A core cutter 15 cm in height, 10 cm in diameter, and having a mass of 1078 gm when empty is used to determine the insitu density of embankment soil. The mass of the core cutter full of soil is found to be 2968 gm. If the water content of the soil is 7% the insitu dry unit weight is kg/m3

A core cutter 15 cm in height, 10 cm in diameter, and having a mass of 1078 gm when empty is used to determine the insitu density of embankment soil. The mass of the core cutter full of soil is found to be 2968 gm. If the water content of the soil is 7% the insitu dry unit weight is kg/m3

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter5: Soil Compaction

Section: Chapter Questions

Problem 5.2P

See similar textbooks

Similar questions

For a given soil, show that
i need clear ans by hand and solve very very fast in 20 min and thank you | ᴅʏʙᴀʟᴀ ?✨؛
For a soil specimen, given the following: % passing sieve #4-92 %, sieve #10 -81%, sieve # 40-78%, LL-48%, PL-16%, GI-18.2 classify the soil by AASHTO classification system. GI = (F200-35)[0.2 + 0.005 (LL - 40)] +0.01 (F20015)(PI – 10)
pls help
Afalling-head permeability test is performed on a fine-grained soil. The soil sample has a length of 120 mm and a cross-sectional area of 600 mm2. The water in the standpipe flowing into the soil is 0.60 m above the top of the sample at the start of the test. It falls 50 mm in 30 minutes. The standpipe has a cross-sectional area of 200 mm2. (a) Make a sketch of the described conditions. (b) What is the coefficient of permeability in millimeters per second? (c) What is the coefficient of permeability in feet per minute? (d) On the basis of the calculated value for khyd, what is the probable soil type?
(b) The representative soil specimen collected from the embankment field has a bulk density of 17.61 kN/m³ and a dry density of 15.89 kN/m³, and the specific gravity of the soil particles is 2.67. During field construction, the soil embankment will be exposed to moisture. (i) Calculate the degree of saturation of the soil. (ii) If the soil embankment specimens have 80% degree of saturation, estimate the weight of water in kN need to be added per cubic meter of the soil
A constant head permeability test is performed on soil that is 4 cm2, and 2.5cm long. The head difference applied during the test is 20 cm and 7 cm3 is collected over a time of 100 sec. Provide step by step solution. What is the permeability based on these test conditions and results.
Problem The saturated soil specimen shown below has a permeability of 0.005 cm/sec, a porosity of 38%, and a cross-sectional area of 22 cm². Two standpipes are placed at points A and B as shown below. The specimen has reached a steady state condition after flushing it with water for 1 hr. Datum ttttt h₁ = 100 cm 50 cm L = 50 cm B 40 cm h₂ = 80 cm Determine: 1. 2. Elevation head (in cm) at points A and B. Pore water pressure (in kPa) at points A and B. 3. Discharge velocity (in cm/sec) through the sample. 4. 5. What is the quantity of flow through the sample in cm³/day? What is the magnitude of the seepage velocity (in cm/sec)? OUT
solution of subpart e,f of question?
Urgent need the solution. Kindly answer everthing. Please skip if you're not going to answer them. Thank you.
A cylindrical soil sample prepared for laboratory testing has a diameter of 71 mm, aheight of 142 mm, and weighs 10.675 x10^-3 kN. If the degree of saturation is 93%and the specific gravity of soil solids is 2.71, determine the void ratio,and water content. Please this asap. For upvote. Thanks
solve completely from A to E. Thank you FINAL ANSWER: A. ? (USE EXCEL) B. ? C. e = 0.488, and S = 76.9%, D. γt = 20.27 kN/m3, E. w = 10.7% to 16.0%