A digital system multiplexes 32 voice channels based on 16-bit PCM. Each voice signal is put through a low- pass filter with a cutoff frequency of 2.3 KHz. The filtered voice signal is sampled at 9.1 KHz. In addition, two bits are added at the end of the frame for synchronization and control purposes. The output transmission rate for this system equals to: O a. 4.677 Gbps O b. 4.677 Mbps O c. 4.677 Kbps O d. 4.677 bps

A digital system multiplexes 32 voice channels based on 16-bit PCM. Each voice signal is put through a low- pass filter with a cutoff frequency of 2.3 KHz. The filtered voice signal is sampled at 9.1 KHz. In addition, two bits are added at the end of the frame for synchronization and control purposes. The output transmission rate for this system equals to: O a. 4.677 Gbps O b. 4.677 Mbps O c. 4.677 Kbps O d. 4.677 bps

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q27) Quantization noise can be reduced when the size of quantization level is decreased. a. False b. True DIGITAL COMMUNICATIONS Course.
is one of the methods used for the generation of SSB-SC signals. O Carrier shift method O Frequency shift method O Amplitude shift method O Phase shift method
Which shift keying technique is used in the following diagram? Briefly explain:
uring the execution of an IN instruction, the WR signal will Go low. Stay high. Tristate. Multiplex
Schneider LON 0.OFF MCCB MCB RCD Isolator
i need the answer quickly
Q3/ Design maximum size multiplexer by using the following (Note that all multiplexers and all decoders active low multiplexers. enable) Type of multiplexer 8-to-1 4-to-1 2-to-1 Number of multiplexers 3 3 10 Type of decoder 3-to-8 2-to-4 1-to-2 Number of decoder 1 4 6
Design a Mode 14 asynchronous forward counter circuit
What is the problem arises from removing ?carrier signal from Normal AM decrease Noise. O Increase synchronization O Decrease power. O Increase power. O Increase Noise. O
1.Which method is the only form of pulse modulation that is used in a digital transmission system? Explain. 2.What are the four most common methods of pulse modulation?
(a) Suppose that the BI/RBO input line was connected to ground on the 74LS47 BCD- to-seven segment decoder and all other input lines were connected as shown in Figure 3. Determine the effect this would have on the display. (b) Assume that the switches in Figure 3 are set to binary 1000, but the display shows a zero. What are possible causes for this error? Four DIP switches +5.0 V 1.0 ΚΩ MSB LSB w 330 Ω www 330 Ω 330 ww 330 Ω +5.0 V 7447A +5.0 V R's=330 Voc Anode a w a Lamp test ba ww b BI/RBO CO www RBI Outputs d w e ww e f w ww 8 DUBA BCD inputs GND MAN72 seven-segment display
with explanation steps, please