a) Fig. 2 shows a rim of a tractor tyre of diameter 60 cm and width 25 cm. After inspection, the tyre was found imbalanced. It seems to the equivalent a 2 kg mass 5 cm from the outside of the tyre and 30cm from the centre of the tyre at 100°, and another one 1 kg mass at 18 cm from outside of the tyre and 10 cm from centre of the tyre at 300° angle. Find masses that should be added to make it balanced at the outside and inside tyre at the rim (30cm from the centre) B 5cm 2kg 13-30cm 18 cm Outside YU Fig. 2 10cm 1 boy Inside 18cm 300⁰ 100⁰ 10 cm С

a) Fig. 2 shows a rim of a tractor tyre of diameter 60 cm and width 25 cm. After inspection, the tyre was found imbalanced. It seems to the equivalent a 2 kg mass 5 cm from the outside of the tyre and 30cm from the centre of the tyre at 100°, and another one 1 kg mass at 18 cm from outside of the tyre and 10 cm from centre of the tyre at 300° angle. Find masses that should be added to make it balanced at the outside and inside tyre at the rim (30cm from the centre) B 5cm 2kg 13-30cm 18 cm Outside YU Fig. 2 10cm 1 boy Inside 18cm 300⁰ 100⁰ 10 cm С

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Similar questions

The two-pan balance scale of Fig. a 400-mm-long bar that fits loosely over a 20-mm-diame- ter shaft. The center of mass of the bar coincides with the center of the shaft. The scale functions by placing an item to be weighed (for example, a mini-TV) in the right pan and then placing known weights in the left pan until the scale is in equilibrium. However, because of bearing fric- tion, the system can be in equilibrium for more than a sin- gle value of weight in the left pan. If the coefficient of fric- tion between the bar and the shaft is 0.30, determine the range of weights that can be placed in the left pan to bal- ance an 80-N object placed in the right pan. consists of -200 mm 200 mm -
A professor's office door is 0.99 m wide, 2.2 m high, 4.2 cm thick; has a mass of 27 kg, and pivots on frictionless hinges. A "door closer" is attached to door and the top of the door frame. When the door is open and at rest, the door closer exerts a torque of 5.6 N*m. What is the moment of inertia of the door? If you let go of the open door, what is its angular acceleration immediately afterward?
Here are these questions if I could get help with themIf a spherical storage tank holds 40,000 gallons (120,000 liters) of water,what diameter must it have?If a cylindrical storage tank has a 40-foot (12 m) diameter circular 05::=how high must it be to hold 1 million gallons (3 million liters)?If water is moving at a rate of 3.2 ft3/sec (90,000 cc/sec), how manygallons (liters) per minute is this?If the specific gravity of gold is 19.0. what is the weight of a cubic inch(cubic centimeter) of gold? A cubic foot (cubic meter)?
(mC1)new in kg = Angular position of (mC1)new measured from x axis CCW in degree = (mC3)new in kg = Angular position of (mC3)new measured from x axis CCW in degree =
A barge pulled by a tugboat can be described as a rect- angular box that is open on the top. A certain barge is 30.2 feet wide and 12.50 feet high, with the base of each side being 116 feet long. If the barge itself weighs 6.58 x 10 pounds, what will be the draft (depth in the water) if the cargo weighs 1.12 × 10°pounds in (a) sea- water with a density of 1.025 g/mL and (b) freshwater with a density of 0.997 g/mL?
A solid cylinder (r= 4cm) goes down a ramp at a declination of 20°. The longitude of the ramp is 75 cm and 20 cm high. On average, the cylinder takes 1.25 s to go down the ramp. Without specifying the value of the mass determineWhat is the acceleration of the center of mass?What is the angular acceleration of the object?What is the moment of inertia of the object?What is the value of the radius of gyration?
(3) A cylinder with a cross section S with a frictionless piston with a mass of M is fixed at the angle 0 in a vertical direction, as shown in Fig. 1- 3. Find the pressure inside the cylinder. The atmospheric pressure is denoted as po and the acceleration of gravity is denoted as g. (a) Po + MgS cos 0 (b) (d) (e) Po - MgS sin 0 sin Po + (h) Po - MgS cos 0 Po + 2 cos 0 Po - Masin 0 S Fig. 1-3 M (c) (f) Po + MgS sin 0 Po - Ma cos 0
Plz answer I will rate !:) A right circular cylindrical tank with its circular base on the ground is full of water. The diameter of the base is 4m and the height of the tank is 4m. Set up a Riemann sum to approximate the hydro static force against the lateral wall of the tank. Then express the force as an integral and evaluate it.
(b) The planet Neptune has an equatorial diameter of 49,532 km and its mass is 1.0247 x 10 kg. If the planet is modelled as a homogeneous sphere, what is the acceleration due to gravity at its surface? (The universal gravitational constant is G = 6,67 x 10-|" N- m/kg².)
1- A right circular cylinder of 0.3 m dia and 0.6 m length with a specific weight of 7500 N/m³ is to float vertically in kerosene of specific weight of 8900 N/m³. The Volume displaced of kerosene is... (a) 0.021 m³ (b) 0.053 m³ (c) 0.042 m³ (d) 0.035m
The cylinder in Fig . 2-11 is used to raise the weight 9 in. If the bore of the cylinder is21/2 in. and the pressure is 1800 lbf/in.", how much work is accomplished?
Two spheres, one heavier and weighing12000 N and of diameter 1.2 m and the other lighter and weighing 4000 N, are tied with a rope and placed in seawater. The density of sea water is 1025 kg/m^3. It was found that the spheres floated vertically with the lighter sphere just under the water PROBLEM 0surface. Illustrate the problem before answering the following questions:a)Determine the diameter of the lighter sphere in meters.b) Determine the tension in the rope in Newtons.