) A glass manometer with oil as the working fluid is connected to an air duct. Which of the following picture is CORRECT? a or b 2) A device measured stagnation pressure is called? a) barometer b) Piezometer c) Pitot tube d) manometer

Q: Question 1 a) List out 3 devices to measure hydrostatic pressure. Explain how U-tube manometer can…

A: Hydrostatic pressure- It is defined as the pressure in which exerted by a fluid at rest due to the…

Q: Problem 2-53 A differential manometer shown is measuring the difference in pressure two water pipes.…

A: Given that:                     Indicating liquid, GHg=13.6h1=675 mmhm1=225mmhm2=300 mm   NOTE : As…

Q: As the engineer on the job, you are tasked to determine the pressure drop across an orifice (an…

A: Density of water = 1000kg/m3  h1 - h2 = 200mm = 0.2m

Q: A calibration test of a 12.7mm circular sharp edge orifice in the vertical side of a large tank…

A: Discharge Q is given by ; Q = Cd A 2 g h Cd = QA 2 g h 589 N in 81 sec So ; Divide by density of…

Q: A venturi-meter having an entrance diameter of 300 mm and throat diameter 200 mm is used to measure…

A: Given diameter entrance =300mm throat diameter = 200 mm cofficient of discharge = 0.96 venturimeter…

Q: E A pump is installed in a pipeline of diameter of 0.2 m. Close to the pump gauges are installed on…

A:

Q: choose the correct answer A clean tube of diameter 0.5 mm is immersed in a liquid with a…

A:

Q: The speed of the air passing through a pipe with a small diameter section of 10 cm2 is 4.12m / s.…

A: Given, area of section A1 = 10cm²                             Air speed v1 = 4.12m/s Now,  Magnified…

Q: 8. A vertical Venturi meter, 150 mm in diameter is connected to a 300-mm diameter pipe. The vertical…

A: Venturi meters generally flow measurement instruments that use a converging section of make an…

Q: determine the discharge in the system assuming no head loss.

A:

Q: A Venturimeter having a throat diameter d2 of 100 mm is fitted into a pipeline which has a diameter…

A: The given data is as follows: Throat diameter, d2=100 mmDiameter of pipeline, d1=250 mmSpecific…

Q: A vacuum gauge connected to a chamber reads 5.8 psi at a location where the atmospheric pressure is…

A:

Q: A gasoline line is connected to a pressure gage through a double-U manometer, as shown in figure. If…

A: Pgage=370kPa To find gage pressure of gasoline

Q: connects two pressure pipes A and B. Pipe A contains carbon tetrachloride having specific gravity…

A:

Q: In a venturi nozzle flow, the inlet conditions are p1 = 08 x 103 kPa gauge and d1 = 100 mm and the…

A: GIVEN: P1=8×103 KPad1=100mmP2=0 KPad2=50 mm cd=0.98

Q: A closed vessel 5m high contains 2.9m of oil (SG=0.762). A 90mm diameter orifice is situated 0.3m…

A:

Q: 39 mm Venturi meter (C = 0.96) is installed in a 78-mm-diameter horizontal pipe carrying oil having…

A:

Q: A 50 mm Venturi meter (C = 0.98) is installed in a 75 mm diameter horizontal pipe carrying oil…

A: Schematic diagram of the given problem: D1= 75mm D2 = 50mm Sm (specific density of manometric…

Q: A venturi meter with 150 mm diameter at inlet and 100 mm at throat is laid with its axis horizontal…

A:

Q: Soda ash liquor having 1250 kg/m³ density and 1.2 cP viscosity flows through a 215m length of a…

A: Given: The density of soda ash liquor is 1250 kg/m³. The viscosity of the flow is 1.2 cP. The length…

Q: Two pipes are connected in parallel. One pipe is twice the diameter of the other and three times…

A: Two pipes are connected in parallel, Taking that diameter of 1st pipe is d, diameter of the second…

Q: Define the coefficients used in connection with the flow through orifices. Explain why these…

A:

Q: A differential gauge was attached to a venturi meter. The deflection of mercury is 14.3 inches.…

A:

Q: In a test to determine the discharge coefficient of a 50 mm by 12.5 mm Venturi meter the total…

A:

Q: The air-oil-water system is shown in figure. If gage A reads 17psi absolute and gage B reads 2.2psi…

A:

Q: Q: A simple manometer is used to measure the pressure of water flowing in a pipe line. Its right…

A:

Q: 2 in. by 6 in., is installed in a vertical pipe line carrying water. A differential manometer…

A: Given:- 12 in by 6 in gauge levels=2.50ft Venturi coefficient =0.97 To find:- actual discharge

Q: How fast must be the U-tube shown be rotated about y-axis so that the difference of mercury levels…

A: Given:  y1-y2 = 30 cm = 0.30 m x1 = 0.4 m  x2 = 0.2 m

Q: A horizontal venturimeter with inlet diameter 200 mm and throat diameter 100 mm is used to measure…

A: Venturimeter is used to measure the flow rate in a pipe. Formula for rate of flow Q=CdA1A2A12-A222gh…

Q: An oil of specific gravity 0.82 is flowing through a horizontal venturimeter fitted to a 278 mm…

A:

Q: A cylindrical tank contains water at a height of 55 mm, as shown. Inside is a smaller open…

A: Consider the free body diagram

Q: A fluid is flowing in a pipe 8 inches in diameter with a me an velocity of 10 feet/second. The…

A: Given data: Diameter of the pipe = 8 inch=0.667 feet Velocity , v= 10 ft/s Pressure, P=5 psi=720…

Q: 50 mm size is fixed in a horizontal pipe carrying water. The pressure gauge at entry read 137.34…

A: Pressure at entry =137.5kNm2Pressure at Throat=-0.375×13.6×9.81=-50.031kNm2Change in pressure…

Q: An open, clean glass tube, having a diameter of 2.8 mm, is inserted vertically into a dish of…

A: \\\\\\\\\\\\\\\\\\

Q: Q3) A differential manometer is connected at two points A and B of two pipes. The pressure at A and…

A: Given:- The pressure at point A (PA) = 1 bar  The pressure at point B (PB) = 2 bar The specific…

Q: The actual pipe length of diameter 80 mm is 66 m. Along the pipe there are two 90° elbows, one globe…

A: The given data is: Pipe length, L=66 m Diameter of pipe, d=80 mm

Q: A 100 mm diameter orifice discharges 45.34 Li/s liquid under a head of 3.60 meter. Using a Vernier…

A:

Q: Problem 5. For the setup shown, a manometer was attached from a tank into a pipe. Assuming standard…

A:

Q: A closed cylindrical tank measures 12 ft height and 5 ft in diameter. It has to contain water with a…

A: first, find the angle of the cylindrical tank then find the area of cross-section Also, find the…

Q: A pressure gauge at elevation 12m at the side of an open tank containing a liquid reads 80 kPa.…

A: To calculate the height of liquid in an open tank, pressure corresponding to elevation is given.  We…

Q: Design the chilled water pipe system shown in the figure and calculate the power of the pump. Take…

A: Discharge is the main quantity in any sector that is used to transfer fluid from one place to…

Q: A gas under pressure of 12.868 bar abs at 40°C. a. compute the pressure in kpa b. compute the gage…

A:

Q: A venturimeter wth a throat diameter of 10 cm is connected to a 20 cm diameter main (0.1V3 carrying…

A: Given  Head loss between inlets and throat = 0.1v²/2g Throat diameter =10cm

Q: Draw neat sketches of the following and label them. A. Barometer B. Differential U-tube manometer C.…

A:

Q: 6. What type of indicator device is used nowadays? a) Digital pressure indicator b) Mechanical…

A:

Q: U-tube manometer is connected to a closed tank containing air and water is shown. At the closed end…

A:

Pressure and Stress