A cross-section of a beam is shown in Figure Q2. If the shear force in this section is V = 130 KN, determine the value and the location of the maximum shear stress in the section. In Figure Q2, a = 58 mm and the origin of the coordinate system is at centroid of the cross section. Z A AY 2a O 4a Figure Q2 B a 3a a

A cross-section of a beam is shown in Figure Q2. If the shear force in this section is V = 130 KN, determine the value and the location of the maximum shear stress in the section. In Figure Q2, a = 58 mm and the origin of the coordinate system is at centroid of the cross section. Z A AY 2a O 4a Figure Q2 B a 3a a

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Determine the principal stresses in the cantilevered beam at points A and B.
1) Determine the axial stress in members EF and KL (area 10in?) using method of sections. 1OK 20K. Eレ F 30k It 4' 4' 4' 4' 4' 4'
The T-bracket is formed by welding together two cylindrical rods AB and CD. If the allowable shear stress is 80 MPa, what is the smallest allowable diameter of rod AB? Neglect the stress caused by the transverse shear force
Draw mohr circle and determine maximum and minimum principal stress
2. The state of plane stress at a point is shown on the element in (a). Determine the maximum in-plane shear stress at this point. 90 MPa 60 MPa 20 MPa (a)
The screw of the clamp exerts a compressive force of 250 lb on the wood blocks. The cross section is rectangular, 0.75 in. by 0.50 in 4 in. 0.75 in. a Part A Determine the maximum normal stress along section a- a. Express your answer to three significant figures and include appropriate units. HA ? Omax = 52.8 ksi
Use Mohr’s circle to determine the normal stress and shear stress acting on the inclined plane AB.
Determine the average normal stress on the cross section. Sketch the normal stress distribution over the cross section.
A lever is attached to a shaft with a square shear key as shown. If the force applied to the lever is P = 395 N, determine the shear force applied to the shear key. 42 mm. ↓ Shear key O 10.90 KN O 18.31 KN O 9.70 KN O 14.25 KN O 13.17 kN 700 mm C Shear key detail
Solve Prob. using the maximum shear stress theory.