A gas storage cylinder in an ordinary chemical laboratory measures 3.9 cm wide and 16. cm high. This is the label on it. Contents: N, gas Pressure: 7.93 atm If the cylinder is opened and the gas allowed to escape into a large empty plastic bag, what will be the final volume of nitrogen gas, including what's collected in the plastic bag and what's left over in the cylinder? Write your answer in liters. Round your answer to 2 significant digits.

A gas storage cylinder in an ordinary chemical laboratory measures 3.9 cm wide and 16. cm high. This is the label on it. Contents: N, gas Pressure: 7.93 atm If the cylinder is opened and the gas allowed to escape into a large empty plastic bag, what will be the final volume of nitrogen gas, including what's collected in the plastic bag and what's left over in the cylinder? Write your answer in liters. Round your answer to 2 significant digits.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

a. b. The normal force which the path exerts on a particle is always on: The Normal direction The Transverse direction The Tangent direction The Radial direction It is time to draw, match the axis you will draw on the free body diagram or the kinetic diagram with the force or acceleration on this specific axis: Y axis Normal axis Tangent axis Radial axis Transverse axis N [Choose] [Choose] The normal force between the surface and the motorcycle The weight of the motorcycle The frictional force between the surface and the motorcycle The transverse acceleration (a theta) The radial acceleration (ar) [Choose] [Choose ] [Choose ]
how do i get 145?
(include units with answer) A 0.11 inch diameter hole is punched in the bottom of a 2.8 inch diameter can. The can is open at the top and contains 11 oz of liquid. What is the initial velocity Format C of the liquid coming out of the hole? (include units with answer) Previous Next
FLUID MECHANICS 3
Box the final answer. Write legibly. Compute the mass of air in slugs that can be contained inside a conical tank with a base radius of 2.5 meters and a vertical height of 7.5 meters. The pressure gage is 15.75 bar and the average temperature is 35 degrees C.
1. A full gas cylinder contains nitrogen gas at 70° F and the maximum allowed pressure [2640 lb/in.2 (gauge)]. If it were left in the sun and the contents reached a temperature of 210° F, what is the resulting pressure in the cylinder?
You install a pumping well to recover the toluene. The pumping well is 6 inch diameter and the well is 50% efficient. What would be the minimum pumping rate (in US gal/min) required to complete capture the plume and what would the drawdown be after one year of pumping?
Kerosene has an API gravity of 42.5. What is the specific gravity of kerosene at 16°C? How does this compare with the value in Table 2.7? What is the energy density (MJ/L) of kerosene at 16°C? Use the data given in Table 2.7.
(Use the following figure to answer questions b, c and d) T du dy Liquid A Liquid B b. What is the type of the two liquids? c. Explain how the shear force applied to each liquid affects its viscosity. d. Which liquid has higher apparent viscosity? Explain your answer.
1. In the operation of an internal combustion engine, the combustion gases expand in volume to make the piston move. As this occurs piston. Select the most correct phrase to go into this blank from these choices: gas particles move in the same direction as the motion of the A all the В almost all of the very few of the about half of the
30 ft 10ft. 10 ft 15 ft D 15 ft 12.5 ft The cable AC develops a tension of 100 Ib. Under the equilibrium condition, answer the following questions: Determine the following: V Ib 1. Tension in cable AB. [ Select ] 2. Tension in cable AD. [ Select ] V Ib
I have the answer but I need to much sure.