A lecture room with an area of 50 square meters (5m at the shortest side) accommodates 45 students. The room is being utilized at 7:30am to 7:30 pm from monday to wednesday for 18 weeks( 1 semester). The fixture has a 0.35 coefficient of utilization and maintenance factor of 0.80. B. Compute for the illumination.

A lecture room with an area of 50 square meters (5m at the shortest side) accommodates 45 students. The room is being utilized at 7:30am to 7:30 pm from monday to wednesday for 18 weeks( 1 semester). The fixture has a 0.35 coefficient of utilization and maintenance factor of 0.80. B. Compute for the illumination.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Similar questions

A 120 V, 60 W lamp is to be operated on 220 V, 50 Hz supply mains. For the lamp to operate in correct voltage, calculate the value of (i) non-inductive resistance and (ii) pure inductance (U.P.T.U. 2005–06)
At what height are the telephone outlets in this residence mounted? Give measurement to center. _____
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
POWER SISTEMS high voltage technlque it is possible to measure pulsed (AND ANSWER THE SAME QUESTION FOR AC AND DC ) high voltages with the help of two spheres of equal radius placed on the same axis. In which case the approxlmate pulse voltage for pulse hlgh voltage , approxlmate voltage value for DC voltage , AND effective value for AC VOLTAGE voltage value that can be measured with such a system with diameters of 500 mm and known spacing between them is 2.5 cm, is given correctly. (Ambient conditions are neglected and take Ed = 30 kV / cm2 k = 0.9) a) 68,65114 kV b) 81.30081 kv c) 97,08737 kv d) 65,35947 kv e) 57.48835 kv f) 46.21612 kv PLEASE ANSWER THE THREE EQUESTION AND THE OPTIONS ARE THE SAME approxlmate pulse voltage for pulse hlgh voltage, approxlmate voltage value for DC voltage , AND effective value for AC VOLTAGE
08. Consider a solar PV system with Number of PV modules: 4 The number of PV cells in one PV module: 28 Arca of cach PV cell= 134 cm (take insolation valuc as 1150 W/m and efficicncy as 15% ) For the connection schemes a &b, Calculate the following for the PV Panel: a) If the Four PV modules are connected in Scrics: a) Total output power b)Total output voltage c)Total output current
Calculate the capacitative reactance and the voltage in each point. Also calculate the current and the impedance.
For a system if the value of peak overshoot is 16 %, then the value of damping ratio o is
Refer to the figure below in which surge protectors p and q are used to protect an expensive high-definition television. If there is a surge in the voltage, the surge protector reduces it to a safe level. Assume that each surge protector has a 0.94 probability of working correctly when a voltage surge occurs. Complete parts (a) through (c) below. TV Series Configuration Parallal Configuration a lf the two surge protectors are arranged in series, what is the probability that a voltage surge will not damage the television? Do not round.) b. If the two surge protectors are arranged in parallel, what is the probability that a voltage surge will not damage the television? (Do not round.) c. Which arrangement should be used for better protection? O The series arrangment provides better protection because it has a higher probability of protection. O The parallel arangment provides better protection because it has a lower probability of protection. O The series arrangment provides better…
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
Electrical engineering problem
18/1.A. Draw the phasor diagram, also write the voltage and current relation statements for the following circuits (i) pure resistor (ii) pure inductor (iii) Resistor and inductor connected in series.
Which of the following statement is true? a. Angle between load voltage and load current in a pure capacitive load is 45 degree. b. Angle between load voltage and load current in a pure capacitive load is is 180 degree. c. Angle between load voltage and load current in a pure capacitive load is is zero. d. Angle between load voltage and load current in a pure capacitive load is is 90 degree.