A five bit digital to analog converter (DAC) has a voltage output range 0-7 V. The resolution of the converter would be Select one: O O O a. 0.2000V b. 0.5333V c. 1.28571V d. 0.22581V

Q: Cyclo Convertors:AC to AC conversion by using Thyristors draw the Circuit diagram and point out the…

A: Cyclo Convertors AC to AC conversion: The circuit diagram is given as:

Q: 6. In figure 3. If R1=100, R2=50 N, Vin=0.5V and RL=2002. Find the output voltage. 7. In figure 2.…

A:

Q: If the resolution of a digital-to-analog converter is approximately 0.4% of its full-scale range,…

A: Given: A digital to analog converter with resolution % R = 0.4 % of its full scale range

Q: A five bit digital to analog converter (DAC) has a voltage output range 0-11V. The resolution of the…

A:

Q: The "moderate voltage limiting device" used in ECG circuitry is made of O a None of these Ob 2…

A: As per guidelines given to us we can only provide the solution of first question in multiple type of…

Q: From the following trifilar circuit let Van = Vnb = 120 ∟0° Vrms, determine: a.) InN b.) The active…

A:

Q: What will be the output voltage of this opamp circuit?

A: The voltage Vb  will be :

Q: 24 Explain the advantage of using a 4 to 20 mA current loop as an input signal compared to a 0 to…

A: Explain the advantage of using a 4 to 20 mA current loop as an input signal compared to a 0 to 5-V…

Q: 11 The shown circuit represents Q1 Vs Load buck converter O boost converter O full-bridge DC-DC…

A: In the given questions we need to identify the given circuit. Buck converter circuit

Q: The upper cutoff frequency of this amplifoer is 22KHz. The output at that frequency is 6.71V p-p.…

A:

Q: What will happen to the output if the resistor R1 gets damaged and gets shorted ideal diode) D R,…

A:

Q: Question No.56 A 6-bit ladder D/A converter has a maximum output of 10 V. The output for input…

A: Given a digital to analog converter with, Total number of bit, n = 6. Maximum or full scale voltage,…

Q: Design a Buck Converter with the Following Features. Input Voltage = 50 V Output Voltage = 20 V…

A: Buck Converter:  It is a type of DC-DC converter where input voltage is being stepped down to get…

Q: Draw What is the cross over distortion in class B?

A:

Q: what are the apllications of DC-TO-DC converter

A: Dc to Dc converter also known as chopper are of three types, namely Step up chopper Step down…

Q: O Inductor Diode Voltage Surce Swilching Device Capactor This DC-to-DC converter has a duty cycle of…

A: Given data: Duty cycle = 33.3% = 0.333 Converter input = 5 V Output voltage = ? The dc-dc…

Q: R1 R3 R5 R2 R4 R6 Vo Vin Determine the output peak voltage, Vo R1=18190 ohms, R3=18190 ohms,…

A: We need to find out output voltage for given circuit

Q: A boost converter is 80% efficient, has an output voltage of 12V and a duty cycle of 75%.  What is…

A: Fig in solution shows the basic configuration of a boost converter where the switch is integrated in…

Q: If the output of a transistor amplifier is 5V rms and the input is 100mV rms, the voltage gain is (5…

A: Given a transistor amplifier with, Output rms voltage, Vout=5 V. Input rms voltage, Vin=100…

Q: The term "Bipolar" in Bipolar Junction Transistor (BJT) refers to a) Two junctions c) Two polarity…

A: BJT- (BIPOLAR JUNCTION TRANSITION) - bjt is a solid state device current to be flow two terminals…

Q: Determine the output voltage waveform of the circuit. Indicate the positive peak and negative peak…

A: The solution can be achieved as follows.

Q: 2. Draw and explain the Successive approximation type Analog to Digital Converter.

A: The successive approximation type Analog to Digital converter is shown below:  It is a type of…

Q: First quadrant operation of single phase fully controlled converter is called operation. of

A: In first quadrant operation firing angle is less than 90°.

Q: The diode voltage for a buck converter is 0.6V, the transistor voltage is 0.25V, and the input is…

A: Given: A buck converter has The diode voltage, VD=0.6 V The transistor voltage, VT=0.25 V The input…

Q: A 5 bit converter has a range 0-5 V what is the approximate resolution of the converter O 0.66 0.6 O…

A:

Q: The samples of analog signal is converted to digital signals by using which of the following…

A:

Q: Question 1. Design a Boost Converter circuit by drawing according to the Values given below. Input…

A:

Q: A D/A converter has a 14-bit binary input. The output analog voltage range is 0 to 8 V. How many…

A: No. of discrete level of voltage=2n-1No. of discrete level of voltage=214-1No. of discrete level of…

Q: C) What is a Transducer? With a neat sketch, explain the Measurement system using a piezoelectric…

A:

Q: What is the output signal voltage for a gain of 20 and input voltage of 30mV? O 600mV O 6V O 60mV O…

A:

Q: Which of the following is not true about 7905 voltage regulators? It has a minimum input voltage…

A: Not true statement  79 refer to negative output voltages

Q: This is a block diagram of a 4-bit analog to digital converter (A/D).  Assume the analog input…

A: The solution can be achieved as follows.

Q: 2

A: From the given figure, Rf​=10kΩV1​=16V (1) We have to determine the resolution for the given…

Q: Q2. Consider the following RISC-V loop: (i) (ii) (iii) (iv) (iv) (v) (vi) (vii) DONE: add x12, x11,…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: The 5 bit representation of a DAC converter for an analog value of 8 is type of display devices use…

A:

Q: The input voltage Vi of the following circuits is a triangular signal with an amplitude of 18Vpp,…

A:

Q: An n-c nmon connguratio (Rp) 61 2.2kN and its transconductance is 3mSiemens. When input voltage is…

A: Given RD = 2.2 Kohm,  gm = 3 mS Vi = 200 mV To find output voltage Vo

Q: single phase full controlled bridge converter uses     a. 4 SCRs and 2 diodes b.  4 SCRs   c.…

A: fully controlled converter means it has control over both positive and negative half cycles .  where…

Q: The collector current Ic (see the circuit below) is:

A: The following circuit diagram is given:

Q: Q#2: in the following circuit if Peak input voltage=20V and diode forward resistor is = 1092. Find •…

A:

Q: Resolution of 4-bit analog to digital converter in percent is

A: DAC and ADC are data converters. A DAC (Digital to analog converter) circuit convert digital data in…

Q: n which class of chopper, the output current is always positive, whereas the output voltage could be…

A: Consider the quadrant diagram given below:

Digital to Analog Converters

Digital to analog converters are commonly known as DAC, digital analog converter, D2A, or Digital-to-Analog converters. DACs are one of the important devices used in the electronics and electrical domain. DACs are the systems that convert a digital signal into an analog signal, whereas an analog to digital converter or ADC performs the opposite function. Digital signals are those signals that can represent the information or data as a set of discrete values. At a particular instant of time, a digital signal can only take a particular value of data. A digital signal is characterized by two unique values; zeros and ones, or true and false, represented by the Boolean domain. These are also known as binary signals or logic signals. Unlike digital signals, an analog signal is represented by continuous values, where at any time instant, the analog signal is represented by a real number.