(a) Find a conversion factor to convert from miles per hour to kilometers por hour. mi/h x km/h (b) Suppose the maximum highway speed is 70 mi/h, Use the conversion factor from part (a) to find the speed in kilometers per hour. km/h

(a) Find a conversion factor to convert from miles per hour to kilometers por hour. mi/h x km/h (b) Suppose the maximum highway speed is 70 mi/h, Use the conversion factor from part (a) to find the speed in kilometers per hour. km/h

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q6 The relationship between the velocity, u, of a construction vehicle (in km/h) and the distance, d (in metre), required to bring it to a complete stop is known to be of the form d = au² + bu + c, where a, b, and c are constants. Use the following data to determine the values of a, b, and c when: a) u 20 and d = 40 b) u = 55, and d = 206.25 c) u = 65 and d = 276.25 [Note: Use an appropriate standard engineering software such as MATLAB, CAS calculator, programmable calculator, Excel software]
Solve correctly stepwise, all subparts.
B7
Please I want answer for this question - 7 . Many Thanks
Need help with the calculations i keep getting lost in the conversions
question is below
Thermal conductivity k is a measure of the ability of a material to conduct heat. For conduction heat transfer in the x-direction through a surface normal to the x-direction, Fourier’s law of heat conduction is expressed as: Q=-kA.dT/dx where ?̇ is the rate of heat transfer and A is the area normal to the direction of heat transfer. Determine the primary dimensions of thermal conductivity (k). Look up a value of k and verify that its SI units are consistent with your result. Write a set of primary SI units for k.
Find the Velocity of arocket by using Stilling formula formula + = 150 Sec +(s) V (mile/ Go 120 180 0.0824 0.2747 0.6502 240 1.38 51 300 3.2224
kindly answer question c, d, e and f
The traffic volume data table below counts was taken on rural a highway during the morning peak hour at (8:00-9:00 am) on Monday of a week. Time periods (minute) 8:00-8:15 AM 8:30-9:00 AM Number of vehicles 385 790 The average time headway (sec) during 8:00-9:00 am 2.25 a) Find the traffic volume for the period from 8:15 to 8:30 am. b) Determine the hourly volume (HV), the maximum rate of flow within the hour, and the peak hour factor (PHF). c) Estimate the density and speed of traffic if an average spacing of 150 ft. d) Estimate the daily volume for Monday if the hourly expansion factor (HEF) is 22.05.
Parts for each product Homework 1 n produce dryer plant Can for each product castiens Then each product is assembled in its dedicated washing and dryer A machines. Difterent are manufactured by press and motor ly sechon. The the monthly capacity of different sections are: washing machine or looo dryer machine Press section: 100 - Motor section: 1600 washing machine or 7o00 drjer machine machine assembly line: goo0 machine washing druer machine assembly line: 5000 machine washing 1, profit for each unct of washing and dryer machines is 270 and 300 respectively. Formulate a linear programming problem for Find ing how many washing and dryer machines should be produced many washing to maximize total plant's profit. 2.A A Post Company need to transfer 30000 boxes with two each truck presented of olifferent trucks. Chavactenistics problem for The table below. Formulate a linear programming each truck to optimum nunber of minimIze total Cost.
As we explained in earlier chapters, the air resistance to the motion of a vehicle is something important that engineers investigate. The drag force acting on a car is determined experimentally by placing the car in a wind tunnel. The air speed inside the tunnel is changed, and the drag force acting on the car is measured. For a given car, the experimental data generally is represented by a single coefficient that is called drag coefficient. It is defined by the following relationship: F, where air resistance for a car that has a listed C, = drag coefficient (unitless) measured drag force (N) drag coefficient of 0.4 and width of 190 cm and height of 145 cm. Vary the air speed in the range of 15 m/s