A group with 10 elements of the same radiating point elements separated by a distance of d= 5.0 λ angle 10 = 0, if you know that the frequency used is 1.3GHz and the phase difference between the elements resulting from the current 8= 5, the value of the group factor is

A group with 10 elements of the same radiating point elements separated by a distance of d= 5.0 λ angle 10 = 0, if you know that the frequency used is 1.3GHz and the phase difference between the elements resulting from the current 8= 5, the value of the group factor is

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A typical single mode optical fiber has a core of diameter 8 mm and a refractive index of 1.46.…

Q: Question 4: Determine whether or not the following signal is periodic. In case the signal is…

A: A discrete signal is given byx[n]=cos(πn2)−sin(πn8)−3cos(πn4+π3) ;We need to check the periodicity…

Q: An EM wave comes from air to a surface with a relative dielectric value of 90. What is the angle of…

Q: What will be the frequency corresponding to a wavelength of 4 m?

A: In this case, the frequency corresponding to a wavelength of 4 m is to be determined.

Q: As per de Broglie's relationship, the wavelength 2 related to its mass m and velocity v is h (A) mv…

A: From Einstein energy-mass relation E=mc2 And from Plank's theory E=hν Here ν→Nu and ν=cλ

Q: Two beams of light start together and then hit a slab of two different kinds of material. This will…

Q: Find Flw) for the foilowing Sunctions und plet their spectrum. t. -2 -1 -- (b)

A: The Fourier Transform is a handy image processing method for separating sine and cosine components…

Q: Microwave Engineering 9 The radiation resistance of a circular loop of one turn is 0.01 Q. The…

A: Given- Radiation resistance of a circular loop, Rr1=0.01Ω, To find - Radiation resistance of five…

Q: Given that H= 0.5e*lr sin(10ʻr – 2x)a, A/m, which of these statements are incorrect? (a) a = 0.1…

A: Wave is function of space and time. Frequency below which attenuation occur and above which…

Q: What is the element and its value in box X to set the angle of the source current to (- 14°) for any…

A: Given circuit: Taking m=31, S1 will be: To find: What is the element and its value in box X to set…

Q: A fiber has an index of refraction of 1.5 for core and 1.44 for cladding. Determine the critical…

A: Given data : index of refraction for n2=1.5 index of refraction for n4=1.44

Q: E = (10 a, + 5a,) cos(w! + 2y – 42) V^ Determine

Q: The gain of a parabolic reflector antenna is 1000 when the frequency is 300 MHz. If the mouth of the…

A: The gain of a parabolic reflector antenna with a circular aperture mouth can be expressed as…

Q: Two light beams are incident normal to one surface of a triangular prism with refractive indexn=1.4…

Q: What would be the depth of penetration for copper at 1 MHz frequency with σ = 5.8 x 10?

A: Not required

Q: O Determine the smallert height that an infinitertinal dipole must be ploce above PEC with null…

A: We need to determine the smallest height that an infinitesimal dipole must be placed above PEC with…

Q: A parabolic reflector has a beam-width of 4 degrees and has an antenna efficiency of 90%, what is…

A: Solution Given data Efficiency =90% Gain =3DB Determine: here find gain at 3 db mark.

Q: The electric field strength impressed on a half wave dipole is 6 mV/m at 60 MHz. The maximum power…

A: First we will find out average power density from given electric field then we will find out…

Q: Steps to find the reflection coefficient of the electrically transverse wave in terms of (O . 0) ?

Q: EX The normalized radiation intensity of antenna is defined by U(0) = sin(0) find the HPBW FN B W

A: The given problem is from antenna theory. The detailed solution is given in the next step

Q: Q6: The results of standing wave pattern are measured in the table below: position 20mm Pmax Pmin 1s…

A: Given, Pmax=-25dB-25dB=10log10(Pmax…

Q: Mechatronics 9. A=0 B=1 C=1 D=1 A B X 10. A = 1 B = 0 C = 1 D = 1 E = 0 11. A = 1 B = 1 C = 1 D = 1…

Q: Let y1 and y2 be the wavefunctions of two interfering waves. In which of the listed cases, the…

A: given interference wave

Q: A ray of light is shown being reflected at the surface of a material. If the reflected ray is…

A: Although, formula of refraction index of material is given by u=taniForm given…

Q: Calculate the value of frequency at which an electromagnetic wave must propagate through the…

A: Given that, μ=0.2 Electron density N=4.28*105 Electrons/m3 As, μ=(1 - 81.45N) /f2 ]1/2 0.2=(1 -…

Q: A laser beam with A0 = 550 nm is striking the surface of a pond at an angle of 50°. The pond water…

Q: According to the book the answers are (a) 6 x 108 m/s, (b) 1.5 x 108 m/s, (c) 13.04 GHz, (d) 2.65…

Q: . If two coherent light beams can create interference patterns, which of following condition is not…

Q: A beam of light in air hits a stack of three slides with thicknesses of 2d, d and d and refractive…

A: Illumination problem on electrical engineering. Look below for the solution once.. Option A is…

Q: In simulating JFET characteristic curves, what DC voltage supply do you need to adjust to see the…

A: JFET stands for Junction Field-Effect Transistor. It is a three-terminal voltage-controlled unipolar…

Q: In the satellite C Band ( 6GHZ / 4GHZ), the first frequency 6 GHz represents the frequency.

Q: find the current required to radiate a power of 100W at 100MHz from 0.1 herztian dipole

A: Given, P= 100 W dL= 0.1 m f= 100 MHz

Q: An antenna has a loss resistance of 25 ohms and the total resistance of 55 ohms. What will be the…

A: Given information: The total resistance of the antenna is RT=55 Ω The loss resistance of the antenna…

Q: The return loss of a device is found to be 20 dB. The voltage standing wave ratio (VSWR) and mag…

A: The solution can be achieved asfolows.

Q: What will be the frequency corresponding to a wavelength of 4 m?

A: In this case, the frequency corresponding to a wavelength of 4 m is to be determined.

Q: 75-ohm transmission line of 2m length is connected to a half-wave dipole antenna at the transmitting…

A: Transmission Line:

Q: The following switching functions are to be implemented using a decoder, so the equipment's required…

Q: What will be the frequency corresponding to a wavelength of 4 m?

A: In this case, the frequency corresponding to a wavelength of 4 m is to be determined.

Q: of page M 00 NOMOTO +

Q: An EMF source has an internal impedance of 100+ j0 ohms, and EMF of 3 V. Using Zo= 50 , find the…

Q: If your cellphone camera needs at least 1000 photons per second to detect light of wavelength 481…

A: Given, n = number of photons detects per second =1000 h = planks constant =6.626 ×10-34 J.s. c =…

Concept explainers

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.

Question

A group with 10 elements of the same radiating point elements separated by a distance of
d= 5.0 A angle 10 = 0, if you know that the frequency used is 1.3GHZ and the phase
difference between the elements resulting from the current 8= 5, the value of the group
factor is
O 2.347
О 3.35
О 3.5
O 5

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

show soln
A multimode step index fiber has a relative refractive index difference of 1% and a core refractive index of 1.5. The number of modes propagating at a wavelength of 1.3 µm is 1100. Estimate the diameter of the fiber core.
If the solid angle subtended by the main beam of an antenna is 0.5 steradian then what will be the directivity of the antenna?
(7.15* Microwaves of frequency 3 x 10¹0 Hz are beamed directly at a metal reflector. Neglecting the refractive index of air, determine the spac- ing between successive nodes in the resulting standing-wave pattern. odsalsups qolavas s srli yo 7.16* A standing wave is given by yo babivib sqolevis abutilqms gaisd E = 200 sin7x cos 3nt Determine two waves that can be superimposed to C.E.A sugh Is M generate it. ubor
h.w. 1- A meniscus lens has a convex surface whose radius is 20 cm and a concave surface whose radius is –30 cm. What is the focal length if the refractive index is 1.54?
Wave propogatiaon
Determine the angle by which vi lags iz if vi = 34 cos (10t + 125°) volts and i= 5 sin (10t - 19°) amperes.
Step by step detailed soln.