A house has the following electrical appliance usage: Four 60W incandescent lamp used during 3 hours per day. one 100W refrigerator that runs during 24 hours a day with the compressor turned on half of the time. The standalone PV system is planned. The system will be powered by 12V, 120W PV panels. 1) Find the energy demands per day. 2) Find the number of the required PV panels. 3) Find the size of the required inverter. 4) 12V batteries will be used, considering an efficiency of 80 percent and a depth of discharge of DOD of 60 percent. Find the Ampere hours required to ensure three days of autonomy.

A house has the following electrical appliance usage: Four 60W incandescent lamp used during 3 hours per day. one 100W refrigerator that runs during 24 hours a day with the compressor turned on half of the time. The standalone PV system is planned. The system will be powered by 12V, 120W PV panels. 1) Find the energy demands per day. 2) Find the number of the required PV panels. 3) Find the size of the required inverter. 4) 12V batteries will be used, considering an efficiency of 80 percent and a depth of discharge of DOD of 60 percent. Find the Ampere hours required to ensure three days of autonomy.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4) A 10 KW, 74 V variable speed wind generator is providing power to the grid through a three-phase six pulse bridge converter, a DC link capacitor of 2 F, and an inverter. If firing-angle of the converter is 0 degree, calculate the energy storage in the dc-link capacitor. Calculate the grid voltage. 5) In problem 4, why was the converter-inverter used? If the converter-inverter was not used, how would it affect the grid voltage and frequency?
Advanced equipment 14. The equipment grounding conductor of a PV solar system that bonds to the framework of the solar panels must be sized slightly larger than expected, since the A. panels are mounted outdoors and may be prone to corrosion over their lifespan.B. AC inverter system on a utility connected system can backfeed energy into the panels.C. panels may be contacted by metal ladders during service work or during repair of the roofing structure. D. lower output current levels may cause the overcurrent device to take longer to trip.
4) A 10 KW, 74 V variable speed wind generator is providing power to the grid through a three-phase six pulse bridge converter, a DC link capacitor of 2 F and an inverter. If firing-angle of the converter is 0 degree, calculate the energy storage in the dc-link capacitor. Calculate the grid voltage.
for solar PV while module heat up ! Voc is unstable ( increase and decrease ) why this happen ? Isc is increase or decrease and Why ? ..
66 For which environmental factor(s) can the expected dc current of a PV array be accurately calculated using the module nameplate current value? Irradiance Irradiance and temperature Change in temperature D Wind speed 67 Which PV system component ovides performance analysis information? A Inverter B Irradiance meter Service meter D Charge controller 68 What is the MOST common maintenance issue for low-tilt PV arrays in dry climates? Corrosion Loose connections Shattered glass D Soiling 69 What is the OSHA-regulated MAXIMUM distance to an eyewash station when working on flooded lead-acid batteries? 10 ft. 15 ft. C 20 ft. 25 ft.
Draw a simple single line diagram of a grid tied PV system with at least two inverters, showing all the different components involve in generating, converting, and Transmitting power. Label appropriately.
3)This MCQ QUESTION FROM BASIC POWER ELECTRICAL ENGINEERING course.
How to obtain Vth? For below diagram Do solution
What are the advantages of using trans- formers and transformer rectifiers vice inverters and dynamotors for supplying air- craft power? What power system requirements do modern naval aircraft have?
With the aid of well labeled diagrams, explain the principle of operation of: a. a pyranometer. b. a wind turbine, from resource to electrical power
6. The battery bank in DC microgrid may act as 7. Microgrid may allow the 8. The per unit kilovolt ampere rating would be is 450 with 0.8 power factor lag. 9. If the voltage of the photovoltaic string is 650 V and the maximum power point voltage is 45.10 V the modules in the string would be expected as of distributed generation resources. if, actual is 320 and base 10. The voltage output of direct current dc-converter is 488.8 V with the duty ratio of 0.55 the feed-in voltage would be
12. A grid-connected installation consists of three components: a. PV array , storage battery and power supply. b. PV array , inverter and power supply. c. PV array ,inverter and storage battery