A conductor carries a current of 70 A at right- angles to a magnetic field having a flux density of 1.5 T. If the length of the conductor in the field is 200 mm calculate the force acting on the conductor. What is the force when the conductor and field are at an angle of 45°?

A conductor carries a current of 70 A at right- angles to a magnetic field having a flux density of 1.5 T. If the length of the conductor in the field is 200 mm calculate the force acting on the conductor. What is the force when the conductor and field are at an angle of 45°?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: C) Briefly explain the three (3) classification of ferromagnetic materials based on the effect by…

Q: What is the fundamental cause of magnetic fields?

A: The volume where any change in energy is present there we can say that magnetic fields are present.…

Q: Whenever lines of magnetic force cut across a conductor: Select one: a. a voltage will be induced in…

A: The question is asking about the phenomenon that occurs when lines of magnetic force cut across a…

Q: Two VERY LONG wires are placed along parallel lines as shown below in the picture. The wire ON THE…

Q: The magnetic force ( ) on a curved current-carrying wire in a uniform magnetic field is equal to…

A: According to the question we have to discuss The magnetic force on a curved current-carrying wire in…

Q: Magnets are surrounded with lines of force emitted from the north pole that are called flux. A. True…

A: In the given questions we need to discuss about the basic of magnet.

Q: A long solenoid is wound with1000 turns of thin insulated wire over a 15cm length. The core of the…

Q: When current flows in a conductor, lines of magnetic force: Select one: circle the conductor. try…

A: The question is asking about the behavior of magnetic field lines when current flows through a…

Q: 2. A rectangular frame of sides 2b x c has current I and mass m. It is a distance b below a very…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: What is the primary characteristic of an eddy current in a conductor exposed to a changing magnetic…

A: Eddy currents are circulating currents induced in the conductor when it is exposed to a changing…

Q: In the figure below, show in which direction the force acting on the wire will be if the current + x…

A: Given, current + x is in the direction of the magnetic field + y.

Q: When a moving conductor is placed across the magnetic field, voltage is induced. Explain further…

Q: Consider an infinite straight wire that carries a current /₁. There is a rectangular loop, whose…

A: Given, The figure,

Q: A coil of 100 turns and area 50 square centimeter is placed in a magnetic field B = 2 T. The normal…

A: Number of turns in the coil N = 100.Cross sectional area Magnetic field B = 2 T.Angle between normal…

Q: Magnetic flux density is a vector, and the direction of current will be an important determinant of…

A: Option c is incorrect. Because there is not any such threshold exist for electric current to cancel…

Q: What is a magnetic field? a) it is the space araund a magnet, or the space in whic magnetic forces…

A: A magnetic field is a vector field that describes the magnetic influence on moving electric charges,…

Q: Choose the parameter which is developed in a generator, when a conductor cuts the magnetic flux.…

Q: d N2 N1 Figure 3 ] Figure 3 shows a magnetic device with two airgaps and two coils. The depth of the…

A: A magnetic core of a magnetic device with tow air gaps is given in the question. The permeability of…

Q: Two circular loops of 10 cm in radius are 0.5 mm away from one another as shown in the figure below.…

A: Given values are - r1=r2=10cm=0.1mDistancex=0.5mm=0.5×10-3mI1=150AI2=120A

Q: Two long, parallel wires are 6 m apart. T nts of 10 A each, in opposite directions. a third long…

A: The magnetic field created at a point due to a current carrying conductor is given as: B=μ0I2πR…

Q: 4.4 A cast steel ring having a radius of 150 mm is uniformly wound with 3000 turns of wire. When a…

Q: Which one or ones of the following statements about an ideal solenoid carrying a uniform current are…

Q: MH If We apply magnetism for ferromagnetic material, what will happen? What is Eddy current?

A: In the given questions we need to discuss about ferromagnetic material and eddy current.

Q: An electromotive force (EMF) induced in a conductor moving inside a magnetic field is given by

A: Given Emf induced in a conductor moving inside magnetic field

Q: In the following figure a wire loop with a current I, that is near a long straight current carrying…

A: By using right hand thumb rule we can find the direction of magnetic field . Put the thumb in the…

Q: The relationship law between magnetic flux density, magnetic field strength and magnetization is…

A: Basic problem on electromagnetic field theory.. Look below for the solution..

Q: When a current carrying wire is located in a uniform magnetic field with the direction of the…

Q: Explain (1) the presence of magnetic lines of force, and (2) motion of conductors cutting the flux,…

A: The magnetic lines of force emerge from the north pole and terminate at the south pole. These are…

Q: In the magnetic circuit shown below, what is the flux density produced if the relative permeability…

A: A magnetic circuit- Number of turns N=100, Current I = 5 A, Relative permeability μr=1000,

Q: Determine the induced voltage in a conductor 60 cm long moving in the magnetic field at a velocity…

A: Given Data: B= 0.18 Weber/meter, l= 60 cm or 0.6m, V= 8000ft/min = 4.064 m/s, and θ = 60°. We need…

Concept explainers

Type of Magnetic Material

Every material has a unique composition that defines its magnetic behavior. Some materials get attracted towards a magnet and are called magnetic materials. Based on the magnetic properties held by each material, they are classified into different types.

Question

A conductor carries a current of 70 A at right-
angles to a magnetic field having a flux density
of 1.5 T. If the length of the conductor in the
field is 200 mm calculate the force acting on
the conductor. What is the force when the
conductor and field are at an angle of 45°?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A conductor passes 50 times per across the face of the pole of a field magnet having a flux density of 15000 lines per sq in the dimensions of the pole face are 20x20in. Determine the (a). total flux, (b) lines cut per second (c) voltage induced (average).
Can someone explain this problem step by step? please
Find the magnetic force when a charge 3.5C with flux density of 4 units is having a velocity of 2m/s. Select one: O a. 7 O b. 28 O c. 32 O d. 14
These are questions about magnetic properties of a material: 1. How are carrier concentration and mobility calculated measured for materials?2. What is the Gouy’s method to measure magnetic susceptibility?3. What are the limitations in the electrical and magnetic measurements in materials?
2. To induce a voltage in a loop of wire, what must be present? A magnetic force, a ladder, and a wire loop O a power source, a ladder, and relative motion a conducting loop, a power source, and curren a conducting loop, a magnetic field, and relativ motion
electromagnetic theory What is the unit of magnetic flux density? a) Wb / m2 b) V / m c) Wb d) F / m
Shown below, a wire carrying a current of 1.25 A. The wire is present in a magnetic field of flux density 1.2 T, directed to the right. If the length of the wire is 65 cm, find the direction of the induced force on the wire. B B Select one: O a. O b. None O c. O d. Oe. To the right Into the Page To the left Out of the Page I
Given a magnetic circuit with a current of 820 mA flowing through 415 turns of wire on a core having a reluctance of 2.0 MAt/Wb. Determine the magnetomotive force of the circuit.
Two parallel straight wires are separated by a distance of 0.12 m and carry currents of I1 = 3.0 A and I2= 1.4 A. Find the magnitude and direction of the force that the magnetic field of wire 2 applies to a 1.2-m length of wire 1 when the currents are in opposite directions.