: Given: The paced data for the unknown line is 489, 482, 489, and 483. The distance of the new line…

Q: Do not copy the answer here in bartleby. Give clear solutions UPVOTE WILL BE GIVEN. Please write…

Q: The length of a line was measured repeatedly on three different occasions and probable error of each…

A: 1st set of measurements = 1201.50±0.02m2nd set of measurements= 1201.45±0.04m3rd set of measurements…

Q: A line’s length has been measured repeatedly on different occasions. The following are the results…

A: Given:- The results obtained after repeated measurement of the line are:- 1st measurement record =…

Q: as computed with the following results: 1st set of measurements = 1201.50 0.02m 2nd set of…

A: Given:- 1st set of measurements = 1201.50 0.02m2nd set of measurements= 1201.45 0.04m3rd set of…

Q: vorking in groups of four came up with 10 different measurements as follows: 920.45, 921.05, 921.65,…

A: Formula used- Em=Es/nand Es=±0.6745∑V2/(n-1)where Es= probable error in single…

Q: b. The surveyor's first reading was to TBM 41 with reading 5.76, she then took the following…

A: First Reading at TBM 41 =5.76 Last Reading at TBM 41 =5.77 Assume the elevation of TBM 41 =100

Q: Datum in the figure, A. Ar elev, eleve and the measured slope length L were 1.634, 1.546, 987.207,…

A: he =1.634 mhr = 1.546 mElevA = 987.207 mElevB = 1006.816 mL = 435.955 m

Q: Given are the interior angles of a heptagon. Determine the discrepancy for the givenobservation and…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: what is the estimated total error? what is the probable total error if the random error is ± 0.006 m…

Q: Problem 1 A distance AB is observed repeatedly using the same equipment and procedure, and the…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: From the following data, perform the required curve fitting: i 1 4 6 3 5 7 9 12 14 9 15 21 27 36 42…

Q: A lake 280 m long had soundings taken at right angles to its length on ranges 60m, 120m, 200m from…

Q: A 100-meter tape weighing 5.08 kg was used to measure a line. It was supported at the end points,…

A: The measurements done with the chain and tape encounter any errors during the due course of the…

Q: 6. A line was measured 5 times with a tape on a windy day with these results: 286.85, 286.96,…

A: Given:- The results of the 5 times line measurement with a tape = 286.85, 286.96, 286.77, 286.80,…

Q: I measure the length of a building 10 times, using a tape measure. Use the following observations to…

Q: Q2) the following table represent the three sets of measurements of the length of a straight line by…

Q: 2. An archaeologist took some measurements on the unique mountain he had found. He sets two points X…

Q: A team of Civil Engineering Students performed a reciprocal leveling along the edge of a dam. The…

Q: Ada, using a steel tape, measured a certain line that is divided into four segments. Each segment…

A: The four parts of line lengths are 97.702 ± 0.05 m, 57.972±0.06m, 75.98±0.042m, 57.015±0.042m

Q: The length of a line was measured repeatedly on three different occasions and probable error of each…

Q: A line is laid out using a 50-m tape. The standard error of each tape length laid out is assumed to…

A: To Determine :- Question 1. The standard error of the length of the line. Question 2. The correct…

Concept explainers

Professional survey

A professional survey is a systematic questionnaire that the target audience fills out online, usually by filling out google forms. Professional surveys can vary in length and format. The data is stored on a website and the testing tool usually provides a certain level of data analysis in addition to a professional expert review. Several professional online survey softwares are present worldwide like, SoGoSurvey, SurveyGizmo, SurveyMonkey, Qualtrics, and so on.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Given values and Formula used

VIEW

Step 2 Solution

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A line 100 m long was paced by a civil engineering student for four times with the following data. 142, 145, 145.5 and 146. Then another line was paced for four times again with the following results: 893, 893.5, 891 and 895.5. a. Determine the pace factor. b. Determine the distance of the new line.
With your pencil, make a dot on the position of your best visual estimate of the centroid of the triangular area. 17.0 13.6 10.2 6.8 3.4 0 0 3.4 (x, y) = (i 6.8 10.2 13.6 Now refer to Sample Problem 5/2 and to Table D/3 and find the exact location of the centroid. 17.0 i )
2. During the measurement at the sides of the slope, the data was recorded into three bays, the following information (Table 1.0) was obtained: Table 1.0 Difference in Tension (N) Temperature (°C) Bay Measured Length (m) level between end (m) 1 25.842 19 +0.285 150 27.365 18 -0.236 120 3 21.645 21 -0.239 160 The 30 meter tape used has a mass of 0.400 N/m and a cross-sectional area of 3.00 mm?. It was standardised on the flat at 20 °C under a pull of 100 N, the actual length was 29.995 m during the measuring works. The coefficient of linear expension for the materials of the tape us 0.000015 / °C and Young's Modulus is 20.5 x 104 MN/m?. Calculate the absolute length of survey line in 3 decimal point. Slope correction = -v² 2s Sagging correction = - w²L³ 24P? Tension correction = (P – Ps) EL AE Temperature correction = a (T-Ts) (L)
Situation 01. In a survey within the catchment area of a lake, Thiessen polygons were established by setting up a transit at Point Z, which is the inner portion of a four-sided lake MNOP. The readings are as follow: BEARING N 40°30' W N 38° E S 70° E | S 60° 15' W | 695.10km RAINFALL, ft DISTANCE 420.35km LINE ZM 0.211 ZN 530.15km 0.26 zo 480.75km 0.239 ZP If the rainfall from the area of bounded by ZMP is the Arithmetic Mean of the other rainfalls, compute the average precipitation (in cm) by Thiessen Polygon Method. Situation 02. Given the following data gathered on December 4-23, 2011, compute for the required inflow (in cu.ft/hr) in order to have an increase in storage of 14cm. Outflow 8.23 cms Seepage Loss 68 mm Precipitation Evaporation 12 cm 2.45 in Area 21.21 sq.mi. Situation 03. Given the following rainfall data, draw the hyetograph, and determine at what time is the highest intensity of the rainfall. Time Rainfall, mm 7:40 2 7:40-7:48 43 7:48-7:56 67 7:56-8:04 87 8:04-8:12 44…
what is the total area? use DMD method
topic: Hydrographic surveying include the ff: a) problem with diagram b) complete tabulation of answers c)computations/solution d) final diagram with unknown variables Determine: The volume of reservoir using prismoidal and end area method. *3 dec places*
2. A lake 800 m long had soundings taken at right angles to its length on ranges 0, 225, 400, 650, and 800 m (measured from one end of the lake). The calculated cross-sectional area of the different ranges are: Ao = 60 sq. m, A225 = 930 sq m, A400 = 640 sq m, A650 = 750 sq m, and As00 = 120 sq m. Compute the total volume of water in the lake.
I need answer within 20 minutes please please with my best wishes
Probable Error - a. b. Example 2 PLANE SURVEYING SU1200 ASSIGNMENT 1 1. The sides of a closed figure have been measured and found to have a total length of 1018.910 m. If the error in the measurement is estimated to be 0.073 m, what is the accuracy ratio of the work? 2. A random error of ± 0.004 m is estimated for each of 22 length measurements (which are to be added together to get the total length). what is the estimated total error? what is the probable total error if the random error is ± 0.006 m per length? 3. A surveying crew or party is capable of taping distances with an estimated probable error of ± 0.005 for each 30.000 m distance. What estimated total error should be expected if a distance of 1400 m is measured? 4. It is desired to tape a distance of 360 m with a total estimated probable error of not more than ± 0.006 m. a. How accurately should 30.000 m distance be measured so that the permissible value is not exceeded? b. How accurately should each 30.000 m distance have…
2. The surveying professor require his student to measure line CD by pacing. In order for the student to provide an accurate length of line CD, he must know his pace factor. The student measured line AB , 45 meters long and walked through for several trials. The following numbers of steps or paces on line AB and CD are tabulated below. On line AB Trial Counted paces 1 72.50 2 72 71 4 72 71.5 On line CD Trial Counted paces 1 285 2 283 284.5 4 282 283.5 Determine the paced distance of line CD b. Determine the Relative Precision of а. measurement if the taped distance of line CD is 178.05 m. LO
With your pencil, make a dot on the position of your best visual estimate of the centroid of the triangular area. 14.0 11.2 8.4 5.6 2.8 0 4.8 Now refer to Sample Problem 5/2 and to Table D/3 and find the exact location of the centroid. 0 (x, y) = (i 1.6 3.2 How close did you come with your guess? 6.4 8.0
An unknown line was paced by a surveyor and gathered the following data: 489, 483, 488, and 482. He then laid out a 100m line and paced it several times. The following data were gathered: 143, 144, 139, 136, and 141. Determine the length (m) of the line.