A hydro station has a water discharge of 550 cubic meter/hour. The head of the water in the dam is 25 m with total efficiency of 80 %. The power generation of the station is * 29.94 kw 107800 kw 45.87 kw 205764 kw Non of them

A hydro station has a water discharge of 550 cubic meter/hour. The head of the water in the dam is 25 m with total efficiency of 80 %. The power generation of the station is * 29.94 kw 107800 kw 45.87 kw 205764 kw Non of them

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.28P: For the system shown in Figure 3.34. draw an impedance diagram in per unit by choosing 100 kVA to be...

See similar textbooks

Related questions

Q: The load on an installation is 800 kW, 0.8 lagging power factor which works for 3000 hours per…

Q: A Hydroelectric Plant has a Turbine and Generator with an efficiency of 63%. If the dam has a Head…

A: To find the power generated in the hydroelectric power plant First convert all data in SI Unit

Q: A Hydroelectric Plant is supplied from a reservoir having a capacity of 2 X 106 cubic meters with a…

Q: 1. A hydroelectric station generate power from a reservoir of capacity 4 x 10° m at a head of 50 m…

Q: Explain the THREE impacts of power factor improvement device can augment the kW capacity of a…

A: Power supply by any generating systemS⇀g=Pg+jQgKVA rating of generatorSg=Pg2+Qg2Here KVA rating of…

Q: The domestic load in residential building is used in the following manner Fluorescent lamps 55 watt…

Q: In the calibration of single-phase, energy meter, find the value of Eactual in watthour for the…

A: In the calibration Value of the all parameters are given. What is value of actual energy?

Q: It is desirable to improve the power factor of a 150 kW load from 0.8 lagging to 0.85 lagging. The…

A: Given load P1=150 kW cos ϕ1 =0.8 cos ϕ2 =0.85

Q: A hydro-electric generating station is supplied from a reservoir of capacity 6000000 m at head of…

Q: 17. What is the share of renewable energies on the total electrical energy generated for 2019/2020?…

A: Introduction:. Electricity is produced using all sources of renewable energy. Geothermal steam is…

Q: Q2. The three unit power plant has with the following cost functions: h = 0.52P,² + 220P, + 5100 Sh…

Q: A hydro station has a water discharge of 550 cubic meter/hour. The head of the water in the dam is…

A: Electricity is generated using conventional and renewable energy resources like solar, hydro,…

Q: In a typical power system in Oman, Power stations has . . Which converts to and the generated…

A: In a typical power system in Oman , power stations has alternators which converts mechanical energy…

Q: A hydropower station has a gross head of 13.8 meter Head loss in water conductor system is 1.1…

A: Given: A hydropower station has a gross head of 13.8 meters Head loss in a water conductor system is…

Q: 1. Write an conclusion about Electrical Wiring Installation for Electrical Supply System belong from…

A: Here we need to write the conclusion and objectives about Electrical Wiring Installation for…

Q: A 75 MW steam power station uses coal of calorific value of 6400 kcal/kg. Thermal efficiency of the…

A: Given data, Capacity of thermal station P = 75 MW, Calorific value = 6400 kcal/kg, Thermal…

Q: 10.a. What's the heating or A/C load for a nine-unit multifamily dwelling that contains a 6 kW, 240…

A: 10. (a) We have 8 kW,240 V heating unit in each of 9 dwelling units. So, total power P1=9× 8kW…

Q: 1.2 A hydro-electric power station is used to supplement the unmet constant load demand for 2 hours…

A: Given: A hydroelectric power station is used to supplement the unmet constant load demand for 2…

Q: Consider a house that has a 120V mains with mains frequency of 60hz and a service current of 100A,…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The domestic load in residential building is used in the following manner : Fluorescent lamps 55…

Q: Two systems have a continuous load of 105 MW. Find the expected load loss (ELL) of each system if…

A: It is given that : Two systems have a continuous load of 105MW. a) hydro generators =6 units The…

Q: What is the reserve capacity, if the maximum demand of generation of power is 50 MW, the load factor…

A: Given, Maximum demand is 50 MW. load factor is 60%. Plant capacity factor is 50%.

Q: A hydro station generate 255000 kwh for one day. The water discharge of the station is 43 cubic…

Q: A newly constructed hydro-electric power station has an average annual rainfall of 193 cm. The…

A: Given Catchment area A= 260 km2 Avg annual rainfall =1.93 m head H=32 m efficiencies ηT =78 % ηG…

Q: A power station has two 50MW units each running for 8500 hours in a year and one 30 MW unit running…

Q: 2. A generating unit of 10 MW capacity supplies the following loads: Domestic consumers with a…

A: Since you have posted multiple different question. we will solve the first question for you. To get…

Q: A 132MW generator sends power to an industrial load at 132kV, 500A, Unity power factor. Excluding…

A: An alternator/synchronous generator is a type of electrical machine that converts mechanical energy…

Q: C- If the annual energy generated in the generators of the hydro station is 2.86x10 Kw/h with an…

A: Annual energy is given E=2.86×108 Kw/h=2.86×108×3.6×106=10296×1011 J Density if waterd=1000 kg/m3…

Q: write only the option The electrical power is delivered to the users through five distribution…

A: Some statements are given. We need to choose the correct option regarding to each of the statements…

Q: :Calculate the demand factor for a building with the following Electrical Loads Lighting = 367 w Air…

A: Given, The electric loads of a building are Lighting, 367 W Air conditioner, 6.7 kW Appliances, 4.8…

Q: ) Wind farm consist of ten wind turbines with nominal capacity of 2MWper turbine, has a total of 20…

A: Capacity factor =Average load / installed capacity. Average load = no. Of units produced / no. Of…

Q: A power station has a load cycle as under: 260 Mw for 6 hours; 200 mw for 8 hours; 160 Mw for 4…

Q: A hydro station generate 255000 kwh for one day. The water discharge of the station is 43 cubic…

A: Above given question is based on Hydro power station. A hydro power plant uses the kinetic energy of…

Q: What is the Total Actual Energy Generated by Davao Power Plant if there are (4) substation with 1.12…

Q: A substation rated 1250 kVA is operating at full load at 0.8 pf lagging and to carry an additional…

A: Capacitor banks ,synchronous phase modifiers are used to increase the power factor of the system. By…

Q: What is the dryer demand load in KW for a 25 unit Multi-family dwelling with a 4.5 KW clothes dryer…

Q: A small industry takes a steady load of 350 kW at a lagging power factor of 0·707 for 3000 hours a…

Q: Low power factor has some adverse impact on both the transmission line and on the consumer…

A: “Low power factor has some adverse impact on both the transmission line and on the consumer…

Q: g period. Peak demand is typically measured at 400 kW during the day and 200 kW at night. However,…

A: Service charge for 3 phase is P518. Energy Charge , Total Energy consumed = 126000kWh total energy…

Q: 2. Explain the relation between the output power and system efficiency. ppoprate teesn for the…

Q: The weekly discharge of a typical hydroelectric plant is as under: Day Sun Mon Tues Wed Thurs Fri…

A: Given, The weekly discharge of a typical hydroelectrical plant is as under, Plant has an effective…

Q: uestion 1 The number of units consumed in a year by a consumer with a yearly average load of 80 kW…

A: Solve

Q: A dc transmission facility is modeled by the approximate series circuit shown below. If the load…

A: By ohms law Current in resistor R = Voltage across resistorResistance. Power loss in resistor R = (…

Q: What is the reserve capacity, if the maximum demand of generation of power is 50 MW, the load factor…

A: Given, Maximum demand MD=50 MW. Load factor LF=60%=0.6. Plant capacity factor PCF=50%=0.5.

Q: A hydro station generate 255000 kwh for one day. The water discharge of the station is 43 cubic…

A: Given: For a hydroelectric power station, η=70% Energy generated in one day, E=255000 kWh Water…

Q: Energy produced in a power station is 1440 MWh per day. What is the maximum demand of the station if…

A: Given data: Energy produced in power station = 1440 MWh per day Time period = 1 day = 24 hour Load…

Q: Calculate the total electrical energy consumed for a load usage of 6 lamps (9 watts each) for 6 hrs…

A: Lamps = 6 Power rating 9w Total power = 9*6 = 54w Time 6 hours Energy = 54*6= 324 wh

Q: Solar panel measurement is continuous; one side is about 10 meters and the other is about 16 meters.…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Concept explainers

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.

Question

A hydro station has a water discharge of 550 cubic meter/hour. The head
of the water in the dam is 25 m with total efficiency of 80 %. The power
generation of the station is *
29.94 kw
107800 kw
45.87 kw
205764 kw
Non of them

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A power supply A delivers 10 V dc with a ripple of 0.5 V r.m.s. while the power supply B delivers 25 V dc with a ripple of 1 mV r.m.s. Which is better power supply ?
5. A three-phase rectification system has a voltage ripple of 14%. If the output kVp is 150, what is the minimum voltage? a) 129 kvp b) 14 kVp c) 86 kVp d) 21 kVp e) 10.7 kVp
What is the reserve capacity, if the maximum demand of generation of power is 50 MW, the load factor of the plant is 60% and the plant capacity factor is 50%?
The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base Voltage is 600 V and Base Power is O 6000 VA O 2000 VA O 4000 VA 8000 VA
A hydro station has a water discharge of 550 cubic meter/hour. The head of the water in the dam is 25 m with total efficiency of 80 %. The power generation of the station is 29.94 kw O 107800 kw O 45.87 kw O 205764 kw O Non of them O
5-A Load of particular kVA is drawing a current which lags behind the voltage at an angle of 75.43 degrees. The operating power factor is __________ . a. 0.5958 b. 0.2515 c. 0.6122 d. 0.6511
The actual impedance of a load is 10 OHM. The new per-unit impedance of the load is 0.5 pu when Base Voltage is 200 V and Base Power is O 4000 VA O 8000 VA O 6000 VA O 2000 VA
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. What is the minimum AC voltage rating of each capacitor? Answer is 1200 volts. What is the current flow through the circuit? And what is the minimum kVAR rating of each capacitor?
Which statement is wrong ? High load factor of a generating equipment Ogives more profit to owner leads to lesser charge per Kwh can be obtained by accepting off peak loads implies lower diversity in demand
A sinusoidal current has a rms value of 3 amperes, its maximum value will be ______. 2.1213 amp 4.2426 amp 3.46 amp 0.866 amp
A generating station has a daily output of 280 MWh and uses 500 tonnes of coal in process. The coal releases 7 Mj/kg when burn. Calculate the overall efficiency of the station
7. A power station has to meet the following load demand: Load A 50 kW between 10 A.M. and6 P.M. Load B 30 kW between 6 P.M. and 10 P.M. Load C 20 kW between 4 P.M. and 10 A.M. Plot the daily load curve and determine (i) diversity factor (ii) units generated per day (iii) load factor. () 1-43 (ii) 880 kWh (iii) 52-38%]