A given shunt generator delivers 430 A at 240 V and the resistance of the shunt field and armature are 60 Q and 0.02 respectively. Calculate the armature voltage drop. sh 600 1=430 A 240 V Load

Q: Find out the Z transform of the unit step function. Show all calculation steps.

A: In this case, the Z transform of the unit step function is to be determined.

Q: a) Justify that the impulse response h(t) of the system is unbounded. b) Now, consider the following…

A: Given: 1. 2.

Q: Simplify the following functions, and implement them with two level NAND gate circuits: F (A, B, C,…

A: It is given that: F (A, B, C, D)=A′B′C′D+CD+AC′D

Q: der the following signal x[n] as ibed below: = 28[n8] 3 d[n -6] + [n- 4]-38[n-2] +2.6 Use the DTFT…

A:

Q: 1. The speed of a motor falls from 1100 r.p.m. at no-load to 1050 r.p.m. at rated load. The speed…

A: Given data, No load speed Nnl=1100 rpm Rated speed Nfl=1050 rpm

Q: How much energy is stored in the electrical fields in the capacitors (in total) shown below? (b) Is…

A: It is given that: C1=3.0 μF=3×10-6 FC2=6.0 μF=6×10-6 FC3=3.0 μF=3×10-6 FC4=3.0 μF=3×10-6 FV=400 V

Q: : In residential house, the following are the loads connected; 55W fluorescent tubes - 4 Nos.,…

A: We have an load connection of residential house as given in the question   We have to determine the…

Q: b) Suppose that the two-wattmeter method is used to measure the total power of three-phase…

A: Given, In measurement using two watt-meter method, the watt-meter readings are P1=+3750 WP2=+2350 W…

Q: A half-wave rectifier has a source of 120 V rms at 60 Hz and an R-L load with R=10 2 and L= 10 mH…

A: By passing either the negative or positive half-cycle of the waveform and blocking the other, a…

Q: Which memory storage is widely used in PCs and Embedded Systems? a) EEPROM b) Flash memory c) SRAM…

A: The correct option along with the explanation is provided in the following section.

Q: U₂ (1) C * R Op-amp vo (1) •Find vo(t) if vi(t)=In(2t)sin(2t) mV.

A:

Q: A 20-hp, 110 V DC shunt motor has an efficiency of 88% and the exciting current of 4 amperes and an…

A:

Q: Given x[n] = a"u[n] →→ X(e) = Then the DTFT of x[n] = ()"u[n] is Select one: O X(ej") = 1 Fr O…

A:

Q: An annoying thing about CMOS is that it is naturally inverting so if you wanted to implement a…

A: Given that CMOS has the unpleasant tendency to invert automatically in this situation if we wished…

Q: 2. Consider the signal given below x(t) = 2sin2t (a) Write down the signal Fourier series…

A:

Q: In the lossless transmission line system shown, the switch S is closed at t = 0. a. Find the…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 2. Consider the signal given below x(t) = 2sin2t (a) Write down the signal Fourier series…

A:

Q: A 110-V shunt generator has a full load current of 100 A, shunt field resistance of 55 Ω and…

A:

Q: conductivity

A: Given :- Conductivity of material. To find :- Factor not affecting the Conductivity of material.…

Q: . Determine the value of h(0)

A:

Q: Apply the junction rule to junction b in Figure. Is any new information gained by applying the…

A: The circuit is shown below:  At node b, the incoming current is I1 , the outgoing currents are I2…

Q: A shunt generator delivers 195 A at a terminal voltage of 250 V. The armature resistance and the…

A: Given a DC shunt generator with, Load current, IL=195 A Terminal voltage, Vt=250 V Armature…

Q: vo resistors R₁ and R₂ (where R₁ = R₂) are connected in series to an ideal battery. Which of the…

A: The total resistance= R1+R2                                      = 2R1=2R2 The total resistance is…

Q: Problem 2) Determine the output time function. y(t). from the convolution integral y(t) = Sh(t =…

A: According to Laplace transform:

Q: f(t) A t

A: In this case, the Laplace transform of the given function is to be determined.

Q: 10. Which of the following is true about microprocessors?

A: The correct option along with the explanation is provided in the following section.

Q: What is the role of the @ operator and a sensitivity list in an always statement?

A: Sensitivity List: The sensitivity list will have the list of signals for which the always statement…

Q: To access the services of the operating system, the interface is provided by the

A: The correct option along with the explanation is provided in the following section.

Q: 95. i (Amp) 9 3 t (sec).- 6 **

A: Given data, Resistance R = 10 ohm Waveform is given,

Q: Design a circuit with an op amp that provides a gain of 7.5 having a Rin resistor of 12k2. What…

A:

Q: For the circuit below, what will be the output voltage if the input is V₁ = 0.2 V? 470 ΚΩ W RF 2.4…

A: Given data, Input voltage, VI=0.2 V Circuit diagram is given,

Q: Show that the system shown in Figure (1) is equivalent to : C(s) R(s) Gp(s)Gc(s) 1+ Gp(s)Gc(s) R(s)…

A:

Q: A series RLC circuit has a resistance of 7.5 , a capacitance of 10-2 F, an inductance of 1/6 H, and…

A:

Q: The armature of a dc machine running at 1200 rpm carries 45 A in current. If the induced armature…

A: Given: N=1200 rpmIa=45AEa=130V

Q: 5 SO134 Which of the following is the expression for X(z)? 72-1 A. X(z) = + (1-72-1)² 72-1 B. X(z) =…

A:

Q: 1. A capacitor consists of two circular plates of radius a separated by a distance d (assume d…

A: Let σ be defined as the surface charge density on plates and A be defined as the surface area of…

Q: 2. Consider the signal given below x(t) = 2sin2t (a) Write down the signal Fourier series…

A: So we have to find the complex Fourier series coefficient of the given signal. Also we need to…

Q: In the circuit below, what is the value of the current I1? A O 0.52 A 0.19 A O 0.25 A O 1.25 A 25 Ω…

A:

Q: describe importance laser ablation in combination with ICP-MS in solid sample

A: LA-ICP-MS (Laser Ablation Inductively Coupled Plasma Mass Spectrometry):- It is very sensitive…

Q: Draw (a) a logic diagram using only two-input NOR gates to implement the following function: F (A,…

A: The required circuit can be designed by using the NAND and NOR gate by converting the expression…

Q: To access the services of the operating system, the interface is provided by the a) Library b)…

A: The correct option along with the explanation is provided in the following section.

Q: . Determine the z-transform and ROC

A:

Q: A single phase circuit with a given load 5 ohm resistance and capacitive reactance of 2 ohms as…

A:

Q: LT of the given function

A: In this case, the Laplace transform of the given function is to be determined.

Q: Define the unit step function and the shifted unit step function. Need

A: The unit step function and its shifted counterpart has been defined in the following section.

Q: A 120 / 180 Volts Autotransformer draws power a 120 Volts and supplies power to a 2 kW load at 180…

A: Given: The transformer voltage ratio is 120 V/180 V  Consider the power supplied to the first load…

Q: 3. What is the value of constant B₁? A. -72 B. 0 4. What is the value of I'(0)? -72 A. B. 0 B. 25…

A: Given:  R=7.5 Ω, L=16 H, C=10-2 F and E=12 VAlso, i0=0 A and q0=0 C

Q: If feedback resistor R₁ = 15k and input resistor R₁ = 5k. Then, The voltage gain of the…

A:

Q: A PNP transistor has a dc current gain of ß = 200; a relay of 4 mA connected in the collector…

A: We have an PNP transistor circuit as shown in figure    We need to calculate the base current IB…

Q: The voltage drop across the R3 lamp is? 40 60 90 30

A: Given circuit,

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.